Bedienungsanleitung Talk electronic Cyclone

Inhaltszusammenfassung zur Seite Nr. 1

Talk Electronics
User Manual
TALK ELECTRONICS LTD. UNIT 3 IMAGE HOUSE 326 MOLESEY ROAD HERSHAM SURREY KT12 3PD ENGLAND
TEL: +44 (0)1276 709966 FAX: +44 (0)1276 682843 E-MAIL: info@talkelectronics.com www.talkelectronics.com

Inhaltszusammenfassung zur Seite Nr. 2

Talk Electronics Cyclone User Manual INTRODUCTION with water. Keep it away from potted plants to avoid those all-too-common watering accidents! To clean Thank you for choosing a Talk Electronics the amplifier’s case disconnect it from the wall Cyclone Integrated amplifier. We are socket and wipe it with a barely damp, lint-free cloth confident that it will provide you with many or chamois leather, stubborn marks may be removed using ‘White spirit’ however be careful not to remove years of musica

Inhaltszusammenfassung zur Seite Nr. 3

SIGNAL CONNECTIONS CD: select this button to listen to your CD player or any other source you have connected to the CD The Cyclone integrated amplifiers were developed input. using high quality interconnects and speaker cables Tuner: select this button to listen to your tuner or from Merlin Cables, these allow the amplifiers to any other source you have connected to the Tuner operate as intended and deliver their optimum input. performance. We strongly recommend that you use Aux: select this bu

Inhaltszusammenfassung zur Seite Nr. 4

one and record on the other. Whilst Tape 1’s output The output sockets are marked LEFT and RIGHT to is permantly connected to Tape 2’s record out indicate which channel is which. Each channel’s red sockets you will need to select Tape 2 in the record terminal is its positive connection and the black mode to send the output of tape 2 to the record terminal is the negative. There are two sets of each sockets of Tape 1. to facilitate bi-wiring. Cyclone amplifiers are suitable for use with most REMO

Inhaltszusammenfassung zur Seite Nr. 5

SPECIFICATION CYCLONE 1.1 CYCLONE 2.1 Power output 20-20K 8 Ohms 70W 100W Distortion 1KHz 10W 8Ohms <=0.01% <=0.008% S/N Ratio <= -80dB A weighted <= -80dB A weighted Residual noise <= -62dB unweighted <= -62dB unweighted Frequency response 5-100KHz +/- 3dB +/- 3dB Dimensions H.W.D in mm excluding connections 93x430x300 93x430x300 Weight packed 8.90kg 8.90kg un-packed 7.50kg 7.50kg Talk Electronics’ policy of continued research and development means that the above specification may change withou