Bedienungsanleitung PYLE Audio PYLE PRO amplifier PT-1100/PT3300

Inhaltszusammenfassung zur Seite Nr. 1

OPERATING MANUAL
PDF created with pdfFactory trial version www.pdffactory.com

Inhaltszusammenfassung zur Seite Nr. 2

Foreword Thank you for purchasing this fine PYLE PRO amplifier. Please read this operating instructions carefully before using. It will acquaint you fully with all its features and help you enjoy your time. Precautions The product adopts the most advanced digital technique in the world. It is 4 channels with its high power output, so to speak, the real acoustic centre of your family movie 1.Power source-The unit should be connected toa power supply AC~110/60Hz, theatre. It is designed to be mult

Inhaltszusammenfassung zur Seite Nr. 3

HYBRID AMPLIFIER Audio Digital Amplifier 1 Main Channel Power Output PMPO,8 Ohms, 1KHz test 1000WX2 3000WX2 2 THD(1KHz) <1% <1% 3 Normal Load Impedance 8 Ohm 8 Ohm 4 Input Sensitivity Impedance 400mV/33k Ohm 400mV/33k Ohm CD/DVD AUX TAPE TUNER 5 Microphone 6mV/600 Ohm 6mV/600 Ohm 6 Signal to Noise Ratio 78dB 78dB Pure Amplifier 7 76dB 76dB 8 Frequency Range Frequency Response(20Hz-20KHz) ±2dB ±2dB 9 ±10dB ±10dB Tone Characteristic(100Hz-10KHz) 10 Power Requirements AC~110V/60Hz AC~220V50Hz 11 48

Inhaltszusammenfassung zur Seite Nr. 4

1、SPEAKER Speaker（） A/B Selector 2、SPEAKER 1 ENGINEERED IN JAPAN Speaker（） A+B Selector DESIGNEDIN THE USA 2 WARNI NG 3、DVD/CD 3 DVD/CD Selector - 4 4、AUX 5 AUX Selector 6 5、TUNER TUNER Selector 6、TAPE 7 TAPE Selector 8 7、VOL+ Master Volume Up 8、VOL- Master Volume Down Remote Controller Operation 1. Remote controller should be operated within6 meter and the scope of 30 in front of receiver. 2. Make sure that there is no big obstacle between remote controller and machine. 3. Remote sensor should

Inhaltszusammenfassung zur Seite Nr. 5

2 MIC INPUTS ENGINE ERED IN JAPAN DESIGNED IN THEUSA WARNING 1. Make sure that all connections are properly connected and the main - volume is set to minimum level before turning on the unit. 2. When more than one pair of speakers are used, (specially the main speaker output) make sure that the speakers used are of the same wattage and impedance, otherwise the unit may be damaged under high power or long term operation. TAPE 3. To avoid humming sounds and unwanted noise, make sure that all the w