Inhaltszusammenfassung zur Seite Nr. 1
MICRO COMPONENT SYSTEM
UX-G66 Consists of AX-UXG66, XT-UXG66,
TD-UXG66, and SP-UXG66.
STEREO AMPLIFIER
AX-UXG66
COMPACT DISC/TUNER
XT-UXG66
CASSETTE DECK
TD-UXG66
SPEAKER SYSTEM
SP-UXG66
OPEN/CLOSE
STANDBY/ON
MICRO SYSTEM UX-G66
COMPONENT
FM/AM AUX
MULTI JOG MOS - FET VOLUME
REMOTE CONTROL RM-SUXG6E
PANEL
OPEN/CLOSE DIMMER
1BIT P•E•M D•D•CONVER TER
ACTIVE
BASS EX. CLOCK/TIMER SLEEP
BASS TREBLE FM MODE
PHONES
COMPACT
PLAY MODE REPEAT AUTO PRESET
DIGITAL AUDIO
TITTLE/EDIT ENTER
DISPLAY
CANCEL
Inhaltszusammenfassung zur Seite Nr. 2
Warnings, Cautions and Others Avisos, precauciones y otras notas Advertências, precauções e outras notas Caution –– switch! Disconnect the mains plug to shut the power off completely (the STANDBY/ON lamp goes off). The switch in any position does not disconnect the mains The STANDBY/ON lamp line. Lámpara STANDBY/ON • When the unit is on standby, the STANDBY/ON lamp lights indicador luminoso STANDBY/ON red. • When the unit is turned on, the STANDBY/ON lamp lights green. The power can be remote
Inhaltszusammenfassung zur Seite Nr. 3
CAUTION To reduce the risk of electrical shocks, fire, etc.: 1. Do not remove screws, covers or cabinet. 2. Do not expose this appliance to rain or moisture. PRECAUCIÓN Para reducir riesgos de choques eléctricos, incendio, etc.: 1. No extraiga los tornillos, los cubiertas ni la caja. 2. No exponga este aparato a la lluvia o a la humedad. PRECAUÇÃO Para reduzir riscox de choques eléctricos, incêndio, etc.: 1. Não remova parafusos e tampas ou desmonte a caixa. 2. Não exponha este aparelho à chuva
Inhaltszusammenfassung zur Seite Nr. 4
Caution: Proper Ventilation To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows: 1 Front: No obstructions and open spacing. 2 Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below. 3 Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm or more. Precaución: el aparato debe estar bien ventilado Para evitar posibles riesgos de descargas eléct
Inhaltszusammenfassung zur Seite Nr. 5
IMPORTANT FOR LASER PRODUCTS IMPORTANTE PARA PRODUCTOS LÁSER IMPORTANTE PARA PRODUCTOS LASER REPRODUCTION OF LABELS / REPRODUCCIÓN DE ETIQUETAS / REPRODUÇÃO DE ETIQUETAS/ 2 WARNING LABEL, PLACED INSIDE THE UNIT 1 CLASSIFICATION LABEL, PLACED ON EXTERIOR SURFACE 2 ETIQUETA DE ADVERTENCIA, PEGADA EN EL 1 ETIQUETA DE CLASIFICACIÓN, PROVISTA SOBRE LA SUPERFICIE EXTERIOR INTERIOR DE LA UNIDAD 1 ETIQUETA DE CLASSIFICAÇÃO LOCALIZADA NA 2 ETIQUETA DE ADVERTÊNCIA LOCALIZADA NA PARTE PARTE POSTERIOR DA CA
Inhaltszusammenfassung zur Seite Nr. 6
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this micro component system, read this manual carefully and thoroughly to obtain the best possible performance from your system, and retain this manual for future reference. Power sources About This Manual • When unplugging from the wall outlet, always pull the This manual is organized as follows: plug, not the AC power cord. • The manual mainly explains operations using the buttons DO NOT handle the
Inhaltszusammenfassung zur Seite Nr. 7
Contents Introduction .......................................................... 1 Playing Back a Tape ........................................... 20 About This Manual ............................................................... 1 Playing Back a Tape — Basic Operation ........................... 20 Precautions ........................................................................... 1 Fast-Winding a Tape ........................................................... 21 Searching and Skipping t
Inhaltszusammenfassung zur Seite Nr. 8
Location of the Buttons and Controls Become familiar with the buttons and controls on the units. Front Panels STANDBY/ON OPEN/CLOSE AX-UXG66 1 4 MICR O COMPONENT SYSTEM UX-G66 Stereo Amplifier 5 2 6 FM/AM AUX MULTI JOG VOLUME MOS - FET 7 3 XT-UXG66 8 q Compact Disc 1BIT P•E•M D•D•CONVER TER /Tuner 9 w PHONES COMPACT p e DIGITAL AUDIO TD-UXG66 i r Cassette Deck DOLBY B NR o t REC PAUSE AUTO y ; REVERSE REC u a Display window REC BASS 2 1 34 3 EN01-13.UX-G66[US]f 3 12/11/00, 11:54 AM English
Inhaltszusammenfassung zur Seite Nr. 9
SYSTEM UX-G66 MICR O COMPONENT OPEN/CLOSE STANDBY/ON AUX FM/AM MULTI JOG MOS - FET VOLUME Continued Front Panels Buttons behind the sliding panel AX-UXG66 Stereo Amplifier 123456789p 1 button and STANDBY/ON lamp (11)* 2 MULTI JOG dial DISPLAY PLAY REC TITLE CLOCK 3 FM/AM button (14)* /CHARA. 4 ¢ SET CANCEL ENTER MODE MODE /EDIT /TIMER 4 OPEN/CLOSE button (13)* 5 Display window 6 VOLUME dial (12) 7 AUX button (13, 24)* XT-UXG66 Compact Disc/Tuner 8 CD tray 9 Remote sensor (5) p PHONES jack (12)
Inhaltszusammenfassung zur Seite Nr. 10
Continued Become familiar with the buttons on the remote control. Remote Control Remote Control 1 PANEL OPEN/CLOSE button (13) 2 CLOCK/TIMER button (10, 25) 3 ACTIVE BASS EX. (extension) button (12) REMOTE CONTROL RM-SUXG6E 4 TREBLE button (12) PANEL o OPEN/CLOSE DIMMER 5 BASS button (12)
; 1 6 REPEAT button (19) ACTIVE 2 CLOCK/TIMER SLEEP BASS EX. 7 PLAY MODE button (17)
3 a 8 TITLE/EDIT button * 4 BASS TREBLE FM MODE
9 UP button (12, 14, 17) 5 s 6 PLAY MODE REPEAT AUTO PRESET p DISPL
Inhaltszusammenfassung zur Seite Nr. 11
Getting Started Unpacking Connecting the System Control Cables and the External Wire After unpacking, check to be sure that you have all the following items. UX-G66 micro component system consists of three units, The number in the parentheses indicates the quantity of the AX-UXG66 Stereo Amplifier, XT-UXG66 Compact pieces supplied. Disc/Tuner, TD-UXG66 Cassette Deck, and SP-UXG66 Speaker System. • AM loop antenna (1) You can easily connect these units using the system control • FM antenna (1) ca
Inhaltszusammenfassung zur Seite Nr. 12
AM LOOP FM 75 COAXIAL AM LOOP FM 75 COAXIAL ANTENNA ANTENNA Continued Connecting MD Recorder XM-G6 Connecting Antennas You can also connect the MD recorder XM-G6 (not Supplied FM antenna supplied), specifically designed for UX-G66. This unit will complete UX-G66 micro component system. When you connect and use this unit, refer to the Instructions supplied with it for details. External wire AX-UXG66 (supplied with XM-G6) VOLTAGE SELECTOR External wire (supplied with UX-G66) XT-UXG
Inhaltszusammenfassung zur Seite Nr. 13
Continued AM antenna Connecting Speakers You can connect the speakers using the speaker cords. 1 2, 3 Vinyl-covered wire ANTENNA (not supplied) Red AM LOOP Speaker Cord Speaker Cord AM EXT FM 75 COAXIAL SPEAKERS RIGHT LEFT Black AM loop antenna (supplied) Right speaker Left speaker 1 Connect the AM loop antenna to the AM LOOP 1 Open the speaker terminal. terminals as illustrated. 2 Insert the end of the speaker cord to the terminal. 2 Turn the AM loop antenna until you have the best Match th
Inhaltszusammenfassung zur Seite Nr. 14
Continued To connect audio equipment with an optical digital Connecting Other Equipments input terminal You can connect the following equipments to the system: By using both an optical digital cable (not supplied) and an audio cable (not supplied), connect: • Audio equipment — used only as an analog playback • Between the optical digital input terminal on the other device. equipment and the optical digital output terminal on • Audio equipment with an optical digital input terminal XT-UXG66. — us
Inhaltszusammenfassung zur Seite Nr. 15
Basic Settings REMOTE CONTROL RM-SUXG6E DIMMER PANEL OPEN/CLOSE DIMMER OPEN/CLOSE STANDBY/ON ACTIVE CLOCK/TIMER SLEEP BASS EX. CLOCK/TIMER MICR O COMPONENT SYSTEM UX-G66 BASS TREBLE FM MODE MULTI JOG PLAY MODE REPEAT AUTO PRESET FM/AM AUX MULTI JOG VOLUME MOS - FET TITTLE/EDIT ENTER DISPLAY SET /CHARA. CANCEL CANCEL UP Display window SET < > < > / DOWN
MD AUX Before operating the system any further, set the clock built Setting the Display Illumination (Dimmer) in this system first, then
Inhaltszusammenfassung zur Seite Nr. 16
Common Operations PANEL REMOTE CONTROL RM-SUXG6E OPEN/CLOSE PANEL OPEN/CLOSE DIMMER STANDBY/ON OPEN/CLOSE (standby/on) ACTIVE CLOCK/TIMER SLEEP BASS EX. ACTIVE BASS EX. STANDBY/ON OPEN/CLOSE BASS BASS TREBLE FM MODE MICR O COMPONENT SYSTEM UX-G66 PLAY MODE REPEAT AUTO PRESET TREBLE TITTLE/EDIT ENTER BASS FM/AM AUX MULTI JOG MOS - FET VOLUME DISPLAY /CHARA. CANCEL UP SET < > UP/DOWN FM/AM BASS indicator AUX DOWN
AUX MD AUX MULTI JOG VOLUME FM/AM TAPE CD FM/AM
CD 6 (play/pause) TAP
Inhaltszusammenfassung zur Seite Nr. 17
Continued • To save the power consumption, make use of Dimmer Reinforcing the Bass Sound feature (see page 10). • To switch off the power supply completely, unplug the The richness and fullness of the bass sound is maintained AC power cord from the AC outlet. STANDBY/ON lamp regardless of how low you set the volume level. goes off. You can use this effect only while listening sources. • To get the effect, press ACTIVE BASS EX. button on When you unplug the AC power cord the remote control, and i
Inhaltszusammenfassung zur Seite Nr. 18
OPEN/CLOSE STANDBY/ON MICR O COMPONENT SYSTEM UX-G66 AUX FM/AM MULTI JOG MOS - FET VOLUME Continued Operating the Sliding Panel Listening to the External Equipment You can use the sliding panel to enable advanced operations You can listen to an external equipment such as MD recorder, features provided for UX-G66 micro component system. VCR, and other auxiliaries. First make sure that the external equipment is properly connected to the system (see page 7 and 9). For operation of the equipment, re
Inhaltszusammenfassung zur Seite Nr. 19
Listening to FM and AM Broadcasts Buttons behind the sliding panel REMOTE CONTROL RM-SUXG6E PANEL PANEL OPEN/CLOSE DIMMER DISPLAY PLAY REC TITLE CLOCK OPEN/CLOSE SET /CHARA. 4 ¢ CANCEL ENTER MODE MODE /EDIT /TIMER ACTIVE BASS EX. CLOCK/TIMER SLEEP BASS TREBLE FM MODE FM MODE PLAY MODE REPEAT AUTO PRESET AUTO PRESET 4 ¢ CANCEL TITTLE/EDIT ENTER SET OPEN/CLOSE DISPLAY SET /CHARA. CANCEL UP CANCEL OPEN/CLOSE STANDBY/ON UP/DOWN SET < > MICR O COMPONENT SYSTEM UX-G66 DOWN
MD AUX FM/AM FM/AM A
Inhaltszusammenfassung zur Seite Nr. 20
Continued 5 The tuned station in step 1 is now stored in the Preset Station preset channel selected in step 3. You are possibly not allowed to use the feature until the station presetting completes. In some cases, test frequencies have been already memorized for the system since the factory examined the preset station features before shipment. This is not a malfunction. Storing a new station on an used channel erases the previously stored one. Presetting Stations To preset stations automatically
