Inhaltszusammenfassung zur Seite Nr. 1
MICRO COMPONENT SYSTEM
—Consists of CA-UXS10 and SP-UXS10
UX-S10
INSTRUCTIONS
LVT1563-001A
[B]
UX-S10[B]_C_01cover_f.p65 1 06.3.10, 5:17 PM
Inhaltszusammenfassung zur Seite Nr. 2
Warnings, Cautions and Others IMPORTANT FOR LASER PRODUCTS IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the CAUTION - INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCKS DEFEATED. AVOID EXPOSURE TO BEAM. cable is too short to reach a power point, then obtain an appro- VORSICHT ! UNSICHTBARE LASERSTRAHLUNG TRITT AUS, WENN DECKEI. priate safety approved extension lead or consult your dealer. GEÖFFNE
Inhaltszusammenfassung zur Seite Nr. 3
SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. ✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮ Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connections (including the mains plug, extension leads and inter
Inhaltszusammenfassung zur Seite Nr. 4
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual •When unplugging the unit from the wall outlet, always pull This manual is organized as follows: on the plug, not the AC power cord. • This manual mainly explains operations using the DO NOT handle the AC power cord w
Inhaltszusammenfassung zur Seite Nr. 5
Contents Location of the Buttons and Controls ............................. 3 Main unit ................................................................................... 3 Remote Control ......................................................................... 5 Getting Started .................................................................. 6 Unpacking ................................................................................. 6 Putting the Batteries into the Remote Control ..........
Inhaltszusammenfassung zur Seite Nr. 6
Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Main Unit Top view 1 OPEN 5 6 TIMER ON/OFF BAND MULTI SOUND 2 CONTROL /BASS TAPE TUNER CD 7 PHONES CD CONTROL 3 4 8 Front view 9 STANDBY/ON VOLUME p e STANDBY q MICRO COMPONENT SYSTEM UX-S10 r w CD SYNCHRO RECORDING OPEN t Inside the front cover y 3 UX-S10[B]_C_03name_f.p65 3 06.3.10, 5:17 PM
Inhaltszusammenfassung zur Seite Nr. 7
Continued Display window on the front panel 12 3 4 56 7 ON OFF SLEEP ST MONO SOUND BASS SYNC MHz kHz MP3 1ALL GR. PRGM RAND TOTAL REMAIN 89q p w e r t See pages in parentheses for details. Main unit Display window 1 Disc cover (14) 1 (timer) indicator 2 PHONES jack (9) 2 ON/OFF (timer on-time/off-time) indicators 3 TIMER ON/OFF button (20) 3 SLEEP indicator 4 SOUND/BASS button (9) 4 FM mode indicators 5 0 OPEN (disc cover open) (14, 15) • ST (stereo), MONO 6 Source buttons 5 SOUND indicator • T
Inhaltszusammenfassung zur Seite Nr. 8
Remote Control See pages in parentheses for details. 1 TIMER SET button (20) 2 REPEAT/PTY SEARCH button (12, 16) 3 RANDOM button (16) 4 REMAIN/PS/PTY/RT button (12, 16) 5 BEAT CUT button (10, 18) 6 DISPLAY/CLOCK SET button (8) TIMER SET ON/OFF STANDBY/ON 7 MUTING button (9) 9 1 8 SOUND/BASS button (9) REPEAT/ p 9 STANDBY/ON button (8, 20) PTY SEARCH RANDOM SLEEP 2 q p TIMER ON/OFF button (20, 21) 3 w REMAIN/ q SLEEP button (21) PS/PTY/RT PROGRAM FM MODE w PROGRAM button (11, 15, 16, 20) 4 e TUNE
Inhaltszusammenfassung zur Seite Nr. 9
Getting Started Continued Connections Unpacking After unpacking, check to be sure that you have all the To connect speakers following items. You can connect the speakers using the speaker cords. The number in parentheses indicates the quantity of each piece supplied. • FM antenna (1) 1 2,3 • AM (MW) loop antenna (1) • Remote control (1) • Batteries (2) If any item is missing, consult your dealer immediately. SPEAKER Putting the Batteries into the Remote Control IMPEDANCE 4-16Ω Red Insert the
Inhaltszusammenfassung zur Seite Nr. 10
FM 75 COAXIAL AM LOOP FM 75 COAXIAL AM LOOP To connect AM (MW) and FM antennas To connect an outdoor FM antenna Before connecting the antenna, disconnect the supplied FM antenna. FM antenna Outdoor FM antenna (not supplied) Ω Coaxial cable (not supplied) 1 2 Ω A 75 Ω antenna with coaxial type connector AM (MW) loop antenna (IEC or DIN 45325) should be used. (supplied) 1 Attach the FM antenna to the FM COAXIAL NOW you are ready to plug in the unit. 75 Ω terminal. Fasten it up in the position
Inhaltszusammenfassung zur Seite Nr. 11
Basic and Common Operations Continued Setting the Clock • When you unplug the AC power cord or if a power failure occurs Before operating the unit any further, first set the unit’s clock. The clock is reset to “0:00” right away. If this happens, set the When you plug in the power cord, “0:00” starts flashing on clock again. the display. • The clock may gain or lose 1 to 2 minutes per month You can set the clock when the unit is either turned on or in If this happens, reset the clock. standby mo
Inhaltszusammenfassung zur Seite Nr. 12
Selecting the Source Selecting the Sound Modes To select the source, press TAPE, You can select one of the 4 sound modes. TUNER/ TAPE CD BAND TUNER/BAND, or CD. •This function also affects the sound from headphones. •This function only affects the playback sound, and does not •When you select TAPE or CD as affect your recording. the source, playback does not start SOUND/ automatically. To select the sound modes, press SOUND/BASS BASS repeatedly. To operate the tuner (FM or AM (MW)), see pages 10
Inhaltszusammenfassung zur Seite Nr. 13
Listening to FM and AM (MW) Broadcasts Continued To change the FM reception mode Tuning in to a Station On the remote control ONLY: FM MODE When an FM stereo broadcast is hard to receive TUNER/ 1 Press TUNER/BAND to select either BAND or noisy, press FM MODE so that the MONO “FM” or “AM.” indicator lights up on the display. Reception will The unit automatically turns on and tunes in to improve. the previously received station—either FM or To restore the stereo effect, press FM MODE again so tha
Inhaltszusammenfassung zur Seite Nr. 14
Presetting Stations Tuning in to a Preset Station You can preset 30 FM and 10 AM (MW) stations manually. On the remote control ONLY: In some cases, test frequencies have been already stored TUNER/ 1 Press TUNER/BAND to select either BAND for the tuner since the factory examined the tuner preset “FM” or “AM.” function before shipment. This is not a malfunction. You The unit automatically turns on and tunes in to can preset the stations you want into memory by following the previously received sta
Inhaltszusammenfassung zur Seite Nr. 15
Receiving FM Stations with Radio Data System Continued Radio Data System allows FM stations to send an additional Searching for Programs by PTY Codes signal along with their regular program signals. For example, (PTY Search) the stations send their station names, as well as information about what type of program they broadcast, such as sports or One of the advantages of Radio Data System is that you can music, etc. locate a particular kind of program by specifying the PTY codes. With the unit,
Inhaltszusammenfassung zur Seite Nr. 16
Description of the PTY codes: NEWS: News. WEATHER: Weather reports and forecasts. AFFAIRS: Topical program expanding or enlarging FINANCE: Stock Market reports, commerce, trading upon the news—debate, or analysis. etc. INFO: Program the purpose of which is to impart CHILDREN: Programs targeted at a young audience. advice in the widest sense. SOCIAL: Programs about sociology, history, SPORT: Program concerned with any aspect of geography, psychology and society. sports. RELIGION: Religious progra
Inhaltszusammenfassung zur Seite Nr. 17
Playing Back Discs Continued This unit has been designed to play back the following Playing Back the Entire Disc—Normal Play discs—CD, CD-R, and CD-RW. When playing a CD-R or CD-RW 1 Press 0 OPEN on the unit. User-edited CD-Rs (CD-Recordable) and CD-RWs (CD- The disc cover opens. ReWritable) can be played only if they are already •You can insert a disc while listening to another source. “finalized.” • Usually you can play back your original CD-Rs or CD- 2 Place a disc correctly with its label s
Inhaltszusammenfassung zur Seite Nr. 18
While playing back an MP3 disc Programming the Track Playing Order—Program Play ID3 Tag information (the name of the title, artist, and album up to 30 characters) will be shown on the display. When the name is too long You can arrange the order in which tracks play before you to be displayed at once, it is scrolled. start playing. You can program up to 60 tracks. This unit supports ID3 Tag ver. 1.1 and 2.0. On the remote control ONLY: To stop playing, press 7. 1 Place a disc. • If the current so
Inhaltszusammenfassung zur Seite Nr. 19
When playing back an MP3 disc: To modify the last programmed track PROGRAM Press PROGRAM in stop mode, then repeat step 3 1 ALL above. To finish modifying and start playback, Canceled GR. press CD 3/8. •You cannot modify the program after programming the 1: Repeats one track. 60th track. In Random Play, this function is not available. To clear the program and exit the program play ALL: In Normal Play, repeats all the tracks. mode In Program Play, repeats all the tracks in the Press 7 in stop mo
Inhaltszusammenfassung zur Seite Nr. 20
Playing Back Tapes For Tape operations, use buttons inside the front cover on the 4 Close the cassette holder gently. unit. Playing Back a Tape You can play back type I tapes only. On the unit ONLY: 1 Open the front cover. 5 Press TAPE. TAPE The unit automatically turns on and the source changes to the tape deck. •You can select to the tape by pressing TAPE on the remote control. 6 Press # (play). The tape starts playing. • When the end of the tape is reached, playing 2 Press &/) (stop/cassette
