Bedienungsanleitung Dynamic Distributors 103B11

Inhaltszusammenfassung zur Seite Nr. 1

Model 103B11
ICP® Dynamic Pressure Sensor
Installation and Operating Manual
For assistance with the operation of this product , contact the Pressure
Division of PCB Piezotronics, Inc.
Division toll-free 888-684-0015
SM
24-hour SensorLine 716-684-0001
Fax 716-686-9129
E-mail pressure@pcb.com

Inhaltszusammenfassung zur Seite Nr. 2

Warranty, Service, Repair, and Return Policies and Instructions The information contained in this document supersedes all similar information that may be found elsewhere in this manual. Total Customer Satisfaction – PCB recommended as this helps build Piezotronics guarantees Total Customer confidence in measurement accuracy and Satisfaction. If, at any time, for any acquired data. Equipment calibration reason, you are not completely satisfied cycles are typically established by th

Inhaltszusammenfassung zur Seite Nr. 3

Materials Authorization (RMA) PCB for a complete statement of our Number. This RMA number should be warranty. Expendable items, such as clearly marked on the outside of all batteries and mounting hardware, are not package(s) and on the packing list(s) covered by warranty. Mechanical accompanying the shipment. A detailed damage to equipment due to improper account of the nature of the problem(s) use is not covered by warranty. being experienced with the equipment Electronic circuitry failur

Inhaltszusammenfassung zur Seite Nr. 4

OPERATION MANUAL FOR 1 MICROPHONE Series 103A 1.0 DESCRIPTION The Series 103A microphones are high-sensitivity pressure sensors featuring miniature size, built-in solid state electronics and acceleration compensation. The Model 103A (see installation drawing) has pigtail leads extending radially from the side of the unit and has a nominal sensitivity of 1500 mV/psi. The Model 103A11 is similar in appearance and in mode of electrical connection, but differs from the

Inhaltszusammenfassung zur Seite Nr. 5

OPERATION MANUAL FOR 2 MICROPHONE Series 103A The result is a two-wire system, precluding the need for multi-conductor cabling. VIEW FROM A second diaphragm, located behind the pressure DIAPHRAGM END diaphragm and attached to another bimorph bender WHITE TO crystal acting in opposition to the pressure crystal, READOUT provides acceleration compensation to the Series BLUE (N.C.) 103A Sensors. BLACK 3.0 INSTALLATION XDUCER SCOPE SERIES 480 As shown in installation drawing 1

Inhaltszusammenfassung zur Seite Nr. 6

OPERATION MANUAL FOR 3 MICROPHONE Series 103A Refer to Guide G-0001B for tips on power and signal At PCB, the units are subjected to various calibrated utilization. steps of pneumatic pressure to obtain a linearity curve over the full range of the instruments. NOTE: The internal low-noise amplifier in the Model 103A, A02, A11 and A12 differ from the 6.0 MAINTENANCE AND REPAIR ® standard ICP amplifiers described in Guide G- 0001B in that the turn-on (or bias) voltage i

Inhaltszusammenfassung zur Seite Nr. 7

Inhaltszusammenfassung zur Seite Nr. 8