Inhaltszusammenfassung zur Seite Nr. 1
Contents
AV Receiver
Before using 2
DTR-7.2
Facilities and connections 8
Instruction Manual
Setup and operation 27
Thank you for purchasing the AV Receiver.
Please read this manual thoroughly before making
Remote controller 56
connections and plugging in the unit. Following the
instructions in this manual will enable you to obtain
optimum performance and listening enjoyment
from your new AV Receiver. Please retain this
manual for future reference.
Appendix 71
Inhaltszusammenfassung zur Seite Nr. 2
WARNING: WARNING AVIS TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, RISK OF ELECTRIC SHOCK RISQUE DE CHOC ELECTRIQUE DO NOT OPEN NE PAS OUVRIR DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated CAUTION: “dangerous voltage” within the product’s enclosure that may be of TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT sufficient magnitude to constitute a risk of
Inhaltszusammenfassung zur Seite Nr. 3
21. Replacement Parts – When replacement parts are required, be FIGURE 1: sure the service technician has used replacement parts specified EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL by the manufacturer or have the same characteristics as the ELECTRICAL CODE, ANSI/NFPA 70 original part. Unauthorized substitutions may result in fire, electric shock, or other hazards. ANTENNA 22. Safety Check – Upon completion of any service or repairs to the LEAD IN WIRE appliance, ask the service technician to
Inhaltszusammenfassung zur Seite Nr. 4
Contents Before using Setup and operation Important Safeguards......................................... 2 Setup menus ..................................................... 27 Navigating through the Setup menu .............................. 27 Precautions ......................................................... 3 Hardware Setup................................................. 29 Contents .............................................................. 4 0. Hardware Setup menu .....................
Inhaltszusammenfassung zur Seite Nr. 5
Contents Enjoying music or videos with the DTR-7.2 ...... 50 Programming the commands of remote controllers for other devices into the Basic operation ............................................................... 50 remote controller ......................................... 64 Temporarily turning off the sound ..................................... 50 Programming procedure ................................................. 64 Adjusting the bass and treble .......................................
Inhaltszusammenfassung zur Seite Nr. 6
HOME THEATER CONTROLLER RC-461M Features Pre Out Terminals for Front L/R, Center, Amplifier Features Surround L/R, Surround back L/R and 100 W×2 (Front)/100 W (Center)/100 W×2 Subwoofer (Surround)/100 W (Surround Back) at 8 Ω , 20Hz-20kHz, 0.08% THD (FTC) FM/AM Tuner Features 6 Channel Amplifier 40 FM/AM random presets Wide Range Amplifier Technology (WRAT) FM auto tuning Linear Optimum Gain Volume Circuitry Other Performance Features 192 kHz/24 Bit D/A Converters (except for Sur
Inhaltszusammenfassung zur Seite Nr. 7
HOME T HEA T ER CONT ROLL ER RC-461M Before using this unit Installing the remote controller batteries Using the remote controller Point the remote controller toward the remote control sensor. The 1. Remove the battery compartment cover by pressing Standby indicator lights up when the unit receives a signal from the and sliding the cover. remote controller. 2. Insert two AA (R6 or UM-3) batteries into the battery Remote control sensor compartment. Carefully follow the polarity diagram DTR-7.2 (p
Inhaltszusammenfassung zur Seite Nr. 8
Front panel facilities Here is an explanation of the controls and displays on the front panel of the DTR-7.2. Front panel See illustration below Display Dimmer Rec Out Zone 2 Of f Standby/On Master Volume Se tup Tun ing Enter Standby Power Return Preset On O f f Direct Stereo Surround THX DSP FM Mode Memory Upsampling A-FO RM Listening Mode Memory Clear Phones Zone 2() GRN Rec() RED Video 5 / Video Cam Input DVD Video 1 Video 2 Video 3 Video 4 Video 5 Tape FM AM Phono CD Audio Selector VCR 1 VCR
Inhaltszusammenfassung zur Seite Nr. 9
Front panel facilities For operational instructions, see page indicated in brackets [ ]. Input source buttons (DVD, Video 1–5, Tape, FM, AM, Phono, and CD) [26, 48, 50, 55] Power switch [26] These buttons are used to select the input source for the main zone. Turns on and off the main power supply for the DTR-7.2. To select the input source for the remote zone (Zone 2) or recording out (Rec Out), first press the Zone 2 or Rec Out button, and then the desired input source button. The input chann
Inhaltszusammenfassung zur Seite Nr. 10
Front panel facilities Return button [27] Listening Mode buttons [51] Press to exit the Main menu level or go back one level up. Press these buttons to select a listening mode for the current input source. Memory button [49] Stereo: Selects for normal stereo output. Surround: Selects for the Dolby Pro Logic, Neo:6, Dolby Digital, This button is used to assign the radio station that is currently tuned in to a preset channel or delete a previously preset station. or DTS listening modes. THX: Selec
Inhaltszusammenfassung zur Seite Nr. 11
Remote controller AUDIO/TV/VCR button VOL button [50, 53] AUDIO/A: For selecting the audio input signal. The setting changes For adjusting the volume. from “Auto” to “Multich” to “Analog” and back each time this button is pressed. [53] TEST/MENU button TV/VCR: Must be preprogrammed for use in the TV and VCR TEST: Outputs a test tone for setting speaker levels. modes. [63] Use this button in conjunction with the LEVEL / and CH SEL buttons to calibrate the speakers levels without entering the Set
Inhaltszusammenfassung zur Seite Nr. 12
Rear panel facilities Here is an explanation of the terminals found on the rear of the DTR- • Insert all plugs and connectors securely. Improper 7.2 and how they are used. Before connecting your audio and video connections can result in noise, poor performance, or components, be sure to read this section carefully and then proceed damage to the equipment. to the explanations on how to connect each individual component Improper connection (see page 16). • Be sure to always refer to the instructio
Inhaltszusammenfassung zur Seite Nr. 13
Rear panel facilities PRE OUT COMPONENT VIDEO INPUT/OUTPUT These jacks are for connecting auxiliary power amplifier. If your DVD player or other device has component video Using auxiliary power amplifiers allows you to listen at louder connectors, be sure to connect them to these component video volumes than with the DTR-7.2 alone. If power amplifiers are used, connectors on the DTR-7.2. The DTR-7.2 has two component video connect each speaker to the corresponding power amplifier. input connecto
Inhaltszusammenfassung zur Seite Nr. 14
Rear panel facilities AC OUTLETS REMOTE CONTROL The DTR-7.2 is supplied with AC mains outlets for connecting the The terminal on the DTR-7.2 is for connecting other Integra/ power cords from other devices so that their power is supplied Onkyo components equipped with the same terminal. When a through the DTR-7.2. By doing this, you can use the Standby/On component is -connected, you can point the remote controller button on the DTR-7.2 to turn on and off the connected devices as supplied with
Inhaltszusammenfassung zur Seite Nr. 15
Rear panel facilities IR IN/OUT GND If the DTR-7.2 is located inside a rack or cabinet that will not allow Use this GND terminal for connecting the ground (or earth) wire if a infrared beams to reach the IR sensor, you will need to connect a turntable is connected. Refer to “Connecting a turntable” on page 16. remote sensor to IR IN input to be able to use the remote controller. Then install the remote sensor in an unblocked location where you can easily point the remote controller. Using a mini
Inhaltszusammenfassung zur Seite Nr. 16
Connections Here is an explanation of how to connect the main components to the Audio connection cable DTR-7.2 in the standard manner. There are many ways that any one Left (white) L component can be connected, and it is up to you to decide which method best fits your situation. The directions given here are only one option and should only be thought of as such. It is best to fully understand the nature of each connector and terminal as well as each Right (red) R of your components and their fea
Inhaltszusammenfassung zur Seite Nr. 17
Connections : Signal flow Video connection cable Component video connection cable Audio connection cable PR PR Left (white) L PB PB S video connection cable Y Y Right (red) R Digital audio input (optical) Digital audio output (coaxial) S Video input Digital audio output (coaxial) Video input R (red) Analog audio output L (white) DIGITAL PRE COMPONENT R (red) AUDIO VIDEO S VIDEO Analog audio OUTPUT R VIDEO TENNA FRONT OUTPUT MONITOR input OUT Video output OPT Y L R SUB AM ZONE 2 PB DIGITAL OU
Inhaltszusammenfassung zur Seite Nr. 18
Connections DIGITAL PRE COMPONENT AUDIO VIDEO S VIDEO OUTPUT TENNA R VIDEO FRONT 7. Settop box, video camera MONITOR OUTPUT OPT OUT Y (VIDEO 3) R L SUB AM OUT ZONE 2 PB DIGITAL INPUT R (red) COAX SURR S Video input 1 IN DVD PR SURR INPUT 1 Analog audio BACK Video input FM 2 OUT Y 75 output L (white) VIDEO 1 FRONT 3 IN PB DIO L (white) Analog audio L OPT Video output SUB input 1 PH OUT PR VIDEO 2 INPUT 2 SURR S Video output 2 CD IN Y R (red) SURR OUT BACK 3 IN VIDEO 3 PB Digital audio output (op
Inhaltszusammenfassung zur Seite Nr. 19
Connections 9. TV monitor or projector Y (MONITOR OUT) Component video input PB PR DIGITAL PRE COMPONENT Video input AUDIO VIDEO S VIDEO OUTPUT R VIDEO TENNA FRONT MONITOR OUTPUT OUT OPT Y 8. Satellite tuner or television S Video input R L (VIDEO 4) SUB AM OUT ZONE 2 PB DIGITAL INPUT COAX SURR Digital audio output 1 IN DVD PR (optical) SURR INPUT 1 BACK FM 2 OUT Y 75 VIDEO 1 R (red) FRONT 3 IN PB DIO L OPT SUB Analog audio 1 PH OUT PR output VIDEO 2 L (white) SURR INPUT 2 2 Y CD IN Video outpu
Inhaltszusammenfassung zur Seite Nr. 20
Connecting speakers Before connecting the speakers, place them correctly by consulting Surround back speaker/Surround back left and right speakers the instruction manuals that came with them. • Place these speakers behind the listener so that the angle For surround playback, the configuration and placement of your between each speaker and the listener is approximately 15 speakers are very important. degrees. For THX surround EX playback, we recommend that you use a • Place these speakers so that
