Inhaltszusammenfassung zur Seite Nr. 1
R
EVOLUTION OF POWER
SUPER SPORT
AT-SERIES
AMPLIFIERS
AT1000 / AT1500 / AT1200 / AT2000.1 / AT3000.1
Inhaltszusammenfassung zur Seite Nr. 2
SUPER SPORT AT-SERIES AMPLIFIERS Autotek is proud to introduce the finest high end car audio products available and would like to thank you for your continued support. The Super Sport AT-Series amplifiers have been designed to a very high level of performance, with features unavailable in any other products. All of the amplifiers have variable crossovers built in, with added touches such as High Level Inputs, Bass Equalization, Wide Range Crossover controls with High Pass, Low Pass and
Inhaltszusammenfassung zur Seite Nr. 3
WIRE GAUGE GENERAL INSTALLATION PROCEDURE System Design The success of any car stereo system relies on several factors, such as the system design, execution of the installation, and system setup. Please remember that any system is only as good as its weakest link. Please remember that higher power systems are not necessarily useful purely for high sound pressure levels, but also to establish a headroom capability, to reproduce musical peaks cleanly without distortion. Lower power amplifiers w
Inhaltszusammenfassung zur Seite Nr. 4
AMPLIFIER FEATURE DESCRIPTIONS SUPER SPORT AT-SERIES AMPLIFIERS: ! Each model is capable of 4 & 2-Ohms stereo per channel, or 4-Ohms mono bridged ! All Autotek amplifiers feature a comprehensive diagnostic system, with speaker lead operation except the mono amps which are capable of 4, 2 and 1-Ohm loads. short circuit, and amplifier DC faults indicated by the red “PROTECT” LED. ! Tri-Mode operation with any stereo pair of amplifier channels is possible, as with all ! CAUTION: DO NOT OPERATE
Inhaltszusammenfassung zur Seite Nr. 5
L L LEVEL BASS EQ HPF LPF X-OVER MODE + - gnd + - HI INPUT 5V 0.2V 0dB 12dB 60Hz 1.2KHz 30Hz 250Hz FULL LPF HPF MONO STEREO R R LINE OUT LINE INPUT L L LEVEL BASS EQ HPF LPF X-OVER MODE + - gnd + - HI INPUT 5V 0.2V 0dB 12dB 60Hz 1.2KHz 30Hz 250Hz FULL LPF HPF MONO STEREO R R LINE OUT LINE INPUT AT1000 / AT1500 / 2 CHANNEL AMPLIFIER APPLICATIONS
Inhaltszusammenfassung zur Seite Nr. 6
L L L L LEVEL BASS EQ HPF LPF X-OVER MODE LEVEL BASS EQ HPF LPF X-OVER MODE + - gnd + - + - gnd + - HI INPUT HI INPUT 5V 0.2V 0dB 12dB 60Hz 1.2KHz 30Hz 250Hz FULL LPF HPF MONO STEREO 5V 0.2V 0dB 12dB 60Hz 1.2KHz 30Hz 250Hz FULL LPF HPF MONO STEREO R R R R LINE OUT LINE INPUT LINE OUT LINE INPUT AT1000 / AT1500 2-CHANNEL AMPLIFIER APPLICATIONS
Inhaltszusammenfassung zur Seite Nr. 7
+ - + - + - + - + - + - + - + - INPUT OUTPUT INPUT MODE X-OVER X-OVER CH1 CH2 CH3 CH4 CH1 CH3 2 3 4 + - GND - + + - GND - + LPF HPF F ULL FULL HPF L PF LPF HPF BASS EQ LEVEL LEVEL BASS EQ HPF LPF CH2 CH4 30Hz 250Hz 60Hz 1.2KHz 0dB 12dB 5V 0.2v 5V 0.2v 0dB 12dB 60Hz 1.2KHz 30Hz 250Hz CHANNEL 1 / 2 4CH MONO MIX CHANNEL 3 / 4 INPUT OUTPUT INPUT M
Inhaltszusammenfassung zur Seite Nr. 8
REMOTE OUTPUT INPUT BASS SUB LOW CONTROL BOOST SONIC PASS LEVEL POWER L L PROTECT 0dB 12dB 15Hz 55Hz 40Hz 150Hz 6V 0.2V R R AT2000.1 / AT3000.1 / MONO AMPLIFIER APPLICATIONS Basic application These sub bass amplifiers can be used in any of the bi-amplification systems SUBSONIC:15 Hz to 55 Hz described in this manual, replacing the 2 channel amplifiers as per the BASS EQ: 0 to +12dB illustration
Inhaltszusammenfassung zur Seite Nr. 9
7 .1 .1 15
Inhaltszusammenfassung zur Seite Nr. 10
SETTING UP SYSTEMS AFTER INSTALLATION FOR BEST PERFORMANCE AT1000 / AT1500 / AT1200 General: At this point you are ready to get more specific on the settings for your amplifier. High Pass: -When in Hi Pass operation, this setting acts as a low frequency cut off for your system reproduction. The point that you set it at cuts off any frequencies from reproduction beyond this point. The 12 o’clock position is a great starting point. EXAMPLE: If you adjust the High Pass to 100Hz, the amplifier will
Inhaltszusammenfassung zur Seite Nr. 11
TROUBLESHOOTING A SYSTEM The key to finding the problem in a misbehaving sound system is to isolate parts of that system in a logical fashion to track down the fault. Description of the PROTECT system built into all Autotek amplifiers The diagnostic system will shut down the amplifier, until reset by turning the head unit off, and back on. This state of affairs will be indicated by the front panel PROTECT LED lighting up under the following conditions: 1 - A sort circuit on the loudspeaker lea
Inhaltszusammenfassung zur Seite Nr. 12
SUPER SPORT AT-SERIES Maxxsonics Limited Warranty As the manufacturer of Maxxsonics, Autotek, Crunch, MB Quart and Hifonics car audio products Maxxsonics USA Inc. Warrants to the original consumer purchaser the amplifier to be free from defects in material and workmanship for one (1) Year from date of purchase. All other parts and accessories of the system are warrantied to be free from defects in material and workmanship for one (1) year from date of purchase. Maxxsonics will repair or replac
Inhaltszusammenfassung zur Seite Nr. 13
PART#S608
