Inhaltszusammenfassung zur Seite Nr. 1
Operating instructions
TV
Connect 42
Connect 37
Connect 32
233–33319.020
Inhaltszusammenfassung zur Seite Nr. 2
Contents Electronic Programme Guide ................................................................. 30 Remote control – TV functions ................................................................ 3 Electronic Programme Guide – EPG ...............................................................30 Control unit front side of the device ....................................................... 4 Configuring EPG .......................................................................................
Inhaltszusammenfassung zur Seite Nr. 3
Remote control – TV functions Switch on / (page 20) ............................................................. Sound off/on switch off to standby mode .....................................(page 12) (page 52) .................... LED display for current operating mode (1 Switch over to radio mode ..............................(page 12, 36) (page 11, 52) ...................................... Switch over to TV mode (page 52) ................................ Switch over to operate recorder Swit
Inhaltszusammenfassung zur Seite Nr. 4
Control unit front side of the device Display (3 Connectivity Button M: Call the menu Display: in the menu: up/down The mains switch is located on = Standby the bottom of the set in the middle = Operation = Operation without on-screen display On/Off button: (Radio, EPG data capture or timer recording) Switch on from the standby mode Switch off to the standby mode Button +: Station up in the menu: to the right Button – : DR+ Station down in the menu: to the left (2 Dis
Inhaltszusammenfassung zur Seite Nr. 5
Connections r rear side of the device ear side of the device – Connect 32 – – Connect Connect 32 32 Factory settings: AV1: DVD player AV2: DVD recorder Common Interface You can change this during the (CI-Slot) initial installation (page 12) or USB connection 1 in the connection wizard (page (USB stick/card reader) 37). Before you connect other devices Headphones connection or make any changes, please start the connection wizard (page 37) S-VHS connection (AVS) and the sound components wi
Inhaltszusammenfassung zur Seite Nr. 6
Connections rear side of the device – Connect 37 / Connect 42 Factory settings: (2 AV1: DVD player Connection for additional antenna AV2: DVD recorder Common Interface You can change this during the (CI-Slot) initial installation (page 12) or USB connection 1 in the connection wizard (page (USB stick/card reader) 37). Headphones Before you connect other devic- connection es or make any changes, please start the connection wizard S-VHS connection (AVS) (page 37) and the sound compo- (e.g.
Inhaltszusammenfassung zur Seite Nr. 7
Welcome Thank you! About this operating manual Loewe sets high standards in technology, design and user friendliness. This For many questions concerning the technology you will find an answer applies equally for TV, video and accessories. in the index of your TV set. If your question concerns TV set operation, you can access a function directly from the index of the Tv set. Owing to Your new TV set is equipped for the TV standard "HDTV" this possibility, this operating manual only explains t
Inhaltszusammenfassung zur Seite Nr. 8
Welcome Assist+ Operating convenience with wizards You can select the most important operating modes directly with the This TV set offers user prompting with wizards that take you through the Assist+ menu (ASSIST button). Selectable modes are: TV, Radio digital, settings step-by-step. Teletext, PhotoViewer, Index and when equipped with Digital Recorder or You can return to the previous step or exit the wizard at any time. Network Mediaplayer also Digital Recorder archive or MediaNetwork (see
Inhaltszusammenfassung zur Seite Nr. 9
For your safety For your own safety and to prevent unnecessary damage to your device, Power supply read and comply with the following safety instructions: The wrong voltage can damage the set. This equipment must only be connected to a mains power supply which has the same voltage and Proper use and environmental conditions frequency as that specified on the rating plate; use the power cable This TV set is intended exclusively for the reception and reproduction of provided. The mains plug of
Inhaltszusammenfassung zur Seite Nr. 10
For your safety Environmental protection Repairs and accessories Energy consumption Your TV set is equipped with an eco-standby power supply. In the standby Never remove the back of the TV set yourself. Only have your TV device mode, the power consumption drops to low power (see technical data on repaired or serviced by authorized television technicians. page 57). If you want to save even more energy then switch the device Only use original accessories such as Loewe stands if possible (see A
Inhaltszusammenfassung zur Seite Nr. 11
AAA LR03 Initial installation Installing the TV set Connecting the TV set Install as manually rotatable table unit with the Table Stand included. Connecting to the mains See accessories (page 58) for other installation options. Connect the TV set to a 220-240V power outlet: First plug the small plug of the power cable into the power connection on the rear of the TV, then plug the Preparing the remote control unit large power plug into a mains power outlet. Inserting or replacing batteries Co
Inhaltszusammenfassung zur Seite Nr. 12
Initial installation Turning the set on/off First installation wizard Switching the TV set to standby mode Initial installation after switching on for the first time This wizard starts automatically after the set is switched on for the first Actuate the mains switch on the bottom of the set. time, however it can also be called later manually in the TV index, see The display in the control panel on the front of the set Repeat initial installation on page 16. will be illuminated red, the set is
Inhaltszusammenfassung zur Seite Nr. 13
Initial installation Explanations of the setting possibilities, including the upgradeable LNC Normally, you do not need to change the values for high frequencies and low band, unless the LNC (LNB) of your satellite satellite reception: Low Band / system uses a different oscillator frequency (important Location of Select the country for country-specific pre-settings. High Band for the frequency display). TV set If UK or IRL is selected for the location of TV set, it is pos- After you have made
Inhaltszusammenfassung zur Seite Nr. 14
Initial installation Digital Link If you have logged in and connected a recorder in the Positioning/aligning the DVB-T antenna Plus connection wizard, the Digital Link Plus transmission If you receive one or more DVB-T stations with picture or sound interfer- starts when the sound component wizard closes. If a ence, you should change the position and alignment of the antenna. Ask Digital Link Plus compatible recorder is connected, the your dealer to tell you which channels are used to broad
Inhaltszusammenfassung zur Seite Nr. 15
Operating convenience General information on menu operation The info display Menus for the individual operating modes (TV, Radio, PIP, EPG, Teletext, The info display shows a content-based info text for each menu item at PhotoViewer, MusicBox and Digital Recorder, if installed) are called with the top edge of the screen to aid you in making the settings. In conjunc- the MENU button. Other menus can be opened with other buttons on tion with the index it makes a convenient control system. the rem
Inhaltszusammenfassung zur Seite Nr. 16
Operating convenience The index in the TV set The Assist+ menu You can start all wizards and many operating functions directly from The most important additional functions of the TV set can be called this point. The complete function scope of the TV set can thus be easily directly by the Assist+ menu. understood. Call Assist+ Alphabetic sorting is preceded by the items Language, Integrated features and Repeat initial installation. Call Assist+ menu. Call index Select additional functions. O
Inhaltszusammenfassung zur Seite Nr. 17
Operating convenience TV menu – Overview diagram TV menu Picture Sound Connections Settings (9 (1 Picture adjustment Sound via New devices/modifications Stations (1 (1 Search wizard Contrast Sound effects Sound components Manual adjustment (1 Colour intensity Sound adjustment Antenna DVB Change stations Colour temperature Headphone volume Digital Link Plus Select/change favourites Brightness Loudness Miscellaneous Parental lock Manual adjustment of AV standard Sharpness more... Timer funct
Inhaltszusammenfassung zur Seite Nr. 18
Daily operation With the station list Select station In normal TV mode, without other displays, no favour- With the keys P+ and P - on the remote control ites selected: P+/P– station up/down. OK call Station list. The station display with sound identification is displayed briefly. Sorting Station list COMP. IN 5 hr-fernsehen numerically If favourites are selected, the station in the favourites list HDMI1/DVI 6 Phoenix HDMI2/DVI 7 BR-alpha is switched ove
Inhaltszusammenfassung zur Seite Nr. 19
Daily operation With the favourites lists Explanation of the icons following station names: Digital DVB-T station (terrestrial via antenna) You can save and call your favorite stations in 6 favourites lists (e.g. for Digital DVB-C station (via cable) multiple users). Each favourites list can contain up to 99 stations. After initial installation, 10 stations from the station list are already stored in Digital DVB-S station (via satellite) the first list. Change the favourites list to
Inhaltszusammenfassung zur Seite Nr. 20
Daily operation Explanations of the sound settings: Adjusting the sound Sound via Playback over the TV speakers, active speakers, Loewe Auro, Switching sound on/off Loewe Sound Projector or an external hi-fi amplifier. The selection active speakers, hi-fi/AV amplifier or Sound Sound off; Projector is only possible if these have been logged in in Sound on: Press button again or set volume V+. the audio component wizard. The Auro selection is only possible if a Loewe DVD Preceiver Auro is co
