Bedienungsanleitung Electrolux HT600

Inhaltszusammenfassung zur Seite Nr. 1

HT42/420 HT45/450
HT51/510 HT60/600
For all customer enquiries or for replacement parts, contact:-
☎ ☎ 01325 300303
www.flymo.com
eop.customer.services@electrolux.co.uk
IMPORTANT INFORMATION
Read before use
& retain for future reference

Inhaltszusammenfassung zur Seite Nr. 2

1 Carton Contents Switch levers instruction manual Handguard blade cover/storage holder IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new product. IF ANY PARTS ARE MISSING CONTACT:- Electrolux Outdoor Products Customer Service Department direct Telephone : 01325 300303 Fax : 01325 318193 Safety If not used properly this Hedgetrimmer can be dangerous! This Hedgetrimmer can cause serious injury to the operator and others, the warnings and safety instructio

Inhaltszusammenfassung zur Seite Nr. 3

2 General Preparation 1. Never allow children or people unfamiliar 1. Always wear suitable clothing, gloves, and with these instructions to use the stout shoes. The use of safety glasses is rec- Hedgetrimmer. Local regulations may ommended. Do not wear loose clothing or restrict the age of the operator. jewellery which can be caught in moving parts. 2. Only use the Hedgetrimmer in the manner 2. Thoroughly inspect the area where the and for the functions described in these Hedgetrimmer is to b

Inhaltszusammenfassung zur Seite Nr. 4

3 CABLES 3. IMPORTANT! IMPORTANT 2 • Use only 1.00mm size cable up to 40 metres E length maximum. Maximum rating : L RED 2 1.00mm size cable, 10 amps 250 volts AC. OR • YOUR HEDGETRIMMER IS SUPPLIED BROWN F WITH CABLE WIRED DIRECTLY INTO THE U BLACK S PRODUCT. E OR N 1. Mains Cables and Extension Cables are avail- BLUE able from your local Electrolux Outdoor Products Approved Service Centre. 2. Do not wire an extension cable directly to your product yourself. Please contact your loca

Inhaltszusammenfassung zur Seite Nr. 5

4 Starting and Stopping Before starting your Hedgetrimmer. B C 1. Form a loop in mains cable and push the loop through the hole in the handle as illustrated in Fig. B. 2. To secure, position the loop over the hook and pull back as illustrated in Fig. C. 3. Connect to mains and switch on 4. Remove blade cover/storage holder as illustrated in Fig. D. D To start your Hedgetrimmer 1. There are two switch levers fitted to your Hedgetrimmer. 2. Both switch levers need to be held in the operating posi

Inhaltszusammenfassung zur Seite Nr. 6

5 Caring for your Hedgetrimmer J Cleaning (J) 1. Using a soft brush - remove debris from all air intakes and cutting blade. 2. Wipe over surface of your hedgetrimmer with a dry cloth. • IMPORTANT Never use water for cleaning your hed- getrimmer. Do not clean with chemicals, including petrol, or solvents - some can destroy critical plastic parts. K Lubricating the Cutting Blade For easier operation and longer life, lubricate the cutter blades before and after use. Apply the oil so that it runs

Inhaltszusammenfassung zur Seite Nr. 7

6 Fault Finding Hints Fails to Operate Fails to stop when one switch lever is released. 1. Is the Power Turned On? Immediately disconnect from the mains 2. Check the fuse in the plug, if blown replace. electricity supply and consult your local 3. Fuse continues to blow? approved Service Centre. Immediately disconnect from the mains Poor cut quality electricity supply and consult your local 1. Ensure the product is being used correctly approved Service Centre. (see How to Use) Cutting blade stops

Inhaltszusammenfassung zur Seite Nr. 8

Service Recommendations 1. We strongly recommend that your product take your complete machine including cable is serviced at least every twelve months, and any extension cables used. more often in a professional application. A network of specialist dealers can be found in 2. Always use genuine Electrolux Spare Parts. your local Yellow Pages. To obtain service on 3. Prepacked spares are available from most your product simply telephone or visit your local Electrolux Outdoor Products stockists. S