Inhaltszusammenfassung zur Seite Nr. 1
®
MPT9008PZ/CZ
Coaxitron Switcher/Controller
Installation/Operation Manual
C558M (3/96)
Pelco • 3500 Pelco Way, Clovis, CA 93612-5699 • USA • www.pelco.com
(800) 289-9100 or (1-559) 292-1981 • FAX (800) 289-9150 or (1-559) 292-3827
International Customers: Tel (1-559) 292-1981 or FAX (1-559) 348-1120
Inhaltszusammenfassung zur Seite Nr. 2
TABLE OF CONTENTS Section Page 1.0 WARNINGS ...................................................................................................................................... 1 2.0 SCOPE ............................................................................................................................................. 2 3.0 DESCRIPTION ................................................................................................................................. 2 4.0 IN
Inhaltszusammenfassung zur Seite Nr. 3
LIST OF ILLUSTRATIONS Figure Page 1 MPT9008CZ–Front View ................................................................................................................... 2 2 MPT9008CZ–Rear View .................................................................................................................... 3 3 MPT9008PZ/CZ–Configuring for Loop-Through Operation............................................................... 4 4 MPT9008PZ/CZ–Homing/Terminating Config
Inhaltszusammenfassung zur Seite Nr. 4
(This page intentionally left blank.) iv Pelco Manual C558M (3/96)
Inhaltszusammenfassung zur Seite Nr. 5
INSTALLATION/OPERATION MANUAL MPT9008PZ/CZ COAXITRON SWITCHER/CONTROLLER 1.0 WARNINGS Prior to installation and use of this product, the following 4. After replacement/repair of this unit’s electrical WARNINGS should be observed. components, conduct a resistance measurement between line and exposed parts to verify the exposed 1. Installation and servicing should only be done by parts have not been connected to line circuitry. Qualified Service Personnel and conform to all Local codes. 2. Unless
Inhaltszusammenfassung zur Seite Nr. 6
2.0 SCOPE CAMERA/LENS FUNCTIONS 9. Iris Open 11. Camera Power On/Off The information contained within this manual covers 10. Iris Close 12. Auto/Manual Scan the installation and operation of the MPT9008PZ/CZ Coaxitron Switcher/Controller. AUXILIARY FUNCTIONS Please thoroughly familiarize yourself with the infor- 13. AUX 1 (Manual Iris) 15. AUX 3 mation in this manual prior to installation and operation. 14. AUX 2 (Auto Iris) 16. AUX 4 Functions 1 through 10, 15 and 16 are momentary; that 3.0 D
Inhaltszusammenfassung zur Seite Nr. 7
The MPT9008PZ/CZ is shipped with terminated BNC 4.2 NONTERMINATING LOOP-THROUGH inputs; however, the user can configure the unit for CONFIGURATION loop-through operation. See Section 4.2 and Figure 3. This makes it possible to loop signals through the To configure the MPT9008PZ/CZ for loop-through MPT9008PZ/CZ switcher/controller to an additional operation reference Figure 3 and perform the following switcher/controller and monitor at a remote location steps: where the signal is terminat
Inhaltszusammenfassung zur Seite Nr. 8
Figure 3. MPT9008PZ/CZ–Configuring for Loop-Through Operation Figure 4. MPT9008PZ/CZ–Homing/Terminating Configuration 4 Pelco Manual C558M (3/96)
Inhaltszusammenfassung zur Seite Nr. 9
Figure 5. MPT9008PZ/CZ–Homing/Looping Configuration 5.0 OPERATION 5.1.1 Controls In general, all operating controls on the transmitter are Power ON/OFF Rocker switch self explanatory. With the exception of the ON/OFF Pan/Tilt 8-position joystick power switch and the 8-position joystick, all controls Zoom Paddle switch Tele/Wide are center-off, spring return paddle switches (momen- Focus Paddle switch Near/Far tary on-off-on). Iris Paddle switch Open/Close Aux 1,2 Paddle switch Auto/Manual 5.
Inhaltszusammenfassung zur Seite Nr. 10
6.0 MODELS Operating Distance: Cable distances are approximate MPT9008CZ Coaxitron Switcher/Controller according to cable type used. 75 capable of handling and/or ohm coax required. controlling 8 video inputs, one at a time. 120 VAC input. Cable Distance MPT9008CZ/220 Same as MPT9008CZ except Type Distance Using EA2000 230 VAC input. RG59U 750 ft 9229 m) 3,000 ft (914.4 m) MPT9008PZ Same as MPT9008CZ except RG6 1,500 ft (457 m) 4,500 ft (1,371.6 m) rack-mount. RG11 1,800 ft (549 m) 6,000 ft (1
Inhaltszusammenfassung zur Seite Nr. 11
8.0 WARRANTY AND RETURN INFORMATION WARRANTY RETURNS Pelco will repair or replace, without charge, any merchandise proved In order to expedite parts returned to the factory for repair or credit, please defective in material or workmanship for a period of one year after the date call the factory at (800) 289-9100 or (559) 292-1981 to obtain an of shipment. authorization number (CA number if returned for credit, and RA number if returned for repair). Exceptions to this warranty are as note
Inhaltszusammenfassung zur Seite Nr. 12
® Pelco 3500 Pelco Way, Clovis, CA 93612-5699 (559) 292-1981 • (800) 289-9100 FAX (800) 289-9150 or (559) 292-3827 (Product specifications subject to change without notice.) C558M 8 Pelco Manual C558M (3/96)
