Inhaltszusammenfassung zur Seite Nr. 1
Cover[B].fm Page 1 Sunday, January 18, 2004 6:58 PM
MICRO COMPONENT SYSTEM
UX-P400—Consists of CA-UXP400 and SP-UXP400
INSTRUCTIONS
GVT0128-003A
[B]
Inhaltszusammenfassung zur Seite Nr. 2
Safty[B1].fm Page 1 Sunday, January 18, 2004 6:58 PM Warnings, Cautions and Others IMPORTANT FOR LASER PRODUCTS IMPORTANT for the U.K. 1. CLASS 1 LASER PRODUCT DO NOT cut off the mains plug from this equipment. If the 2. CAUTION: Do not open the top cover. There are no user plug fitted is not suitable for the power points in your home serviceable parts inside the unit; leave all servicing to or the cable is too short to reach a power point, then obtain qualified
Inhaltszusammenfassung zur Seite Nr. 3
UX-P400[B]TOC.fm Page 1 Sunday, January 18, 2004 6:58 PM Contents Introduction........................................................ 2 Precautions..........................................................................2 How to Read This Manual..................................................2 Getting Started ................................................... 3 Step 1: Unpack....................................................................3 Step 2: Prepare the Rem
Inhaltszusammenfassung zur Seite Nr. 4
Introduction.fm Page 2 Sunday, January 18, 2004 6:57 PM Introduction Precautions How to Read This Manual To make this manual as simple and easy-to-understand as Installation possible, we have adapted the following methods: • Install in a place which is level, dry and neither too hot nor • Button and control operations are explained as listed in the too cold—between 5°C and 35°C. table below. In this manual, the operations using the • Install the System in a location
Inhaltszusammenfassung zur Seite Nr. 5
Introduction.fm Page 3 Sunday, January 18, 2004 6:57 PM Getting Started Step 1: Unpack Step 1:Unpack the package and check the accessories. After unpacking, check to be sure that you have all the following items. The number in parentheses indicates the quantity of each piece supplied. • FM antenna (1) • AM loop antenna (1) • Remote control (1) • Batteries (2) If any item is missing, consult your dealer immediately. Step 2: Prepare the Remote Control Insert the batteries into t
Inhaltszusammenfassung zur Seite Nr. 6
Connection.fm Page 4 Sunday, January 18, 2004 6:57 PM Step 3: Hook Up If you need more detailed information, see page 6. Illustrations of the input/output terminals below are typical examples. When you connect other components, refer also to their manuals since the terminal names actually printed on the rear may vary. Turn the power off to all components before connections. For better FM/AM reception AM loop antenna Keep it connected. Outdoor FM antenna (not supplied) Vynile-covered
Inhaltszusammenfassung zur Seite Nr. 7
Connection.fm Page 5 Sunday, January 18, 2004 6:57 PM FM antenna (supplied) Extend it so that you can obtain the best reception. AM loop antenna (supplied) Turn it until the best reception is obtained. Red White 5 AUTO REVERSE PUSH OPEN
Inhaltszusammenfassung zur Seite Nr. 8
Connection.fm Page 6 Sunday, January 18, 2004 6:57 PM To connect the AM loop antenna To assemble and connect the AM loop antenna To assemble the AM loop antenna 1 Hold 3 Release 2 Insert • If the AM loop antenna wire or speaker cords are covered with vinyl, remove the vinyl to expose the tip of the antenna by twisting the vinyl. • Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. Also, keep the antennas away from metallic parts o
Inhaltszusammenfassung zur Seite Nr. 9
Connection.fm Page 7 Tuesday, January 20, 2004 6:31 PM Before Operating the System The indications on the display teach you a lot of things while you are operating the System. Before operating the System, be familiar with when and how the indicator illuminates on the display. 3 FM reception indicators • MONO: lights while receiving an FM stereo station in 12 34 5 monaural. • ST (stereo): lights while an FM stereo station with SLEEP MONO ST MP3 REC sufficient signal strength
Inhaltszusammenfassung zur Seite Nr. 10
Basic.fm Page 8 Sunday, January 18, 2004 6:56 PM Daily Operations—Playback 1 Turn on the power. The STANDBY/ON lamp on the main unit lights in green. • Without pressing STANDBY/ON , the System 1 turns on by pressing one of the source selecting 10 keys buttons in the next step. 2 Select the source. 4,7,¢ SET Playback automatically starts if the selected source is PRESET UP GROUP UP ready to start. PRESET DOWN GROUP DOWN • If you press AUX, start playback source on the exte
Inhaltszusammenfassung zur Seite Nr. 11
Basic.fm Page 9 Sunday, January 18, 2004 6:56 PM 4 Store the station. To tune in to a station While FM or AM is selected... SET Remote control: Main unit: 2 sec. 2 sec. Remote ONLY DOWN UP To tune in to a preset station 1 Select the band (FM or AM). Frequency starts changing on the display. FM AM When a station (frequency) with sufficient signal strength is tuned in, the frequency stops changing. • When you repeatedly press the button, the frequency
Inhaltszusammenfassung zur Seite Nr. 12
Basic.fm Page 10 Sunday, January 18, 2004 6:56 PM To start: To pause: To stop: Playing Back a Tape To insert a tape You can play back tapes of types I, II, and IV. Push Insert Close To release, press again. To select a track Increases the track numbers. With the tape side facing outside Decreases the track numbers. To start: To stop: Remote ONLY To select a group (MP3 only) Before starting playback... GROUP UP Increases the group numbers. To rewind tape: GROUP DOWN Before or
Inhaltszusammenfassung zur Seite Nr. 13
Basic.fm Page 11 Sunday, January 18, 2004 6:56 PM Daily Operations—Sound&Other Adjustments Adjusting the Volume Remote control You can adjust the volume level from level 0 (VOL MIN) to level 40 (VOL MAX). Remote control: Main unit: VOLUME SLEEP CLOCK/ VOLUME TIMER DISPLAY SET Remote ONLY 4/¢ To drop the volume in a moment To restore the volume, press again, or FADE MUTING adjust the volume level. A.STANDBY BASS/ TREBLE RHYTHM AX DIMMER VOLUME Adjusting the Sound FADE +/– M
Inhaltszusammenfassung zur Seite Nr. 14
Basic.fm Page 12 Sunday, January 18, 2004 6:56 PM Remote ONLY Changing the Display Brightness Turning Off the Power Remote ONLY You can dim the display window. Automatically To turn off the unit after playback is over—Auto DIMMER DIM 1 DIM 2 Standby DIM OFF A.STANDBY (Canceled) ON OFF (Canceled) DIM 1 Dims the display. DIM 2 Erases the display illumination. When Auto Standby is in use, the A.STANDBY indicator lights on the display. Remote When the tape or disc
Inhaltszusammenfassung zur Seite Nr. 15
AdvancedRadio.fm Page 13 Sunday, January 18, 2004 6:56 PM Advanced Radio Operations To show the RDS information Remote control While listening to an FM station... RDS DISPLAY PS PTY Frequency RT (Non-RDS signal) PS Station names is displayed. “NO PS” will appear if no signal is sent. PTY The broadcast program type is displayed. “NO PTY” will appear if no signal is sent. RT Text messages the station sends is displayed. “NO RT” will appear if no signal is sent. S
Inhaltszusammenfassung zur Seite Nr. 16
AdvancedRadio.fm Page 14 Sunday, January 18, 2004 6:56 PM 3 Start searching. How the Enhanced Other Networks function actually works: PTY ST SEARCH CASE 1 If a station is not broadcasting the program of your choice The System continues tuning in to the current station. ST « When a station broadcasting the program of your choice, the System automatically switches to the station. The PTY Ex. When “NEWS” is selected code indicator starts flashing. « The receiver
Inhaltszusammenfassung zur Seite Nr. 17
AdvancedRadio.fm Page 15 Sunday, January 18, 2004 6:56 PM Description of the PTY codes NEWS News. PHONE IN Involving members of the public expressing their views either by phone AFFAIRS Topical program expanding or or at a public forum. enlarging upon the news—debate, or analysis. TRAVEL Travel information. INFO Programs the purpose of which is to LEISURE Programs about recreational activities. impart advice in the wide
Inhaltszusammenfassung zur Seite Nr. 18
AdvancedDisc.fm Page 16 Sunday, January 18, 2004 6:56 PM Advanced Disc Operations Programming the Playing Order— Remote control Remote ONLY Program Play You can arrange the playing order of the tracks (up to 50) before you start playback. 1 Before starting playback, activate Program Play. PLAY MODE PROGRAM RANDOM Canceled 4,7,¢ CANCEL CD 6 PRGM REPEAT PLAY 2 Select tracks you want for Program Play. MODE Examples: 1 3 2 To select track number 5, press 5. 4 5 6 To select trac
Inhaltszusammenfassung zur Seite Nr. 19
AdvancedDisc.fm Page 17 Sunday, January 18, 2004 6:56 PM Remote To check the programmed contents ONLY Playing at Random—Random Play Before or after playback... You can play all tracks at random. In the programmed order. 1 Before starting playback, activate Random Play. In the reverse order. PLAY MODE PROGRAM RANDOM Canceled To modify the program Before or after playback... To erase the last step: To erase the entire RANDOM program: CANCEL 2 Start playback. Playback s
Inhaltszusammenfassung zur Seite Nr. 20
AdvancedDisc.fm Page 18 Tuesday, January 20, 2004 1:28 PM Remote 3 Select the end point (B). ONLY Playing Repeatedly—Repeat Play SET You can repeat playback. Before starting playback... A-B Repeat starts. The selected portion plays repeatedly. REPEAT ALL Canceled To cancel A-B Repeat (No indication) REPEAT ALL A-B Repeat While playing... Canceled (No indication) REPEAT ALL A-B Repeat • A-B Repeat will also be canceled when you stop playback. Canceled (No indication) Repe
