Inhaltszusammenfassung zur Seite Nr. 1
RX-V340
RTL
RX-V340
AV Receiver
OWNER’S MANUAL
MANUAL DE INSTRUCCIONES
YAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE., BUENA PARK, CALIF. 90620, U.S.A.
YAMAHA CANADA MUSIC LTD. 135 MILNER AVE., SCARBOROUGH, ONTARIO M1S 3R1, CANADA
YAMAHA ELECTRONIK EUROPA G.m.b.H. SIEMENSSTR. 22-34, 25462 RELLINGEN BEI HAMBURG, F.R. OF GERMANY
YAMAHA ELECTRONIQUE FRANCE S.A. RUE AMBROISE CROIZAT BP70 CROISSY-BEAUBOURG 77312 MARNE-LA-VALLEE CEDEX02, FRANCE
Inhaltszusammenfassung zur Seite Nr. 2
Schneider 337 Scott 399 335 336 348 359 352 354 CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. 358 Seleco 322 1 To assure the finest performance, please read this 13 To prevent damage by lightning, disconnect the power Sharp 395 362 382 manual carefully. Keep it in a safe place for future cord from the wall outlet during an electrical storm. Siemens 393 reference. 14 Do not attempt to modify or fix this unit. Contact Signature 2000 395 397 2 Install this sound system in a well ventilated, cool,
Inhaltszusammenfassung zur Seite Nr. 3
BASIC ADVANCED ADDITIONAL INTRODUCTION PREPARATION OPERATION OPERATION INFORMATION English CONTENTS INTRODUCTION ADVANCED OPERATION CONTENTS ............................................................ 1 SET MENU ........................................................... 37 FEATURES ............................................................. 2 Set menu list ............................................................ 37 GETTING STARTED ............................................ 3 Adjusting
Inhaltszusammenfassung zur Seite Nr. 4
FEATURES Built-in 5-channel power amplifier Multi-mode digital sound field processing Minimum RMS output power Dolby Pro Logic/Dolby Pro Logic II decoder (0.1% THD, 1 kHz, 6Ω ) Dolby Digital/Dolby Digital + Matrix 6.1 Decoder [U.S.A. and Canada models] DTS/DTS + Matrix 6.1 Decoder Main: 70 W + 70 W CINEMA DSP: Combination of YAMAHA DSP Center: 70 W technology and Dolby Pro Logic, Dolby Digital or Rear: 70 W + 70 W DTS [Other models] Virtual CINEMA DSP Main: 60 W + 60 W SILENT CINEM
Inhaltszusammenfassung zur Seite Nr. 5
INTRODUCTION English GETTING STARTED Supplied accessories After unpacking, check that the following parts are contained. Remote control Batteries (2) Indoor FM antenna (AA, R06, UM-3) (U.S.A., Canada, China, Korea and General models) SYSTEM POWER POWER POWER STANDBY POWER TV TV AV CD MD/CD-R TUNER SLEEP DVD D-TV/CBL VCR V-AUX REC 6CH INPUT AUDIO DISC SKIP CODE SET AMP TV + + + AM loop antenna (Europe, U.K., Australia and VOL CH VOLUME – – – Singapore models) MUTE INPUT MUTE HALL JAZZ ROCK ENTERT
Inhaltszusammenfassung zur Seite Nr. 6
CONTROLS AND FUNCTIONS Front panel 12 3 45 67 8 VOLUME RDS MODE/FREQ EON PRESET/TUNING FM/AM STANDBY EDIT /ON PTY SEEK MODE START TUNING MODE MEMORY AUTO/MAN`L MONO MAN`L/AUTO FM INPUT MODE 6CH INPUT SILENT SPEAKERS STEREO PROGRAM A/B/C/D/E PRESET/TUNING CONTROL BASS/TREBLE INPUT ON A OFF B EFFECT NEXT SET MENU PHONES 9 0 qw e r t y u i o p RDS MODE/FREQ EON PTY SEEK MODE START as df (U.K. and Europe models only) 1 STANDBY/ON 6 FM/AM Turns the unit on, or sets it in standby mode. When you Switch
Inhaltszusammenfassung zur Seite Nr. 7
INTRODUCTION English CONTROLS AND FUNCTIONS w STEREO (EFFECT) Switches between normal stereo and DSP effect (U.K. and Europe models only) reproduction. When you select STEREO, the unit mixes down all Dolby Digital and DTS signals (except the LFE a RDS MODE/FREQ channel) as well as those 2-channel signals without Press this button when the unit is receiving an RDS effects, to the main left and right speakers. station, to cycle the display mode among PS mode, PTY mode, RT mode, CT mode (if the sta
Inhaltszusammenfassung zur Seite Nr. 8
CONTROLS AND FUNCTIONS Remote control This section describes the controls and functions of the 1 Infrared emitter remote control when it is set in AMP mode. Please make Outputs infrared control signals. Aim this emitter at the sure to select AMP mode before beginning operation. component you want to operate. 2 Input selector buttons Select the input source and set the remote control to 7 1 operate the selected source component. 3 DSP program SYSTEM Select DSP programs when the remote control is
Inhaltszusammenfassung zur Seite Nr. 9
INTRODUCTION English CONTROLS AND FUNCTIONS r MUTE Using the remote control Mutes the sound. Press again to restore the audio output to the previous volume level. VOLUME t 6.1/5.1 PRESET/TUNING FM/AM STANDBY EDIT /ON TUNING MODE MEMORY AUTO/MAN`L MONO MAN`L/AUTO FM Switches on or off the Dolby Digital + Matrix 6.1 or DTS INPUT MODE 6CH INPUT SILENT SPEAKERS STEREO PROGRAM A/B/C/D/E PRESET/TUNING CONTROL BASS/TREBLE INPUT + Matrix 6.1 decoder. ON A OFF B EFFECT NEXT SET MENU PHONES y STEREO Swi
Inhaltszusammenfassung zur Seite Nr. 10
CONTROLS AND FUNCTIONS Front panel display 13 2 45 6 7 8 VCR V-AUX D-TV/CBL DVD MD/CD-R TUNER CD VIRTUAL NIGHT MUTE VOLUME MATRIX PS PTY RT CT STEREO AUTO HiFi DSP SLEEP SILENT EON PTY HOLD TUNED MEMORY DIGITAL L C R PCM PL ft LFE RL RC RR PL ~~~~~~~~~~~~~~ dB 90q wer tyuiop a (U.K. and Europe models only) 1 Processor indicators w NIGHT indicator The indicators for the various decoders light up when the Lights up when the unit is set to night listening mode. decoders are in use. e HiFi DSP in
Inhaltszusammenfassung zur Seite Nr. 11
PREPARATION English CONNECTIONS Connecting to digital jacks Before connecting components This unit has digital jacks for direct transmission of digital signals through either a coaxial or fiber optic cable. You can use the digital jacks to input PCM, Dolby CAUTION Digital and DTS bitstreams. Use digital connections if Do not connect this unit or other components to the you wish to enjoy the multi-channel sound track of DVD mains power until all connections between the material, etc. with DSP e
Inhaltszusammenfassung zur Seite Nr. 12
CONNECTIONS Connecting another video component Connecting video components Connect the video signal output jack on your component to the VIDEO jack on this unit. Connect the audio signal output jacks on the component to the AUDIO jacks on this unit. Connecting a video monitor Connect the video input jack on your video monitor to the MONITOR OUT VIDEO jack. Connecting a recording component Connect the audio signal input jacks on your video Connecting a DVD player Connect the optical digit
Inhaltszusammenfassung zur Seite Nr. 13
PREPARATION English CONNECTIONS Note Connecting audio components • Once you have connected a recording component to this unit, keep its power turned on while using this unit. If the power is Connecting a CD player off, this unit may distort the sound from other components. Connect the coaxial digital output jack on your CD player to the DIGITAL INPUT CD jack on this unit. y • Use the AUDIO jacks on this unit to connect to a CD player that does not have a COAXIAL DIGITAL OUTPUT jack, or to reco
Inhaltszusammenfassung zur Seite Nr. 14
CONNECTIONS Connecting the antennas Both AM and FM indoor antennas are included with this Connecting the AM loop antenna unit. In general, these antennas should provide sufficient signal strength. 1 Set up the AM loop antenna, then connect it to the terminals on this unit. Connect each antenna correctly to the designated terminals. AM loop antenna Indoor FM (included) antenna (included) DEO TUNER AM 2 Press and hold the tab to insert the AM loop ANT antenna lead wires into the AM ANT and GND G
Inhaltszusammenfassung zur Seite Nr. 15
PREPARATION English CONNECTIONS Connecting an external decoder This unit is equipped with 6 additional input jacks (MAIN left and right, CENTER, SURROUND left and right and SUBWOOFER) for discrete multi-channel input from a component equipped with a multi-channel decoder and 6 channel output jacks such as a DVD/SACD player. /CD-R OUT DIGITAL V-AUX (REC) INPUT 75Ω UNBAL. CD 2 FM MAIN IN ANT VCR COAXIAL OUT OPTICAL SURROUND DVD 1 SUB MONITOR WOOFER OUT SUB WOOFER CENTER 6CH INPUT OUTPUT LR L R CEN
Inhaltszusammenfassung zur Seite Nr. 16
CONNECTIONS Speaker placement Connecting the speakers Refer to the following diagram when you place the speakers. Speakers Main speaker (R) This unit has been designed to provide the best sound- Center speaker field quality with a 5-speaker system, using main left and Rear speaker (R) right speakers, rear left and right speakers and a center speaker. If you use different brands of speakers (with Subwoofer different tonal qualities) in your system, the tone of a moving human voice and other t
Inhaltszusammenfassung zur Seite Nr. 17
PREPARATION English CONNECTIONS Connections Be sure to connect the left channel (L), right channel (R), “+” (red) and “–” (black) in accordance with the markers on this unit, the speakers, and the speaker cables. If the connections are faulty, no sound will be heard from the speakers, and if the polarity of the speaker connections is incorrect, the sound will be unnatural and lack bass. CAUTION • Use speakers with the specified impedance shown on the rear panel of this unit. • Do not let the b
Inhaltszusammenfassung zur Seite Nr. 18
CONNECTIONS Main A speaker Main B speaker Right Left Right Left 1 2 AUDIO AUDIO VIDEO TUNER SPEAKERS R L R L CLASS 2 WIRING A CD DVD R MAIN L AM ANT B IN D-TV (PLAY) /CBL R MAIN L GND MD /CD-R OUT DIGITAL V-AUX (REC) INPUT 75Ω UNBAL. CD 2 FM MAIN IN ANT REAR VCR MAIN A OR B : 6Ω MIN./SPEAKER (SURROUND) COAXIAL CENTER R L OPTICAL SURROUND OUT DVD 1 SUB MONITOR WOOFER OUT SUB WOOFER CENTER CENTER : 6Ω MIN./SPEAKER REAR : 6Ω MIN./SPEAKER 6CH INPUT OUTPUT 3 4 5 6 Center Subwoofer speaker Right Le
Inhaltszusammenfassung zur Seite Nr. 19
PREPARATION English CONNECTIONS Connecting the power supply Turning on the power cords When all connections are complete, turn on the power of this unit. VOLTAGE SELECTOR 1 VOLUME PRESET/TUNING FM/AM STANDBY EDIT /ON TUNING MODE MEMORY AUTO/MAN`L MONO MAN`L/AUTO FM INPUT MODE 6CH INPUT VOLTAGE SELECTOR SILENT SPEAKERS ON A STEREO PROGRAM A/B/C/D/E PRESET/TUNING CONTROL BASS/TREBLE INPUT OFF B EFFECT NEXT SET MENU PHONES REAR 110V-120V URROUND) L 220V-240V SYSTEM POWER POWER POWER STANDBY POWER N
Inhaltszusammenfassung zur Seite Nr. 20
BASIC SYSTEM SETTINGS The “BASIC” menu allows you to set some of the basic “SOUND” menu parameters with a minimum of effort. If you wish to configure the unit more precisely to suit your listening environment, use the more detailed parameters from the “SOUND” menu instead of those under the “BASIC” menu (See page 38). Altering any parameters in the BASIC menu will reset all parameters in the “SOUND” menu. 4 Press u / d to change the display to the Using the basic menu setting you want to alter.
