Inhaltszusammenfassung zur Seite Nr. 1
.
Cisco SFS 7024 Hardware Installation Guide
Corporate Headquarters
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
http://www.cisco.com
Tel: 408 526-4000
800 553-NETS (6387)
Fax: 408 526-4100
Text Part Number: OL-8794-02
Inhaltszusammenfassung zur Seite Nr. 2
THE SPECIFICATIONS AND INFORMATION REGARDING THE PRODUCTS IN THIS MANUAL ARE SUBJECT TO CHANGE WITHOUT NOTICE. ALL STATEMENTS, INFORMATION, AND RECOMMENDATIONS IN THIS MANUAL ARE BELIEVED TO BE ACCURATE BUT ARE PRESENTED WITHOUT WARRANTY OF ANY KIND, EXPRESS OR IMPLIED. USERS MUST TAKE FULL RESPONSIBILITY FOR THEIR APPLICATION OF ANY PRODUCTS. THE SOFTWARE LICENSE AND LIMITED WARRANTY FOR THE ACCOMPANYING PRODUCT ARE SET FORTH IN THE INFORMATION PACKET THAT SHIPPED WITH THE PRODUCT AND ARE IN
Inhaltszusammenfassung zur Seite Nr. 3
Contents New and Changed Information vii Preface ix Audience ix Organization ix Conventions x Related Documentation x Obtaining Documentation x Cisco.com x Ordering Documentation xi Documentation Feedback xi Obtaining Technical Assistance xi Cisco Technical Support Website xi Submitting a Service Request xii Definitions of Service Request Severity xii Obtaining Additional Publications and Information xiii Product Overview 1-1 SFS 70
Inhaltszusammenfassung zur Seite Nr. 4
Contents Installation 2-7 Planning the Installation 2-8 Environmental Requirements 2-8 Rack Specifications and Recommendations 2-9 Installing and Routing Cable 2-9 Power Requirements 2-10 Installation Tasks Checklist 2-11 Safety Information 2-11 Tools and Equipment Required 2-13 Check the Installation Site 2-14 Unpack the Equipment 2-14 Installation Tasks 2-15 Mounting Kit 2-15 Mark the Rack 2-15 Install the Rails in the Rack 2-15 Rack-
Inhaltszusammenfassung zur Seite Nr. 5
Contents Home Page 3-34 ? (Help) Button 3-34 Support Button 3-34 Displaying the Leaf and Spine Module Views 3-35 Leaf Module View 3-35 Spine Module View 3-36 Leaf and Spine Module Component Details Area 3-37 Leaf and Spine Details Header 3-37 Leaf and Spine Information Area 3-37 Displaying the Chassis View 3-38 Chassis View Component Details Area 3-39 Chassis Details Header 3-39 Rebooting Components from Chassis Viewer 3-39 Chassis View Compone
Inhaltszusammenfassung zur Seite Nr. 6
Contents Configuring the Switch Default Gateway IP Address 3-68 Spine View Menu 3-70 Logging 3-70 Purging the Log 3-71 Select Boot Image 3-72 License Keys; Key Administration 3-72 Adding a New License Key 3-73 Deleting a License Key 3-73 APPENDIX A Technical Specifications A-75 APPENDIX B Command Line Interface B-77 Overview B-77 Commands and Functional Groups B-78 Online Help B-79 Keyboard Shortcuts B-79 Accessing the CLI B-79 Groups a
Inhaltszusammenfassung zur Seite Nr. 7
Contents Problem C-85 Fix C-85 Fan C-86 Problem C-86 Fix C-86 OOB Ethernet RJ45 Port C-86 Problem C-86 Fix C-86 SFS 7024 Leaf Module IB Ports C-86 Problem C-86 Fix C-86 Troubleshooting Scenarios C-87 InfiniBand C-87 Invalid IP Address entered for SWC via Console Port C-87 Bad IB Cable C-87 Improperly Seated IB Cable C-87 Cisco SFS 7024 Hardware Users Guide OL-8794-02 v
Inhaltszusammenfassung zur Seite Nr. 8
Contents Cisco SFS 7024 Hardware Users Guide vi OL-8794-02
Inhaltszusammenfassung zur Seite Nr. 9
New and Changed Information The Cisco SFS 7024 Hardware Users Guide applies to the SFS 7024 Release 3.1 or later. Table 1 lists the new and changed features available with each supported SFS 7024 release. Table 1 Documented Features for the Cisco SFS 7024 Hardware Users Guide Changed in Feature Description Release Where Documented Initial release of the Cisco SFS 7024 Hardware Users Guide Redundant Added redundant management information. 3.3 Installing the Spine Management and Leaf Modu
Inhaltszusammenfassung zur Seite Nr. 10
Cisco SFS 7024 Hardware Users Guide viii OL-8794-02
Inhaltszusammenfassung zur Seite Nr. 11
Preface This preface describes the audience, organization, and conventions of the Cisco SFS 7024 Hardware Users Guide . It also provides information on how to obtain related documentation. Audience The intended audience for this document are network administrators responsible for configuring and operating network equipment. It assumes a basic working knowledge of: • Local Area Networks (LANs) � Ethernet concepts � Simple Network Management Protocol (SNMP) � InfiniBand Organization This g
Inhaltszusammenfassung zur Seite Nr. 12
Conventions This document uses the following conventions for notes, cautions, and safety warnings. Notes and Cautions contain important information that you should be aware of. Note Means reader take note. Notes contain helpful suggestions or references to material not covered in the publication. Caution Means reader be careful. You are capable of doing something that might result in equipment damage or loss of data. Safety warnings appear throughout this publication in procedures that, if per
Inhaltszusammenfassung zur Seite Nr. 13
Ordering Documentation You can find instructions for ordering documentation at this URL: http://www.cisco.com/univercd/cc/td/doc/es_inpck/pdi.htm You can order Cisco documentation in these ways: � Registered Cisco.com users (Cisco direct customers) can order Cisco product documentation from the Ordering tool: http://www.cisco.com/en/US/partner/ordering/index.shtml � Nonregistered Cisco.com users can order documentation through a local account representative by calling Cisco Systems Corporate
Inhaltszusammenfassung zur Seite Nr. 14
Note Use the Cisco Product Identification (CPI) tool to locate your product serial number before submitting a web or phone request for service. You can access the CPI tool from the Cisco Technical Support Website by clicking the Tools & Resources link under Documentation & Tools. Choose Cisco Product Identification Tool from the Alphabetical Index drop-down list, or click the Cisco Product Identification Tool link under Alerts & RMAs. The CPI tool offers three search options: by product ID
Inhaltszusammenfassung zur Seite Nr. 15
Obtaining Additional Publications and Information Information about Cisco products, technologies, and network solutions is available from various online and printed sources. � Cisco Marketplace provides a variety of Cisco books, reference guides, and logo merchandise. Visit Cisco Marketplace, the company store, at this URL: http://www.cisco.com/go/marketplace/ � The Cisco Product Catalog describes the networking products offered by Cisco Systems, as well as ordering and customer support ser
Inhaltszusammenfassung zur Seite Nr. 16
Cisco SFS 7024 Hardware Users Guide xiv OL-8794-02
Inhaltszusammenfassung zur Seite Nr. 17
CH A P TER 1 Product Overview The Cisco SFS 7024™ is an industry leading modular system used for creating large, single-system Grid/Cluster server fabrics, or as a building block for larger fabrics. The SFS 7024 is designed to maximize performance, streamline operations, and ensure uptime by providing full hardware and software reliability, availability, and serviceability (RAS) features. Leveraging InfiniBand (IB) — an industry-standard interconnect — the SFS 7024 provides high performance,
Inhaltszusammenfassung zur Seite Nr. 18
Chapter SFS 7024 Product Specifications Mechanical/Thermal/Power Specifications � 14U - 19" rack mount environment � Integrated thermal management � Front-to-back airflow � Hot plug, redundant cooling � Hot plug, redundant power supplies � 90/264 VAC operation � 50/60 Hz Frequency � Redundant, isolated AC inputs � FCC and VCCI compliant � U.L. Listed Thermal Management Features � Eight (8) fan trays, hot plug, N+1 fans � Two (2) fans per tray, 60mm, 12VDC � Available air flow: 400
Inhaltszusammenfassung zur Seite Nr. 19
Chapter � Available power (all fiber): 1758 Watts max � Available air flow: 200 cfm � Thermal status reporting to CME via IBML � Up to two hundred eighty-eight (288) 4X IB external copper ports � Four (4) RJ-45 connectors for 100BASE Ethernet connection to management LAN. � One (1) RJ-11 serial port per spine module for configuration. Chassis Viewer Software The Chassis Viewer is Cisco”s browser-based management software. Primary functions of Chassis Viewer for the SFS 7024 switch and i
Inhaltszusammenfassung zur Seite Nr. 20
Chapter – Reset the logs – Perform maintenance tasks – Manage firmware updates, including uploading new firmware and setting the active version. Subnet Manager Every InfiniBand fabric subnet requires a single active Subnet Manager (SM) to initialize and maintain the subnet. The fabric may also have one or more standby Subnet Managers. One of the standby Subnet Managers can be configured to become the active SM in the event of a failure. As Figure 1-2 shows, InfiniBand-enabled fabrics consi
