Inhaltszusammenfassung zur Seite Nr. 1
AMC TR1a
WiFi Wireless Transmitter
with Video On Demand and Broadcasting
IA
Inhaltszusammenfassung zur Seite Nr. 2
Inhaltszusammenfassung zur Seite Nr. 3
Inhaltszusammenfassung zur Seite Nr. 4
CAUTIONS AND FEATURE LIST FEATURES OF THE AMC MODEL TR1a TM * with Video on Demand and Broadcasting features. * Wireless IEEE 802.11a 5 GHz WiFi configuration. * Internal NTSC / PAL or SECAM / PAL dual band TV Tuner. * Multiple audio and video inputs supported. * Three external Video Inputs : S VIDEO input: one S connector AV1 input: Composite Video (three RCA Connectors - Video, L & R) AV2 input: Composite Video (one 3.5mm Mini connector - Video, L & R) * MPEG II video chip Encoder * Video Scal
Inhaltszusammenfassung zur Seite Nr. 5
REAR & FRONT SIDE PANELS / FRONT PANEL REAR & FRONT SIDE PANELS 10 1 2 3 4 5 67 8 9 1. "RJ-45" 2. "DC 12V" power input connector RCA connector (Red) 3. "OFF/ON" Power Switch 4. "S VIDEO" input connector 3.5mm mini connector(Video, L, R) 5. "AV1" Composite Video inpu RCA connector (Yellow) 6. "AV1" Audio L input RCA connector (White) 7. "AV1" Audio R input RCA connector (Red) 8. "AV2" Composite Video input 3.5mm mini connector(Video, L, R) 9. "TV Tuner" input connector 10. WiFi External Antenna F
Inhaltszusammenfassung zur Seite Nr. 6
FRONT PANEL 1 2 3 4 1. LED 1 (Orange) Wireless LED 2. LED 2 (Green) Power LED 3. LED 3 (Red) Tuner Status 4. RESET 4
Inhaltszusammenfassung zur Seite Nr. 7
FREAR SIDE PANEL 1. RJ-45 8. "AV2" Composite Video input The RJ45 is for updating firmware of 3.5mm mini connector (Video, L, R) TR1a or hooking TR1a to Ethernet This is a 3.5mm mini connector with Network for linking TR1a to all other Video, L, R for Composite Video "AV2" equipment with IP addresses linked to the input for hooking to Composite Sources. Ethernet Network. 9. "TV Tuner" input connector 2. "DC 12V" power input connector This is a connector for hooking to TV This DC 12V power input
Inhaltszusammenfassung zur Seite Nr. 8
FRONT SIDE PANEL 1. Connector for IR Blaster connecting to external Stereo Audio The 3.5mm mini connector is for IR systems and the latency between the Blaster Output. IR Blasters can be Pre-Out and Video will have to be hooked up to the connector. adjusted by time delay module. So, the Pre-Out is an option and will be installed 2. Connector for Stereo Audio Pre-Out for special designed projects and (Option) according to special orders only. The 3.5mm mini connector is for Stereo Audio Pre-Out.
Inhaltszusammenfassung zur Seite Nr. 9
REMOTE CONTROL (for using with receiving units like AMC i-M15a to control TR1a through IR receiver on receiving units and WiFi) 1 3 4 2 5 6 8 7 9 10 12 11 13 14 15 18 16 17 19 22 20 21 7
Inhaltszusammenfassung zur Seite Nr. 10
Function of each button on Remote Control Handset: 1. Power On/Off 2. Rescan for receiver to re-scan and locate all available TR1a and can select one preferable TR1a. 3. Video Select AV1, AV2 or S VIDEO input of the TR1a selected 4. TV Select Cable/Broadcast TV input of the TR1a selected 5. Audio STEREO, SAP, MONO 6. Screen Select Display aspect ratio 16:10 or 4:3 7. Menu function up Menu function down Menu Menu function display Menu function forward Menu function backward 8. Mute Audio Mute On/
Inhaltszusammenfassung zur Seite Nr. 11
19. TV Scan Auto-detect channels with TV programs 20. Wireless Wireless channel selection 21. Bitrate Low, Mid, High 22. Enter Function confirm 9
Inhaltszusammenfassung zur Seite Nr. 12
SETUP AND INSTALLATION Installing the TR1a For the best reception of the wireless signal to all areas of your house, it is best to install the TR1a near the center of your house. TR1a setup overview Connecting source devices to TR1a 3 2 1 10
Inhaltszusammenfassung zur Seite Nr. 13
1. Connect the Cable TV or Broadcast TV Antenna to the "TV Tuner" connector on rear side panel of TR1a 2. Connect source devices to "S VIDEO", "AV1" and "AV2" input connectors on rear side panel of TR1a S VIDEO AV1 AV2 (Mini AV) (DVD-1) DVD-2 Use S-Video cable included in TR1a to connect your source device with S-Video output to the S Video input connector of TR1a. Use 3 RCA plug to 3 RCA plug Composite AV cable (Yellow for Video, White for Audio-L, Red for Audio-R) included in TR1a to connect y
Inhaltszusammenfassung zur Seite Nr. 14
INSTALLING THE CORRESPONDING RECEIVERS LIKE i-M15a (here we use i-M15a for the installing procedures ) 1. Turn on TR1a power LED will be lighted 2. Turn i-M15a (or other corresponding receivers) battery power ON by pressing the POWER (Battery Power) button on top of i-M15a for 5 seconds. Once i-M15a battery power turning ON i-M15a will be under Standby mode. (If you have power adaptor plugged into i-M15a, the i-M15a will be under Standby mode all the time. 3. Pressing ON/OFF button on top panel
Inhaltszusammenfassung zur Seite Nr. 15
b. Press TV SCAN button on the remote and choose your local TV system by pressing "TV SCAN" button in sequence. c. After choosing your TV system, press ENTER on the remote, the TV Tuner in TR1a will automatically scan and save all available channels. d. Now you can enjoy TV programs on your i-M15a by using the remote handset similar to normal TV set. 11. Selecting AV1, AV2 and S VIDEO Press VIDEO button on remote, you will be able to select AV1 or AV2 or S VIDEO input source. 13
Inhaltszusammenfassung zur Seite Nr. 16
Video On Demand and Broadcasting 14
Inhaltszusammenfassung zur Seite Nr. 17
SPECIFICATIONS Wireless ............................................. IEEE 802.11a 5 GHz Video Encoder .............................. MPEG2 video chip, DVD Quality Video Scaler ......................................... 3D video image chip with Video on Demand and Broadcasting features Wireless IEEE 802.11a 5 GHz Wifi configuration Internal NTSC / PAL or SECAM / PAL dual band TV Tuner Three external Video Inputs : S VIDEO input : one S connector AV1 input: Composite Video(three RCA Connectors- Vi
Inhaltszusammenfassung zur Seite Nr. 18
SAFETY INSTRUCTION 1. READ INSTRUCTIONS 16. DAMAGE REQUIRING SERVICE All the safety and operating instructions should be read The appliance should be serviced by qualified service before the appliance is operated. personnel when: a) The power-supply cord or the plug has been damaged; or 2. RETAIN INSTRUCTIONS b) Objects have fallen, or liquid has been spilled into the The safety and operating instructions should be retained for appliance; or future reference. c) The appliance has been exposed to
Inhaltszusammenfassung zur Seite Nr. 19
Inhaltszusammenfassung zur Seite Nr. 20
WELTRONICS CORP. LONDON/L.A. AMC Web: http://www.amchome.com PN: 21R-4210
