Bedienungsanleitung Panasonic KX-TG6500B

Inhaltszusammenfassung zur Seite Nr. 1

"Telecommunication Products to solve Telecommunication Problems"

Audio Cord
CK-1P3
Promotion-On-Hold
Adapter
(For Panasonic
Power Cube
KX-TG6500B and KX-TG6502B)
Introduction
Thank you for purchasing the
Sensor Cable
Skutch CK-1P3 Promotion-On-Hold
Adapter for the Panasonic KX-
TG6500B & KX-TG6502 two line
Sensor Board
cordless phone system. The CK-1P3
is a true plug and play device. The
unit does not require any "Learning" to operate. When a call is placed ON HOLD from

Inhaltszusammenfassung zur Seite Nr. 2

3- Connect the audio cord from your audio source, to the AUDIO IN jack on the back of the CK-1 box. For DIGITAL units use the cable that comes with the digital player. Attach cable to Sensor Board Fig. 2 Align Buttons over buttons on phone 4- Connect a MOD cord from Telephone Wall Jack 1&2 to [1&2 Line on CK-1]. 5- Locate the CK-1P3 "SENSOR BOARD", peel off the protector paper from the bottom of the sensor board, and carefully place it OVER the LINE buttons on the Panasonic base set as

Inhaltszusammenfassung zur Seite Nr. 3

Testing the System: 1- Pickup line 1 on your telephone. The No."1" LED on the CK-1P3 Sensor Board should light up. 2- Repeat this test for line 2. If both lines light up when picked up, the CK-1 is working properly. If either light does not light up, then a) Make sure that the CK-1P3 and Phone is connected to power. b) Make sure that the SENSOR BOARD is aligned properly. Lights on CK-1 Box. When you place a line on HOLD, the corresponding LED on the rear of the CK-1P3 box

Inhaltszusammenfassung zur Seite Nr. 4

ACTA Statement This equipment complies with Part 68 of FCC rules and the requirements adopted by ACTA. On the bottom side of this equipment is a label that contains, among other information, a product identifier in the format US: AAAEQ##TXXXX. If requested, this number must be provided to the telephone company. A plug and jack used to connect this equipment to the premises wiring and telephone network must comply with the applicable FCC Part 68 rules and requirements adopted by the