Inhaltszusammenfassung zur Seite Nr. 1
MICRO COMPONENT SYSTEM
UX-M3R — Consists of CA-UXM3R and SP-UXM3.
MICR O COMPONENT SYSTEM UX-M3R
STANDBY OPEN
/ON /CLOSE
REMAIN
DISPLAY
/RDS MODE
MODE
TIMER
STANDBY/ON
ON/OFF
INTRO/RDS
SEARCH
SET
TUNER
CD/RANDOM /BAND TAPE RANDOM BAND
CD TUNER TAPE
REC
PROGRAM PROGRAM PRESET SEARCH/TUNING
REPEAT
PHONES
REMAIN
/RDS MODE SLEEP PRE UP VOLUME
PRE EQ
REC STOP/CLEAR PLAY/PAUSE /HBS
INTRO REPEAT
/RDS SEARCH TIMER /PRE DOWN
DISPLAY PRE EQ
MODE /HBS +
MUTING BEAT CUT VOLUME
EJECT
–
RM-SUXM3R REMOTE
Inhaltszusammenfassung zur Seite Nr. 2
Warnings, Cautions and Others Caution –– STANDBY/ON button! IMPORTANT FOR LASER PRODUCTS Disconnect the mains plug to shut the power off completely. The REPRODUCTION OF LABELS STANDBY/ON button in any position does not disconnect the mains line. The power can be remote controlled. 1 CLASSIFICATION LABEL, PLACED ON REAR ENCLOSURE 1 CLASS PRODUCT LASER CAUTION To reduce the risk of electrical shocks, fire, etc.: 1. Do not remove screws, covers or cabinet. 2 WARNING LABEL, PLACED INSIDE THE UNIT
Inhaltszusammenfassung zur Seite Nr. 3
Caution: Proper Ventilation To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows: 1 Front: No obstructions and open spacing. 2 Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below. 3 Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm or more. Front view Side view 15 cm 15 cm 1 cm 1 cm 15 cm 15 cm 15 cm UX-M3R UX-M3R 10 cm – G-2 – 01_G1_G
Inhaltszusammenfassung zur Seite Nr. 4
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual • When unplugging from the wall outlet, always pull the This manual is organized as follows: plug, not the AC power cord. • The manual mainly explains operations using the DO NOT handle the AC power cord with wet hand
Inhaltszusammenfassung zur Seite Nr. 5
Contents Location of the Buttons and Controls ..................... 3 Front Panel ................................................................ 4 Remote Control ......................................................... 5 Getting Started .......................................................... 6 Unpacking ................................................................. 6 Putting the Batteries into the Remote Control .......... 6 Connections ..................................................
Inhaltszusammenfassung zur Seite Nr. 6
Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Front Panel Display Window 1 9 2 p 3 q 4 PROGRAM SLEEP HBS TOTAL REMAIN INTRO STEREO w RANDOM ONE 5 e ON OFF ALL REPEAT CD SYNC r MHz 6 t kHz POP CLASSIC ROCK JAZZ TAPE REC y 7 u 8 1 w 2 e MICR O COMPONENT SYSTEM UX-M3R STANDBY OPEN 3 /ON /CLOSE r REMAIN DISPLAY /RDS MODE MODE 4 t TIMER ON/OFF INTRO/RDS SEARCH y 5 SET RANDOM BAND CD TUNER TAPE 6 PROGRAM PRESET SEARCH/TUNING 7 REPEAT PHONES u VOL
Inhaltszusammenfassung zur Seite Nr. 7
Continued a PLAY/PAUSE 6 button (13, 15) Front Panel CD/Tape: starts or interrupts playback. See pages in the parentheses for details. STOP/CLEAR 7 button (13, 15) 1 Disc compartment (13) CD: stops playback or clears the program. 2 STANDBY/ON button (8) Tape: stops playback or recording. Turns the unit on or off (standby mode). 3 CD/RANDOM button (13, 14) Display window Selects CD mode. 1 /ON/OFF (timer on/off) indicators (17) Starts or stops random play in CD mode. 2 HBS indicator (9) 4 DISPLAY
Inhaltszusammenfassung zur Seite Nr. 8
Remote Control Remote Control 1 STANDBY/ON button 2 CD/RANDOM button 3 TUNER/BAND button 1 4 REC (Recording) button STANDBY/ON w 2 5 PROGRAM button TUNER CD/RANDOM /BAND TAPE 6 REMAIN/RDS MODE button 3 e REC 7 INTRO/RDS SEARCH button 4 r 8 TIMER button PROGRAM 9 DISPLAY MODE button t 5 REMAIN /RDS MODE SLEEP PRE UP p PRE EQ/HBS button 6 y INTRO REPEAT q MUTING button /RDS SEARCH TIMER /PRE DOWN Interrupts and resumes sound reproduction. 7 u DISPLAY PRE EQ MODE /HBS + w TAPE button 8 i VOLUME e7
Inhaltszusammenfassung zur Seite Nr. 9
Continued Getting Started Unpacking Connections After unpacking, check to be sure that you have all the following items. • DO NOT connect any equipment to the unit while the unit is powered. The number in the parentheses following each item name • DO NOT plug in any equipment until all connections indicates the supplied quantity. are completed. • Remote control (1) • Batteries (R03 (UM-4)/AAA (24F)) for remote control (2) • AM loop antenna (1) If any is missing, consult your dealer immediately.
Inhaltszusammenfassung zur Seite Nr. 10
2 Connect the supplied AM loop antenna to the AM LOOP terminal. Place the antenna away from the unit and adjust its position for the best reception. 1 2 3 3 Adjust the position of the FM antenna for the best reception. 4 Connect the AC power cord of the unit to the AC outlet after all other connections have been made. – 7 – 02_01_21_UXM3R_A_En.p65 7 02.1.21, 7:22 PM
Inhaltszusammenfassung zur Seite Nr. 11
Continued Common Operations Turning On or Off the Unit On clock resetting To turn on the unit If a power failure occurs or the AC power cord is Press STANDBY/ON on the STANDBY/ON disconnected, the clock is reset to "0:00" (flashing). In such a STANDBY unit or remote control. or case you need to set the clock again. /ON The unit turns on with the last source selection remaining valid. Adjusting the Volume To turn off the unit (on stanby) • You can adjust the volume only while the unit is turned
Inhaltszusammenfassung zur Seite Nr. 12
Digital Sound Control The unit’s digital sound control feature enables you to select desired preset equalizer settings (selectable as sound modes) to enjoy special sound effects matching the music type. You can also use the HBS (Hyper Bass Sound) system to enjoy powerful bass sound created by emphasizing low frequencies. To select the desired sound mode PRE EQ Press PRE EQ/HBS repeatedly. /HBS Each time you press the button, the sound mode changes as follows: POP CLASSIC ROCK FLAT JAZZ POP: Mor
Inhaltszusammenfassung zur Seite Nr. 13
Continued Listening to FM and MW Broadcasts Tuning In a Station Presetting Stations You can preset 20 FM and 20 MW stations. BAND 1 When the unit is turned on, TUNER • There is a time limit in doing the following steps. If the press TUNER/BAND to setting is canceled before you finish, start from step 1 select tuner mode. again. The unit tunes in the last station tuned in (either FM or MW). 1 Tune in the station you want to preset. BAND 2 Press TUNER/BAND to TUNER • See “Tuning In a Station” on t
Inhaltszusammenfassung zur Seite Nr. 14
Tuning In a Preset Station BAND 1 Press TUNER/BAND to TUNER select tuner mode. 2 Press TUNER/BAND to select the band, FM or MW. PRESET 3 Press PRESET ∞ or 5 (or PRE REPEAT UP or REPEAT/PRE DOWN on the remote control) to select the desired preset number. – 11 – 02_01_21_UXM3R_A_En.p65 11 02.1.21, 7:23 PM
Inhaltszusammenfassung zur Seite Nr. 15
Receiving FM Stations with RDS RDS (Radio Data System) allows FM stations to send an Searching for Programs by PTY Codes additional signal along with their regular program signals. (PTY Search) For example, the stations send their station names, as well as information about what type of program they broadcast, such One of the advantages of RDS is that you can locate a as sports or music, etc. particular kind of program by specifying the PTY (Program When tuned to an FM station which provides the
Inhaltszusammenfassung zur Seite Nr. 16
Playing Back CDs This unit can play back audio CDs. Program Play You can arrange the order in which the tracks are played before you start playing. You can program up to 60 tracks. PROGRAM 1 In stop mode, press Loading a Disc PROGRAM. RANDOM The PROGRAM indicator starts 1 Press CD/RANDOM to CD blinking. select CD mode. SEARCH/TUNING 2 Press 4 or ¢ repeatedly 2 Press 0 OPEN/CLOSE. OPEN to select the desired track. The disc tray slides out. /CLOSE The current program number starts blinking. 3 Load
Inhaltszusammenfassung zur Seite Nr. 17
Random Play Introductory Play You can play all the tracks in random order. The introductory portions of tracks can be played back automatically. RANDOM Press CD/RANDOM before or CD INTRO/RDS Press INTRO/RDS SEARCH. during playing. SEARCH The first 10-second portion of each of The RANDOM indicator lights up. the tracks is played back in order. To exit random play mode, press CD/RANDOM again. To exit introductory play mode, press INTRO/RDS The RANDOM indicator goes off. SEARCH again. • Activating
Inhaltszusammenfassung zur Seite Nr. 18
Playing Back Tapes • Use only type I normal tapes. Rewind/Fast Forward SEARCH/TUNING The use of tapes longer than 120 minutes is not 1 Press 4 or ¢ to rewind recommended, since characteristic deterioration may or fast forward the tape. occur and these tapes easily jam in the pinchroller and “REW” or “FF” appears on the the capstan. display. STOP/CLEAR 2 Press 7 to stop rewinding or Loading a Tape fast forwarding. 1 Press 0 EJECT to open the • The tape stops automatically at the end of the rewind
Inhaltszusammenfassung zur Seite Nr. 19
Recording IMPORTANT: Recording Tapes • It may be unlawful to record or playback copyrighted material without the consent of the copyright owner. 1 Load a recordable tape into the tape deck. • The recording level is automatically set correctly, so it is Insert a tape with the open side down and the side to be not affected by the volume control. Thus, during recording recorded facing out from the unit. you can adjust the sound you are actually listening to RANDOM BAND without affecting the recordi
Inhaltszusammenfassung zur Seite Nr. 20
Using the Timers There are three timers available – daily timer, recording timer and sleep timer. 8 Prepare the source and set the volume. Before using the timers, you need to set the built-in clock. To listen to the radio, tune in the desired station. (See page 8.) To listen to a CD, load the disc. TIMER ON/OFF Using Daily Timer 9 Press TIMER ON/OFF SET SET (or TIMER on the remote With the daily timer, you can wake to your favorite music or control) to activate the timer. radio program. “ ” lig
