Inhaltszusammenfassung zur Seite Nr. 1
U A
RX-V800
Natural Sound AV Receiver
YAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE., BUENA PARK, CALIF. 90620, U.S.A.
YAMAHA CANADA MUSIC LTD. 135 MILNER AVE., SCARBOROUGH, ONTARIO M1S 3R1, CANADA
YAMAHA ELECTRONIK EUROPA G.m.b.H. SIEMENSSTR. 22-34, 25462 RELLINGEN BEI HAMBURG, F.R. OF GERMANY
YAMAHA ELECTRONIQUE FRANCE S.A. RUE AMBROISE CROIZAT BP70 CROISSY-BEAUBOURG 77312 MARNE-LA-VALLEE CEDEX02, FRANCE OWNER’S MANUAL
YAMAHA ELECTRONIC
Inhaltszusammenfassung zur Seite Nr. 2
SAFETY INSTRUCTIONS 8 Ventilation – The unit should be situated so that its location or position does not interfere with its proper ventilation. For CAUTION example, the unit should not be situated on a bed, sofa, rug, RISK OF ELECTRIC SHOCK or similar surface, that may block the ventilation openings; or DO NOT OPEN placed in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation CAUTION: TO REDUCE THE RISK OF openings. ELECTRIC SHOCK, DO
Inhaltszusammenfassung zur Seite Nr. 3
BASIC OPERA- ADVANCED ADDITIONAL INTRODUCTION PREPARATION TION OPERATION INFORMATION APPENDIX English SAFETY INSTR SAFETY INSTR UCTIONS UCTIONS 19 For US customers only: EXAMPLE OF ANTENNA GROUNDING Outdoor Antenna Grounding – If an outside antenna is connected to this unit, be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the ANTENNA MAST LEAD IN National Electrical Code, ANSI/NFPA 70, provides WIRE infor
Inhaltszusammenfassung zur Seite Nr. 4
CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. 1 To assure the finest performance, please read this 15 Do not attempt to modify or fix this unit. Contact manual carefully. Keep it in a safe place for future qualified YAMAHA service personnel when any reference. service is needed. The cabinet should never be opened for any reasons. 2 Install this unit in a well ventilated, cool, dry, clean place with at least 30 cm on the top, 20 cm on the 16 When not planning to use this unit for long periods r
Inhaltszusammenfassung zur Seite Nr. 5
BASIC ADVANCED ADDITIONAL INTRODUCTION PREPARATION OPERATION OPERATION INFORMATION APPENDIX English INTRODUCTION CONTENTS INTRODUCTION ADVANCED OPERATION CONTENTS ........................................................... 1 SET MENU .......................................................... 36 FEATURES ............................................................ 2 Adjusting the Items on the SET MENU................. 36 1 SPEAKER SET (speaker mode settings) ........... 37 GETTING STARTED .......
Inhaltszusammenfassung zur Seite Nr. 6
Thank you for selecting this YAMAHA AV receiver. FEATURES Built-in 5-Channel Power Amplifier Other Features Minimum RMS Output Power 96-kHz/24-bit D/A Converter (0.04% THD, 20 Hz – 20 kHz) “SET MENU” which Provides You with 15 Items Main: 100 W + 100 W (8 Ω ) for Optimizing This Unit for Your Audio/Video Center: 100 W (8 Ω ) System Rear: 100 W + 100 W (8 Ω ) Test Tone Generator for Easier Speaker Balance Maximum Power (EIAJ) Adjustment (10% THD, 1 kHz) 6-Channel External Decoder Inpu
Inhaltszusammenfassung zur Seite Nr. 7
BASIC ADVANCED ADDITIONAL INTRODUCTION PREPARATION OPERAIONT OPERATION INFORMATION APPENDIX English GETTING STARTED Checking the Package Contents Check your package to make sure it has the following items. Remote control Manganese batteries (4) AM loop antenna (AAA, R03, UM-4) Indoor FM antenna Quick Reference Card (U.S.A., Canada, China and Quick Reference Card general models) A/B/C/D/E (Australia and Singapore models) Changing batteries Installing Batteries in the Remote As the batteries los
Inhaltszusammenfassung zur Seite Nr. 8
CONTROLS AND FUNCTIONS Front Panel 2 67 1 3 4 5 INPUT VOLUME 6CH INPUT INPUT MODE DIGITAL DIGITAL SURROUND STANDBY /ON PRESET/ PRESET TUNING A/B/C/D/E TUNING /TUNING FM/AM MEMORY MODE BASS TREBLE TUNER SPEAKERS BASS PROCESSOR EDIT MAN'L/AUTO FM AUTO/MAN'L MONO AB EXTENSION DIRECT PHONES S VIDEO VIDEO L AUDIO R OPTICAL EFFECT PROGRAM ON OFF DSP – – + + SILENT VIDEO AUX PRESET TUNING /TUNING FM/AM MEMORY MODE EDIT MAN'L/AUTO FM AUTO/MAN'L MONO 890 q w e r ty a s o u i p 1 STANDBY/ON 6 VOLUME Tu
Inhaltszusammenfassung zur Seite Nr. 9
BASIC ADVANCED ADDITIONAL INTRODUCTION PREPARATION OPERAIONT OPERATION INFORMATION APPENDIX English D I G I T A L CONTROLS AND FUNCTIONS q EFFECT p TUNING MODE (AUTO/MAN’L MONO) Switches the effect speakers (center and rear) on and off. Switches the tuning mode between automatic and manual. If you turn off the output of these speakers by using To select the automatic tuning mode, press this button so EFFECT, all Dolby Digital and DTS audio signals except that the “AUTO” indicator lights up on th
Inhaltszusammenfassung zur Seite Nr. 10
CONTROLS AND FUNCTIONS Remote Control This section describes the basic operation of this unit with 3 Numeric buttons (Input selector buttons) the remote control. First, set the selector dial to the AMP/ These buttons select the input source. TUN position. See “REMOTE CONTROL FEATURES” See pages 7 and 8 for the numeric buttons. on pages 46 to 53 for full details. 4 TEST Outputs the test tone. 5 ON SCREEN 1 9 Selects the on-screen display (OSD) mode for your video monitor. 2 0 6j / i Select the AM
Inhaltszusammenfassung zur Seite Nr. 11
BASIC ADVANCED ADDITIONAL INTRODUCTION PREPARATION OPERAIONT OPERATION INFORMATION APPENDIX English CONTROLS AND FUNCTIONS u VOLUME +/– When selecting a DSP program Increases or decreases the volume level. and turning on or off the effect speakers (center and rear) i MUTE Mutes the sound. Press again to restore the audio output to the previous volume level. A B EFFECT Switches the effect speakers (center and rear) on and off in the following cases: • When the selector dial is set to the DSP/TU
Inhaltszusammenfassung zur Seite Nr. 12
CONTROLS AND FUNCTIONS When selecting a preset station Using the Remote Control number DIGITA L DIGITAL STANDBY SURROUND /ON – + – + 30° 30° Approximately 6 m (20 feet) 1 Set code number “0023” in the AMP/TUN (or DSP/TUN) position. See page 51 for setting the code. 2 Set the selector dial to the AMP/TUN (or The remote control transmits a directional infrared beam. DSP/TUN) position. Be sure to aim the remote control directly at the remote control sensor on the main unit during operation. 3 You
Inhaltszusammenfassung zur Seite Nr. 13
BASIC ADVANCED ADDITIONAL INTRODUCTION PREPARATION OPERAIONT OPERATION INFORMATION APPENDIX English CONTROLS AND FUNCTIONS Front Panel Display 1234 5 678 9 PS PTY RT CT DVD VIRTUAL DTS MOVIE THEATER 1 2 PTY HOLD EON STEREO AUTO VOLUME D-TV/LD MD/TAPE DIGITAL DOLBY DIGITAL NEWS INFO AFFAIRS SPORT PRO LOGIC ENTERTAINMENT MEMORY TUNED SLEEP CBL/SAT CD-R PRO LOGIC DSP VCR 1 TUNER 6.1/ES VCR2/DVR CD SP dB PCM AB ms V-AUX PHONO e t 0 q w r yu 1t indicator 9 Input source indicator
Inhaltszusammenfassung zur Seite Nr. 14
CONTROLS AND FUNCTIONS Rear Panel 1 2 3 4 5 6 7 8 9 DIGITAL OUTPUT AUDIO AUDIO VIDEO TUNER MD/ R L R L S VIDEO VIDEO COMPONENT TAPE DVD IN DVD Y (PLAY) AM MD/TAPE CD-R ANT OUT D-TV PB/ (REC) SPEAKERS OUTPUT AC OUTLETS /LD CB + – – + GND SWITCHED OPTICAL R L 120V 60Hz CD 100W MAX. TOTAL CBL PR/ MAIN IN A /SAT CR (PLAY) R L 75 UNBAL. CD-R CD-R D-TV/LD OUT MAIN FM (REC) IN Y ANT VCR 1 DVD B GND PB/ CD OUT CB D-TV SUB /LD CENTER WOOFER + – PR/ PHONO IN CR OPTICAL VCR 2 IMPEDANCE SELECTOR /DVR MON
Inhaltszusammenfassung zur Seite Nr. 15
BASIC OPERA- ADVANCED ADDITIONAL INTRODUCTION PREPARATION TION OPERATION INFORMATION APPENDIX English PREPARATION SPEAKER SETUP Speakers to Be Used Speaker Placement This unit has been designed to provide the best sound- Refer to the following diagram when you place the field quality with a 5-speaker system, using left and right speakers. Main speaker (R) main speakers, left and right rear speakers, and a center speaker. If you use different brands of speakers (with Rear speaker (R) different to
Inhaltszusammenfassung zur Seite Nr. 16
CONNECTIONS Before Connecting Components CAUTION Never connect this unit and other components to mains power until all connections between components have been completed. • Be sure all connections are made correctly, that is to say L (left) to L, R (right) to R, “+” to “+” and “–” to “–”. Some components require different connection methods and have different jack names. Refer to the operation instructions for each component to be connected to this unit. • When you connect other YAMAHA audio com
Inhaltszusammenfassung zur Seite Nr. 17
BASIC OPERA- ADVANCED ADDITIONAL INTRODUCTION PREPARATION TION OPERATION INFORMATION APPENDIX English CONNECTIONS OPTICAL OPTICAL OPTICAL INPUT MD recorder or OUTPUT INPUT CD recorder tape deck INPUT OUTPUT OUTPUT INPUT L R L R L R L R O DIGITAL OUTPUT AUDIO AUDIO VIDEO TUNER R L R L S VIDEO VIDEO COMPONENT MD/ TAPE DVD IN DVD O Y (PLAY) AM MD/TAPE CD-R ANT OUT D-TV PB/ (REC) CB /LD OPTICAL GND OPTICAL OUTPUT CD CBL PR/ IN O /SAT CR (PLAY) 75 UNBAL. CD-R CD-R D-TV/LD OUT FM OUTPUT (REC) I
Inhaltszusammenfassung zur Seite Nr. 18
CONNECTIONS Connecting Video Components About the video jacks There are three types of video jacks. Video signals input through the VIDEO jacks are the conventional composit video signals. Video signals input through the S VIDEO jacks are separated into luminance (Y) and color (C) video signals. The S-video signals achieve high-quality color reproduction. Video signals input through the COMPONENT VIDEO jacks are separated into luminance (Y) and color difference (PB/CB, PR/CR) video signals. Th
Inhaltszusammenfassung zur Seite Nr. 19
BASIC OPERA- ADVANCED ADDITIONAL INTRODUCTION PREPARATION TION OPERATION INFORMATION APPENDIX English CONNECTIONS Note • If your LD player has an Dolby Digital RF signal output jack, connect it to this unit through an RF demodulator (separately purchased). RF OUTPUT OPTICAL OPTICAL LD player OUTPUT OUTPUT COMPONENT COMPONENT OUTPUT OUTPUT AUDIO AUDIO OUTPUT OUTPUT TV/digital TV or DVD player LD player S VIDEO VIDEO S VIDEO VIDEO V L R V S S OUTPUT OUTPUT OUTPUT OUTPUT DIGITAL OUTPUT AUDIO AUDIO
Inhaltszusammenfassung zur Seite Nr. 20
CONNECTIONS Connecting the Speakers Be sure to connect the left channel (L), right channel (R), “+” (red) and “–” (black) properly. If the connections are faulty, no sound will be heard from the speakers, and if the polarity of the speaker connections is incorrect, the sound will be unnatural and lack bass. CAUTION • Use speakers with the specified impedance shown on the rear panel of this unit. • Do not let the bare speaker wires touch each other and do not let them touch any metal part of this
