Inhaltszusammenfassung zur Seite Nr. 1
SPECIFICATIONS
CD player section General
Power output : 28 W (14 W + 14 W) at 4 Ω (Max.)
Type : Compact disc player 20 W (10 W + 10 W) at 4 Ω (10% THD)
Signal detection Input terminals : AUX IN (300 mV/47 kΩ)
system : Non-contact optical pickup Output terminals : PHONES (Output level: 0-15 mW/ch, 32 Ω, Matching
Number of channels : 2 channels
impedance: 16 Ω - 1 kΩ)
Frequency response : 20 Hz - 20,000 Hz SPEAKER (Matching impedance 4 Ω - 16 Ω)
Signal-to-noise ratio : 90 dB Power requirements : A
Inhaltszusammenfassung zur Seite Nr. 2
Caution – switch! REPRODUCTION OF LABELS AND THEIR LOCATION Disconnect the mains plug to shut the power off completely. The switch in any position does not disconnect the mains line. The power can be remote controlled. CAUTION To reduce the risk of electrical shocks, fire, etc.: 1.Do not remove screws, covers or cabinet. 2.Do not expose this appliance to rain or moisture. WARNING The unit contains a built-in lithium battery for memory back-up that must only be replaced by suitably qualified se
Inhaltszusammenfassung zur Seite Nr. 3
SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been disigned and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connections (including the mains plug, extension leads and inter
Inhaltszusammenfassung zur Seite Nr. 4
Thank you for purchasing this JVC product. Please read these instructions carefully before starting operation to be sure to obtain optimum performance and a longer service life from the unit. CONTENTS Features ..................................................................... 1 Handling cassette tapes ......................................... 10 Handling precautions ............................................... 1 Cassette playback ................................................... 10 Con
Inhaltszusammenfassung zur Seite Nr. 5
CONNECTIONS c Do not switch the power on until all connections are completed. Antenna connection and adjustment c AM (MW/LW) loop antenna adjustment R L AM (MW/LW)loop antenna (provided) RIGHT LEFT AM LOOP AM EXT FM îAC IN COAXIAL 75Ω — 12V Insert in the direction of the arrow. DC IN c Keep the loop antenna away from the unit and install it so that the best reception is obtained. (Do not leave the antenna wire in a bundle.) c FM antenna connections and adjustments R L FM wire antenna (provi
Inhaltszusammenfassung zur Seite Nr. 6
Speaker cord connection 23 1 R L RIGHT LEFT Connect the black cord to the á terminal. îAC IN Right speaker (rear side) Left speaker (rear side) — 12V Speaker cord DC IN RIGHT LEFT c Connec the cord from the speaker on the left to the (LEFT) terminal and the cord from the speaker on the right to the (RIGHT) terminals. Black c The speaker grilles can be removed. c When removing. 1. Insert your fingers at the top and pull towards you. 2. Also pull the bottom towards you. c Attaching the speaker g
Inhaltszusammenfassung zur Seite Nr. 7
POWER SUPPLY A. Connection of AC power cord c Connect the AC power cord after all other connections have been made. R L RIGHT LEFT îAC IN CAUTIONS: Power cord îAC IN 1.ONLY USE WITH JVC POWER CORD PROVIDED WITH THIS UNIT TO AVOID MALFUNCTION OR DAMAGE TO THE UNIT. 2.BE SURE TO UNPLUG THE POWER CORD FROM THE OUT- LET WHEN GOING OUT OR WHEN THE UNIT IS NOT IN USE 12V DC IN FOR AN EXTENDED PERIOD OF TIME. B. Operation on car battery (DC 12 V) R L RIGHT LEFT Ù To car’s cigarette lighter socket (12
Inhaltszusammenfassung zur Seite Nr. 8
G G O O J J NAMES OF PARTS AND THEIR FUNCTIONS CD player/General section Front Top PHONES ~Ù! Ú @ Û Ú 1 23 STANDBY VOLUME AUX 1 2 3 4 5 8 9 10 11 12 13 14 15 6 7 MICRO COMPONENT SYSTEM UX-T550 PROGRAM RANDOM ALL OVER COMPACT DIGITAL AUDIO # AUTO TAPE SELECTOR 4 56 7 AUTO REVERSE ACTIVE HYPER TIMER/SNOOZE BASS PRO OPEN Ü I CLOCK ONE TOUCH BAND REC CD TAPE TUNER $Ý% @ VOLUME buttons $ CD operations buttons ~ button and power STANDBY indicator + : Use to increase the volume. CD searc
Inhaltszusammenfassung zur Seite Nr. 9
G O J REMOTE CONTROL UNIT Preparation before use c Battery replacement c Installing batteries in the remote control unit When the remote control operation becomes unstable or the distance 1. Remove the battery cover from the back of the remote control unit. from which remote control is possible decreases, replace the batter- 2. Insert two “R6/AA (15F)” size batteries. ies. c Insert the batteries with the » and á terminals matching the indication inside the battery compartment. Using the remote c
Inhaltszusammenfassung zur Seite Nr. 10
One touch operation (COMPU PLAY) Even when the power is set to STANDBY, pressing the button shown below switches on the power and selects the source. Function mode Operations When this button is pressed with a CD loaded, CD playback begins. CD CD When this button is pressed with a tape loaded, tape playback begins. TAPE TAPE BAND When this button is pressed, the tuner is engaged. TUNER TUNER AUX AUX A sound source connected to the AUX terminal can be engaged. Notes: c When switching off the powe
Inhaltszusammenfassung zur Seite Nr. 11
G G O O J J PLAYING CDs Playing an entire CD The following example of playing an entire CD assumes a CD with 12 tracks and a total playing time of 48 minutes 57 seconds. Operate in the order shown STANDBY COMPACT VOLUME DIGITAL AUDIO Ù AUX Ú MICRO COMPONENT SYSTEM UX-T550 AUTO TAPE SELECTOR ACTIVE HYPER TIMER/SNOOZE BASS PRO OPEN I CLOCK ONE TOUCH BAND REC AUTO REVERSE TAPE TUNER CD !~ ~ Press to open the CD holder. c As tracks are played, their track numbers go out one by one. Ù
Inhaltszusammenfassung zur Seite Nr. 12
Programmed play (using the remote control unit) c Up to 20 tracks can be programmed to be played in any required order. The total playing time of programmed tracks is displayed (up to 99 minutes, 59 seconds). (Example: When programming the 2nd track to be played first, and the 6th track next, then the 12th track, etc.) To designate the 2nd track. ~ Ù
! Ú
C D 2 PROGRAM 2 PROGRAM PROGRAM @ Û
To designate the 12th track. C D 6 +10 2 2 6 2 6 12 PROGRAM PROGRAM The total playback time of programme
Inhaltszusammenfassung zur Seite Nr. 13
G O J HANDLING CASSETTE TAPES Cassette tapes Cassette loading 1. Loose tape may cause trouble. Using a pencil or like object, gently 1. Press the eject (0) button to open the cassette holder. tighten the tape as shown. 2. Load a cassette as shown. 2. To prevent recordings from being erased accidentally, remove the 3. Close the cassette holder by pressing it gently. Listen for the click tab(s) with a screwdriver, etc. Reseal the slots with adhesive tape to indicating that the holder is securely s
Inhaltszusammenfassung zur Seite Nr. 14
G G O O J J RADIO RECEPTION Operate in the order shown STEREO AUTO/MONO button STANDBY VOLUME 12 3 AUX SLEEP 4 5 6 Ú ! ACTIVE HYPER TIMER/SNOOZE BASS PRO 7 8 9 DISPLAY OPEN I CLOCK AUTO STEREO 10 +10 PRESET AUTO/MONO MICRO COMPONENT SYSTEM UX-T550 ONE TOUCH BAND REC TAPE TUNER C D TAPE TUNER CD AUX BAND AUTO TAPE SELECTOR REVERSE MODE REW MULTI CONTROL FF ~ Ù BEAT CUT PROGRAM RANDOM REPEAT ~ Press the TUNER/BAND button. Ù Select the band. ! Tune to the required station. c T
Inhaltszusammenfassung zur Seite Nr. 15
G G O O J J RECORDING c During recording, the ALC (Automatic Level Control) circuit auto- Note: matically optimizes the recording level, so manual recording level This unit has recording characteristics suitable for adjustment is unnecessary. normal and CrO2 tapes. Normal and CrO2 tapes c Check that the safety tab on the cassette tape is not broken off. have different characteristics from metal tapes. Synchronized recording with the CD player c In this system, the CD player starts play when the
Inhaltszusammenfassung zur Seite Nr. 16
G G G O O O J J J BEAT CUT button (using the remote control unit) When recording an AM broadcast, beats may be produced which are Erasing not heard when listening to the broadcast. In such case, set this button A recorded tape can be erased by recording new material over the pre- after setting the deck to the record mode so that the beats are elimi- vious material. nated. Normally set this button to “CUT-1”. To erase a tape without making a new recording... 1. Press the TAPE (23) button to set t
Inhaltszusammenfassung zur Seite Nr. 17
G G G G G G O O O O O O J J J J J J TIMER OPERATIONS Setting the timer c The current time must be set before the timer can be used. ~ Press the TIMER/SNOOZE button for 2 seconds or more. ON TIMER/SNOOZE Within the 30 sec. Ù Set the start time. (Example: To set the timer to 12: 15.) ON ON TIMER/SNOOZE ON OFF TIMER/SNOOZE c Press to set the start time. ! Set the stop time. (Example: To set the timer stop timer to 13: 15.) OFF OFF TIMER/SNOOZE OFF TIMER/SNOOZE c Press to set the timer off time. Ú S
Inhaltszusammenfassung zur Seite Nr. 18
G G O O J J Timer recording of broadcast c The current time must be set before the timer can be used. c Make sure that the safety tabs of the cassette have not been broken off. Operations STANDBY ~ COMPACT VOLUME DIGITAL AUDIO AUX @ MICRO COMPONENT SYSTEM UX-T550 AUTO TAPE SELECTOR ACTIVE HYPER TIMER/SNOOZE BASS PRO OPEN I CLOCK ! ONE TOUCH BAND REC Ù AUTO REVERSE CD TAPE TUNER Ú c To cancel timer operation ~ Set the button to ON. Press the TIMER/SNOOZE button for more than 2 se
Inhaltszusammenfassung zur Seite Nr. 19
Sleep timer operations (using the remote control unit) A. Use this when you want to fall asleep while listening to a tape, B. To fall asleep while listening to a tape, broadcast or CD and to broadcast or CD. perform timer playback the following morning 1 Set to the required source and tune (broadcast) or play back (CD or 1 Set the timer. (Refer to “Setting the timer” on page 14.) tape). 2 Set to the required source (broadcast, tape or CD). 2 Press the SLEEP button to set the sleep time. 3 Press
Inhaltszusammenfassung zur Seite Nr. 20
SPECIFICATIONS CD player section General Power output : 28 W (14 W + 14 W) at 4 Ω (Max.) Type : Compact disc player 20 W (10 W + 10 W) at 4 Ω (10% THD) Signal detection Input terminals : AUX IN (300 mV/47 kΩ) system : Non-contact optical pickup Output terminals : PHONES (Output level: 0-15 mW/ch, 32 Ω, Matching Number of channels : 2 channels impedance: 16 Ω - 1 kΩ) Frequency response : 20 Hz - 20,000 Hz SPEAKER (Matching impedance 4 Ω - 16 Ω) Signal-to-noise ratio : 90 dB Power requirements : A
