Bedienungsanleitung Tannoy HITS100

Inhaltszusammenfassung zur Seite Nr. 1

6481 0479
HTS Manual 3/3/06 14:50 Page 1
C M Y CM MY CY CMY K
&
Tannoy has a policy of continuous improvement and this specification sheet provides the latest information at the time of printing.
All specifications may be subject to further change. Please contact the Tannoy website for the latest information.
The Tannoy HTS100 and HTS200 speaker systems and the Tannoy HTS100/200 subwoofer are all designed by Tannoy Ltd and
manufactured for Tannoy Ltd to rigid specifications in accordance with

Inhaltszusammenfassung zur Seite Nr. 2

HTS Manual 3/3/06 14:50 Page 2 C M Y CM MY CY CMY K & SET UP GUIDE ELECTRICAL REQUIREMENTS IMPORTANT SAFETY INSTRUCTIONS Check that the voltage rating displayed on the rear panel is correct for your area before connecting. If it is 1. Read these instructions. incorrect, set with the voltage selection switch, ensuring protective cover is replaced and the appropriate 2. Keep these instructions. fuse used (see specification). 3. Heed all warnings. EUROPEAN MODELS A mains cable is supplied with an

Inhaltszusammenfassung zur Seite Nr. 3

HTS Manual 3/3/06 14:50 Page 3 C M Y CM MY CY CMY K HTS SET UP GUIDE In addition, HTS systems have a subwoofer which provides ASSEMBLING THE CENTRE & SATELLITE WALL BRACKETS very low frequency sounds and special effects. The This high performance Tannoy HTS 5.1 home cinema system subwoofer supports low frequencies for all 5 audio channels. Fit the wall brackets to the smaller satellite speakers if you • Fit 2 halves of 2 brackets to the centre speaker with the has been built and tested with ca

Inhaltszusammenfassung zur Seite Nr. 4

HTS Manual 3/3/06 14:50 Page 4 C M Y CM MY CY CMY K • Position the satellite or centre speaker (with half the wall • Check the alignment of the slot in the top of the tube bracket(s) fitted) against the other half of the wall bracket (pointing backwards) and tighten the screws. already fitted to the wall. Line up the brackets so that the • Place the satellite and stand bracket onto the top of the long screw.pin can be inserted vertically from below the pole taking care to align the slot in th

Inhaltszusammenfassung zur Seite Nr. 5

) z H ( E R M E U V HTS Manual 3/3/06 14:50 Page 5 C M Y CM MY CY CMY K AV RECEIVER/DECODER OUTPUT PANEL PLACING THE CENTRE SPEAKER CONNECTING THE HTS SPEAKERS TO YOUR A/V SUB OUT FRONT REAR CENTRE REAR FRONT RECEIVER OR AMPLIFER LEFT LEFT RIGHT RIGHT Locate the special Centre Speaker performance platform _ _ _ _ _ + + + + + within the packaging materials. Connect the speakers to the AV Home Cinema receiver or separate amplifier terminals as follows: Place the Centre Speaker onto the platform a

Inhaltszusammenfassung zur Seite Nr. 6

HTS Manual 3/3/06 14:50 Page 6 C M Y CM MY CY CMY K CENTRE & SATELLITE SPEAKER PERFORMANCE Recommended amplifier power 25 - 100 Watts Maximum Sensitivity (2.83Volts @ 1m) 87dB Nominal impedance Centre 8 ohm Satellite 6 ohm ALTERNATIVE METHODS OF SUBWOOFER • Connect the HTS subwoofer to a convenient mains socket Frequency response (-6dB) 100Hz to 40kHz (Centre & Satellites) CONNECTION using the lead and plug supplied. Drivers HF: 19mm (3/4inch) titanium WideBand™ dome, with neodymium magnet syst