Inhaltszusammenfassung zur Seite Nr. 1
DX-U10_8[U]c&s.book Page 1 Friday, March 2, 2007 11:22 AM
COMPACT COMPONENT SYSTEM
CA-DXU10
CA-DXU8
CA-DXU10
CA-DXU8
SUPER VIDEO
INSTRUCTIONS
GVT0210-001A
[US, UN, UG, UX, A, UW]
Inhaltszusammenfassung zur Seite Nr. 2
DX-U10_8[U]c&s.book Page 1 Friday, March 2, 2007 11:22 AM Warnings, Cautions and Others Caution–– (standby/on) button! Disconnect the mains plug to shut the power off completely (the STANDBY lamp goes off). When installing the apparatus, ensure that the plug is easily accessible. The button in any position does not disconnect the mains line. • When the System is on standby, the STANDBY lamp lights red. • When the System is turned on, the STANDBY lamp goes off. The power can be r
Inhaltszusammenfassung zur Seite Nr. 3
DX-U10_8[U]c&s.book Page 2 Friday, March 2, 2007 11:22 AM Caution: Proper Ventilation To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows: 1. Front: No obstructions and open spacing. 2. Sides/Top/Back: No obstructions should be placed in the areas shown by the dimensions below. 3. Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm or more. Front view Side view Wall or obst
Inhaltszusammenfassung zur Seite Nr. 4
DX-U10_8[U].book Page 1 Monday, March 26, 2007 2:24 PM Introduction About color system Playable Disc/File Types INFO This System accommodates both NTSC and PAL system and can play back discs/files recorded in either system. To change the color system, see page 6. Note on Region Code DVD players and DVD Video have their own Region Code COMPACT numbers. This System can play back only DVD Video with DIGITAL VIDEO SUPER VIDEO DIGITA
Inhaltszusammenfassung zur Seite Nr. 5
DX-U10_8[U].book Page 2 Monday, March 26, 2007 2:24 PM Precautions Contents Connections....................................................................................3 Installation Connecting a USB Mass Storage Class Device..........................6 • Install the System in a location with adequate ventilation to Preparing the Remote Control ....................................................6 prevent internal heat build-up in the System. Canceling the D
Inhaltszusammenfassung zur Seite Nr. 6
DX-U10_8[U].book Page 3 Monday, March 26, 2007 2:24 PM Connections Do not connect the AC power cord until all other Supplied accessories connections have been made. • FM antenna (x1) • AM loop antenna (x1) • Composite video cord (x1) • Connect VIDEO OUT directly to the video input of your • Remote control (x1) TV. Connecting VIDEO OUT to a TV via a VCR may • Batteries (x2) interfere with your viewing when playing back a copy- • AC plug adapter (x1) protected source. Connecting VIDEO OUT
Inhaltszusammenfassung zur Seite Nr. 7
OPTICAL DIGITAL OUTPUT DX-U10_8[U].book Page 4 Monday, March 26, 2007 2:24 PM ~ TV/monitor ⁄ AM/FM antenna To assemble the AM loop antenna Composite video cord (supplied) S-Video cord (not supplied) Green Red Blue To connect AM/FM antenna Component video cord (not supplied) • If the antenna cord is covered with vinyl on the tip, twist and pull the vinyl off to remove. • To select progressive scanning mode (see page 6), use COMPONENT jacks. AM loop antenna (supplied) • Connec
Inhaltszusammenfassung zur Seite Nr. 8
DX-U10_8[U].book Page 5 Monday, March 26, 2007 2:24 PM • The front and center speakers and subwoofer(s) are @ Speakers magnetically shielded to avoid color distortions on TVs. To connect the speaker cords However, if not installed properly, it may cause color distortions. So, pay attention to the following when installing the speakers. – When placing the speakers near a TV set, turn off the TV’s main power switch or unplug it before installing the speakers. 1Push 2Insert 3Release
Inhaltszusammenfassung zur Seite Nr. 9
DX-U10_8[U].book Page 6 Monday, March 26, 2007 2:24 PM ¤ Voltage selector (not applicable for Canceling the Demonstration Main Unit ONLY Australian models) Use a screwdriver to rotate the 2 sec. voltage selector so that the voltage DEMO OFF mark is pointing to the same voltage as where you are plugging in the unit. DEMO START (See also the back cover page.) To start the demonstration, select DEMO START. Voltage mark # Power cord Changing the Color System and Rem
Inhaltszusammenfassung zur Seite Nr. 10
DX-U10_8[U].book Page 7 Monday, March 26, 2007 2:24 PM Display Indication The indications on the display tell you a lot of things while you are operating the System. Before operating the System, be familiar with when and how the indicator illuminates on the display. 13 2 45 6 7 89 pq w e r t y u 1 Audio signal indicators 8 Play mode indicators • L/R/C/LS/RS/LFE: lights to indicate the incoming audio • PROGRAM: lights when Program Play is activated. channel signals. • RAND
Inhaltszusammenfassung zur Seite Nr. 11
DX-U10_8[U].book Page 8 Monday, March 26, 2007 2:24 PM Daily Operations—Playback ¥ Turn on the power. In this manual, the operations using the remote control The STANDBY lamp on the main unit goes off. are mainly explained; however, you can use the buttons • Without pressing AUDIO, the System also turns and controls on the main unit if they have the same (or on by pressing one of the source selecting buttons in similar) name and marks. the next step. ø Select the sourc
Inhaltszusammenfassung zur Seite Nr. 12
DX-U10_8[U].book Page 9 Monday, March 26, 2007 2:24 PM To tune in to a station Adjusting the Volume While FM or AM is selected... The volume level can be adjusted in 32 steps (VOLUME 1 sec. MIN, VOLUME 1 – VOLUME 30, and VOLUME MAX). SLOW Increases the frequency. Remote control: Main unit: AUDIO Decreases the frequency. Frequency starts changing on the display. VOL When a station (frequency) with sufficient signal strength is tuned in, the frequency search sto
Inhaltszusammenfassung zur Seite Nr. 13
DX-U10_8[U].book Page 10 Monday, March 26, 2007 2:24 PM 4 Store the station. To connect a USB mass storage class device ENTER USB cable /SET (not supplied) To tune in to a preset station 1 Select the band (FM or AM). • Always set volume level to the minimum level when FM/AM/AUX TUNER FM TUNER AM connecting or disconnecting the USB mass storage class device. AUX • To disconnect the USB mass storage class device safely, turn off the System before disconn
Inhaltszusammenfassung zur Seite Nr. 14
DX-U10_8[U].book Page 11 Monday, March 26, 2007 2:24 PM To return to normal playback, press DVD/CD 3 or To select a disc USB MEMORY 3. DISC 1 DISC 2 DISC 3 • For DivX files, each time you press the cursor 3 or 2, you can skip to a scene of 30 seconds or 5 minutes away DISC 4 DISC 5 depending on the DivX file. Playback starts. Remote ONLY To select a title/group While playing... 123 GROUP/TITLE Remote 456 ONLY To select an item directly 789 You can select a title
Inhaltszusammenfassung zur Seite Nr. 15
DX-U10_8[U].book Page 12 Monday, March 26, 2007 2:24 PM 7 For SVCD/VCD with PBC To start playback: To stop: While playing a disc with PBC, “PBC” appears on the display instead of the playing time. TAPE-A TAPE-B When disc menu appears on the TV screen, select an item on the menu. Playback of the selected item starts. • To select a number, see “How to 123 select a number” on page 8. To rewind or fast-forward tape: 456 SLOW 789 10 0 10 To change the tape running direction TA
Inhaltszusammenfassung zur Seite Nr. 16
DX-U10_8[U].book Page 13 Monday, March 26, 2007 2:24 PM Daily Operations—Sound & Other Adjustments Adjusting the Speaker Output Level Remote Control Remote ONLY INFO You can adjust the speaker output level from –6 (dB) to AUDIO +6 (dB). Initial setting: +4 (dB). TV • You can also use the setup menu to adjust the speaker AUDIO output level (see page 39). • This function is not available when the surround mode is TV set to “STEREO” or Mic Mixing is activated. 1 Select the speak
Inhaltszusammenfassung zur Seite Nr. 17
DX-U10_8[U].book Page 14 Monday, March 26, 2007 2:24 PM Applying an Optimal Bass Sound Effect Creating Your Own Sound Modes Remote ONLY —VARIO BASS —User Mode INFO You can adjust bass sound characteristics to create a sound You can adjust the preset Sound Modes to create your own suitable for the playback source of your preference. Sound Modes which suit your taste. The changed settings can be stored as the USER1, USER2 and USER3 Modes. AUTO O
Inhaltszusammenfassung zur Seite Nr. 18
DX-U10_8[U].book Page 15 Monday, March 26, 2007 2:24 PM • While Surround Mode is activated, indicator Selecting the Surround Modes INFO lights up. • For “DVD/CD” and “USB” (multi-channel software): 1 * Selectable Surround Mode varies depending on the SURROUND 1 MODE * AUTO DOLBY D/DTS/PPCM/LPCM software. 2 STEREO * MOVIE (Dolby Pro Logic II Movie) and MUSIC (Dolby Pro Logic II Music) cannot be used for DivX file. 1 Initial setting:
Inhaltszusammenfassung zur Seite Nr. 19
DX-U10_8[U].book Page 16 Monday, March 26, 2007 2:24 PM To adjust the picture tone Remote ONLY Setting the Clock INFO 1 Select “USER1” or “USER2.” Without setting the built-in clock, you cannot use any timers • Follow steps 1 and 2 on page 15. except the Sleep Timer. 2 Select a parameter you want to adjust. • To exit from the clock setting, press CLOCK/TIMER as required. • To correct a misentry during the process, press CANCEL. ENTER You can re
Inhaltszusammenfassung zur Seite Nr. 20
DX-U10_8[U].book Page 17 Monday, March 26, 2007 2:24 PM Unique Video Disc/File Operations Remote Selecting the Audio Track ONLY INFO Remote Control For DVD Video/DivX: While playing back a chapter/file containing audio languages, you can select the language to listen to. AUDIO For DVD Audio: While playing back a track containing TV audio channels, you can select the audio channel to listen to. AUDIO For DVD-VR/SVCD/VCD: While playing back a chapter/ track, you can select the
