Inhaltszusammenfassung zur Seite Nr. 1
Inhaltszusammenfassung zur Seite Nr. 2
CONTENTS SAFETY INFORMATION………………………………………………………………………………………………………………… 1 IMPORTANT SAFETY INSTRUCTIONS………………………………………………………………………………………………. 2 REMOTE CONTROLLER……………………………………………………………………………………………………………….. 3 LOUDSPEAKER POSITIONING……………………………………………………………………………………………………….. 4 FRONT PANEL INFORMATION………………………………………………………………………………………………………… 5 REMOTE CONTROL INFORMATION…………………………………………………………………………………………………. 6 REAR PANEL INFORMAT
Inhaltszusammenfassung zur Seite Nr. 3
SAFETY INFORMATION Caution: - To reduce the risk of electric shock, do not remove Cover (or back) - No user-serviceable parts inside. - Refer servicing to qualified service personnel. - Do not expose this appliance to rain or moisture This lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninstalled “dangerous voltage” within the product’s en
Inhaltszusammenfassung zur Seite Nr. 4
IMPORTANT SAFETY INSTRUCTIONS Caution: Read This Before Operating Your Unit. 1. READ AND FOLLOW INSTRUCTIONS: All the safety and operation instructions should be read before the product is operated. Follow all operation instructions within this manual. 2. RETAIN INSTRUCTIONS: The safety and operation instructions should be retained for future reference. 3. HEED WARNINGS: Comply with all warnings on the product and in the operation instructions.
Inhaltszusammenfassung zur Seite Nr. 5
IMPORTANT SAFETY INSTRUCTION 13. SERVICING: Do not attempt to service this product yourself as removing cover may expose you to dangerous voltages or other hazards. Refer all servicing to qualified service personnel. 14. LIGHTNING: For added protection for this product during a thunderstorm, or when it is left unattended and unused for long period of time, unplug it from the wall outlet and disconnect the antenna or cable system. Thi
Inhaltszusammenfassung zur Seite Nr. 6
REMOTE CONTROLLER BATTERY INSTALLATION By using the provided remote control unit, the receiver can be controlled from your listening position. To use the remote control unit, point it at the REMOTE SENSOR window of the receiver. Notes: - Even if the remote control unit is operated within the effective range, remote control operation may be impossible if there are any obstacles between the unit and the remote control. - If the rem
Inhaltszusammenfassung zur Seite Nr. 7
Ⅵ · Ⅶ Ⅹ Ⅹ · Ⅷ Ⅷ Ⅷ · Ⅸ Ⅵ Ⅵ · Ⅹ Ⅳ Ⅳ Ⅱ Ⅱ 0 0 0 FRONT PANEL INFORMATION 1 2 3 4 5 6 7 8 9 10 0 11 12 13 14 15 16 17 18 19 20 21 22 1. POWER ON/OFF Push this button to turn the unit into standby mode, push it again to turn off the unit. 2. Stereo Direct Press this button ,the unit will change to stereo direct output mode, all the signal through this unit will not be amplify. 3. DVD/CD Press to active the DVD inputs 4. AUX1/AUX2 P
Inhaltszusammenfassung zur Seite Nr. 8
REMOTE CONTROL INFORMATION 5. Speaker A+B Press this button, the speaker A&B outputs’s speaker will work together.. 6. Memory Press it to store the broadcast station as a preset 7. APS In tuner mode, press this button to allocate and memorize radio station automatically. 8. PTY Search No PTY inforamtion would be displayed. 9. ST/Mono Press this button to alternate between Stereo and Mono mode when listen to FM broadcast. 10. Station
Inhaltszusammenfassung zur Seite Nr. 9
REAR PANEL INFORMATION 1. Antenna: Connection terminal for AM& FM 2. Mains switch Use to interrupt the mains voltage 3. RS232 port 4. Analog audio In/Out - TAPE OUT: Connect to the line input terminals on the TAPE DECK - AUX IN: Connect to the line output of an external player. -TAPE IN: Connect to the line output terminals on the TAPE DECK. - DVD IN: Connect to the line output terminals on the DVD player - MD IN: Connect to the li
Inhaltszusammenfassung zur Seite Nr. 10
CONNECTION LOUDSPEAKER CONNECTIONS Caution: To avoid damaging the speakers with a sudden high-level signal, be sure to switch the power off before connecting the speakers. l Check the impedance of your speakers. Connect speaker with an impedance of 8 ohms or more. The amplifier’s red speaker terminals are the + (positive) terminals and the black terminals are the – (negative) terminals. l The + side of the speaker
Inhaltszusammenfassung zur Seite Nr. 11
CONNECTION AUDIO CONNECTIONS Note: Do not plug in the mains power lead or turn on the unit before all connections have been made. Connect to source equipment using phono cables (stereo 2RCA-2RCA). DIGITAL CONNECTIONS Two types of digital audio connections can be made to this unit, optical and coaxial. 9
Inhaltszusammenfassung zur Seite Nr. 12
CONNECTION FRONT INPUT CONNECTIONS The front panel iPod input is for temporary connections to the iPod player. 10
Inhaltszusammenfassung zur Seite Nr. 13
CONNECTIONS AERIAL CONNECTIONS FM aerial Connect an aerial to the FM 75 ohm socket (a simple wire aerial is supplied for temporary use). Extend the lead and move the aerial around until you get the best reception. For continued use, we strongly recommended using a 75 ohm outdoor FM aerial. AM loop aerial Connect each end of the single length antenna to the antenna terminals. Place the antenna as far from the main sy
Inhaltszusammenfassung zur Seite Nr. 14
BASIC OPERATION PHONES jack For private listening, insert optional (not included) headphones (1/4-inch plug) into the PHONES jack, and then the center and surround speaker will be cut automatically. iPod in jack The input ports are for iPod player. It can connect a iPod player directly or connect to a iPod docking. Balance/Bass/Treble control knob 1. Press the Main Power ON/OFF Switch on the rear panel BALANCE control i
Inhaltszusammenfassung zur Seite Nr. 15
BASIC OPERATION Stereo Radio Operations FM stereo broadcasts are received in stereo and the “ ” Automatic Tuning indicator lights on the display. 1. Press the Main Power On/Off switch on the rear panel Mono first, then press the Power On/Off button on the front To compensate for weak FM stereo reception, select this panel to turn this unit on. mode. Reception will now be forced monaural, reducing 2. Press the Tuner button on the
Inhaltszusammenfassung zur Seite Nr. 16
RADIO DATA SYSTEM (Optional) RADIO DATA SYSTEM (RDS) RDS is a method for the transmission of additional d) RT (Radio text) information from local Radio Stations. It can only operated in FM mode. For example, name of the station broadcasting, Press “DISPLAY” on remote control until “RT” appears. name of the program or the type of program will be shown on Some Text messages will be shown. the multi-function display. Note
Inhaltszusammenfassung zur Seite Nr. 17
TROUBLESHOOTING To determine any problem with your receiver, always check the most obvious possible causes first. If any problem still remains after your having checked the items below, consult your nearest dealer. Problem Probable Cause Suggestion Amplifier When listening to the music in stereo. Speakers are connected wrong. After checking, if neede
Inhaltszusammenfassung zur Seite Nr. 18
SPECIFICATIONS Max Power Output: 300W×2CH (RMS,THD=0.25%,8 ohm)(20Hz-20kHz) A Speaker : 4～8 ohm B Speaker: 4～8 ohm A+B Speaker 8 ohm Total Harmonic Distortion: <0.005 (Vin=200mV, 1W Power output) Inter-modulation distortion: <0.008 requency Response: +/- 0.5dB, 20Hz-22kHz Signal/Noise ratio: 110 dB(Digital In) Signal/Noise ratio: 110 dB(Analog In) Channel Separation: >70dB Audio Analogue input Senstivity/Impedance:
