Bedienungsanleitung Extron electronic sVSS 100

Inhaltszusammenfassung zur Seite Nr. 1

FCC Class A Notice
Note: This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is operated
User’s Guide
in a commercial environment. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference t

Inhaltszusammenfassung zur Seite Nr. 2

Installation The Extron VSS 100 composite video sync separator extracts the sync 1 2 signal from an RGsB, component video, S-video, or composite video input. The sync separator outputs the composite sync signal, at TTL CV-INPUT LOOP- levels, on a separate signal line. The VSS 100 loops the input video THRU through and outputs it unchanged. With the VSS 100, systems that use video formats with embedded sync in the video stream can still take advantage of features that depend on a VSS 100 separa

Inhaltszusammenfassung zur Seite Nr. 3

Indicator and Operation Specifications, cont’d Standards ...................................... NTSC 3.58, NTSC 4.43, PAL, SECAM Indicator and Operation Input level ..................................... 0.3V p-p 5 Power LED — This front panel LED (figure 3) lights to indicate Output level .................................. 5.0V p-p that the VSS 100 is receiving power. Input impedance .......................... 75 ohms 5 Output impedance ....................... 75 ohms Polarity ..................