Inhaltszusammenfassung zur Seite Nr. 1
m
For assistance and information
call tollfree I-800-BUY-AIWA
(United States and Puerto Rico)
(ilE3iE
88-MA4-91 3-11
DIGITAL AUDIO
98031 5BMY-Y-9
Inhaltszusammenfassung zur Seite Nr. 2
4 Ventilation — The unit should be situated with adequate space around it so that proper heat ventilation is assured. Allow 10 cm clearance from the rear and the top of the unit, and 5 cm from each side. - Do not place the unit on a bed, rug, or similar surface that may block the ventilation openings. - Do not install the unit in a bookcase, cabinet, or airtight rack where ventilation may be impeded. 5 Objects and liquid entry — Take care that objects or liquid do not get inside the unit through
Inhaltszusammenfassung zur Seite Nr. 3
Outdoor Antenna 1 Power lines — When connecting an outdoor antenna, make sure it is located away from power lines, 2 Outdoor antenna grounding — Be sure the antenna system is properly grounded to provide protection against unexpected PREPARATIONS voltage surges or static electricity build-up. Article 810 of the National Electrical Code, ANS1/NFPA70, provides information CONNECTIONS ................................................................. 3 on proper grounding of the mast, supporting str
Inhaltszusammenfassung zur Seite Nr. 4
2 Connect the stereo turntable to the main unit. Connect the red plug to VIDEO/AUX/PHONO IN R jack, and the white plug to VIDEO/AUX/PHONO IN L jack. Check the AC voltage The rated voltage of your unit shown on the rear panel is 120 V AC. Check that the rated voltage matches your local voltage. Q 0 ‘o’ ,0 IMPORTANT e 0 . Connect the speakers, antennas, and all optional equipment first. 9 Then connect the AC cord in the end, 3 Connect the supplied antennas. Speakers Connect the FM antenna to FM 75
Inhaltszusammenfassung zur Seite Nr. 5
To position the antennas FM feeder antenna: Extend the antenna horizontally in a T-shape and fix its ends to the wall. AM antenna: Inserting batteries Position to find the best reception. Detach the battery cover on the rear of the remote control and insert two R6 (size AA) batteries, To stand the AM antenna on a surface Fix the claw to the slot. R6(AA) When to replace the batteries The maximum operational distance between the remote control . , and the sensor on the main unit should be approxim
Inhaltszusammenfassung zur Seite Nr. 6
CD DEMO 1 I ib---- —til ! b To turn the unit on 1 Press CLOCtVDIMMER once, then press ENTER Press one of the function buttons (TAPE, TUNER/BAND, VIDEO/ within 4 seconds. AUWPHONO, CD). Playback of the inserted disc begins, or the previously tuned station is received (Direct Play Function). POWER is also available. When the unit is turned on, the disc compartment may open and close to reset the unit. To turn the power off When using the remote control Press POWER. Press CLOCK whiIe pressing SHIFT
Inhaltszusammenfassung zur Seite Nr. 7
SHIFT T-BASS GEQ VOLUME SHIFT This unit provides the following three different equalization curves. ROCK: Powerful sound emphasizing treble and bass POP: More presence in the vocals and midrange Turn VOLUME on the main unit, or press VOLUME CLASSIC: Enriched sound with heavy bass and fine treble. on the remote control. The volume level is displayed as a number from O to MAX (31). Press GEQ repeatedly to select the equalization The volume level is automatically set to 16 when the power is mode. t
Inhaltszusammenfassung zur Seite Nr. 8
To search for a station quickly (Auto Search) Press TUNER PRESET repeatedly to display “SEARCH’’(auto search mode), and turn MULTI JOG clockwise or counterclockwise until the frequency starts to change rapidly. After tuning in to a station, the search stops. MONO TUNER BAND SHIFT To stop the Auto Search manually, turn MULTI JOG a little in either direction. ● The Auto Search may not stop at the stations with very weak signals. ● MDOWN and -UP are also available to search for a station. Keep -DOW
Inhaltszusammenfassung zur Seite Nr. 9
“ ‘w ‘~ . = *II’ ,1,*,” * -.,, ,,,!, -’! —, ‘= .-:- ‘-- !!!*, , ‘*’ ‘.. , ,,,*, ,.!!! !!!* . ., ,,,, ,,,8 PLAYING DISCS Load discs. To play all discs in the disc compartment, press F. EDITI CHECK Play begins with the disc on tray 1, RANDOM) Number of track being played Elapsed playing time REPEAT I 0-9,+1 o SHIFT To play one disc onl~ press one of DISC DIRECT PLAY 1-5. The selected disc is played once, Selected disc tray number Elapsed p[aying time Press CD, then press A OPEN/CLOSE to open the d
Inhaltszusammenfassung zur Seite Nr. 10
0-9,+1 o BAND SHIFT *---= L 1! Ii ............ II ~ 1 (Deck 1) (Deck 2) The unit can store a total of 32 preset stations. When a station is stored, a preset number is assigned to the station. Use the preset number to tune in to a preset station directly. Usable tapes Use Type I (normal) tapes only. 1 Press TUNEFUBAND to select a band, and press H DOWN or -UP to select a station. 1 Press TAPE, then press WA to open the cassette holder. Press I I SET to store the station. 2 A preset number beginni
Inhaltszusammenfassung zur Seite Nr. 11
“ When Ioadina an 8-cm (3-inch) disc, make sure to ~lace it onto reciselv. Otherwise, the disc may the inner circle of the trav p be damaged or the disc compartment will not open. If it does Up to 30 tracks can be programmed from any of the inserted not open, please consult your Aiwa dealer for repair. discs. ● Do not place more than one compact disc on one disc tray. - ● Do not tilt the unit with discs loaded, Doing so may cause malfunctions. 2 ● When transporting the unit, remove the discs fro
Inhaltszusammenfassung zur Seite Nr. 12
To record part of the CD When ● is pressed, recording always starts from the first track. To start inthe middle of a track, play the CD firstand press 11SET for CD at the point you wish to start recording from. Then, press ● . The pause mode for CD button is released automatically and recording stark. Sound adjustment during recording The output volume and tone of the speakers or headphones may be freely varied without affecting the recording. IISET ● Do not press the buttons on Deck 2 during re
Inhaltszusammenfassung zur Seite Nr. 13
Press ● on Deck 1 to start recording on the first 6 ,’,~,, ,7 ,- side. B :,~g = flashes for 10 seconds, and then CD play and recording ;F,gg:; of edited tracks for the first side start simultaneously. When ;*,, ,1, “: the end of the tape is reached, Deck 1 enters the recording ““’ , $ ;~ stop mode. After entering the recording stop mode go to step 4 -p 7. 5 7 Press EDiT/CHECK while pressing SHIFT on the remote control to display the program for the :r ‘ ‘“ second recording. 3,7 “B” is displayed.
Inhaltszusammenfassung zur Seite Nr. 14
Selected disc number Program number Remaining time on side A I I 5 4,5 Selected track number Programmed tracks number 6 Repeat step 5 for the rest of the tracks for side 3,7,8,9 A. A track whose playing time is longer than the remaining time cannot be programmed. 7 Press EDIT/CHECK while pressing SHIFT on the remote control to select side B and program the tracks for side B. Tape side B (reverse side) I In the Programmed edit recording function the tracks can be programmed while checking the rem
Inhaltszusammenfassung zur Seite Nr. 15
5 Prepare the source. To listen to a CD, load the disc to be played first on tray 1, To listen to a ta~e, insert the tape into Deck 1 or 2. To listen to the radio, tune in to a station. 6 Press POWER to turn the unit off after adjusting the volume and tone. @ remains on the display after the power is turned off (timer ,~;, 7 Get ready for the TAPE function or the timer recording. To listen to the tape, press ~. The unit can be turned on at a specified time every day with the To record the source
Inhaltszusammenfassung zur Seite Nr. 16
1 2 The unit can be turned off automatically at a specified time Preparation Use the remote control. ● Connect the supplied stereo turntable to the main unit. (See page 3) 1 Press SLEEP while pressing SHIFT. ● Set EQUALIZER AMP. selector on the turntable to ON position. (Refer to the operating instructions of the turntable for details.) 1 Press VIDEO/AUX/PHONO on the main unit. “VIDEO” appears on the display. The source name on the display can be changed to “PHONO. 2 Within 4 seconds, turn MULTI
Inhaltszusammenfassung zur Seite Nr. 17
— CD DIGITAL OUT l— (OPTICAL) POWER- To play equipment connected to VIDEO/AUX/PHONO IN jacks proceed as follows. Refer to the operating instructions of the connected equipment 1 Press VIDEO/AUX/PHONO. for details. “VIDEO” appears on the display. ● The connecting cords are not supplied. Obtain the necessary connecting cords. 2 Play the connected equipment. ● Consult your local Aiwa dealer for optional equipment. To change a source name on the display When VIDEO/ALfX/PHONO is pressed, “VIDEO” is d
Inhaltszusammenfassung zur Seite Nr. 18
Occasional care and maintenance of the unit and the software If the unit fails to perform as described in these Operating are needed to optimize the performance of your unit. Instructions, check the following guide. To clean the cabinet GENERAL Use a soft and dry cloth. There is no sound. If the surfaces are extremely dirty, use a soft cloth lightly ● Is the AC cord connected properly? moistened with mild detergent solution. Do not use strong ● Is there a bad connection? (+ page 3) solvents, suc
Inhaltszusammenfassung zur Seite Nr. 19
NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Main unit CX-ZR555 This equipment generates, uses, and can radiate radio frequency FM tuner section energy and, if not installed and used in accordance with the Tuning range 87.5 Mtiz to 108 MHz instructions, may cause harmful interference t
Inhaltszusammenfassung zur Seite Nr. 20
3 Superficie de montaje — Ponga la unidad sobre una superficie plana y nivelada. 4 Ventilation — La unidad debera situarse donde tenga suficiente espacio Iibre a su alrededor, para que la ventilation apropiada quede asegurada. Deje un espacio Iibre de 10 cm por la parte posterior y superior de la unidad, y 5 cm por cada Iado. - No ponga la unidad sobre una cama, una alfombra o superficies similares que podrfan tapar Ias aberturas de ventilation. - No instale la unidad en una Iibrer(a, mueble o e
