Inhaltszusammenfassung zur Seite Nr. 1
Model iP48
portable rechargeable speaker system
® ®
for your iPhone / iPod
Questions? Visit www.ihomeaudio.com
Inhaltszusammenfassung zur Seite Nr. 2
Table of Contents Table of Contents iP48 Quick Start 1 Controls and Indicators 2 Getting Started with your iP48 3-4 Using the iP48 5-6 A Consumer Guide to Product Safety 7 Trouble Shooting 8 Warranty Information 9 and are registered trademarks of SRS Labs, Inc. TruBass and WOW technologies are incorporated under license from SRS Labs, Inc. Maintenance � Place the unit on a level surface away from sources of direct sunlight or excessive heat. � Protect your furniture w
Inhaltszusammenfassung zur Seite Nr. 3
FCC Information This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with the limits for a Class B digital device as specified in Part 15 of FCC Rules. These limits provide reasonable protection against radio and TV interference in a residential are
Inhaltszusammenfassung zur Seite Nr. 4
iP48 Quick Start 1:Unzip unit 2:AC adaptor RESET TEST Unzip the iP48 to open the unit. Press the Display Button Connect the AC adaptor to the DC jack on the left side of the to release the pop-up display from travel mode (flat) to upright iP48 and plug the other end into a working wall socket to position. charge and play iPod/iPhone and to charge internal battery. iPod touch 2G iPod nano 5G iPhone 3G Use this insert insert 15 insert 16 insert 18 For this iPhone 3G/3GS iPod touch 2G iPod na
Inhaltszusammenfassung zur Seite Nr. 5
Controls and Indicators Side Panel Speakers Front Panel AC Adaptor Jack Line-in Jack Battery Compartment for Rechargeable Battery Backup Battery Compartment (under door) Dock Time Set/Time Sync Button Display Button Power/Alarm Reset Button Snooze/Dimmer Button Alarm Button _ Volume “+” Volume “ ” (raises volume) (lowers volume) iP48 Display PM Indicator Alarm Indicator Time Display Battery Level Indicator Battery backup indicator 2 Press display button to release catch and flip up display P
Inhaltszusammenfassung zur Seite Nr. 6
Getting Started with your iP48 Connecting the AC Adaptor For home operation and to charge your iPhone/iPod, connect the AC adaptor cable plug into the DC jack located under the black tab on the left side of the unit, then plug RESET TEST the AC adaptor into a working outlet. When connected to the AC adaptor, the iP48 charges the internal battery and also charges and lets you play your iPod/iPhone. NOTE: This 9V AC adaptor is for use with the iP48 only. To avoid damage, do not use other ada
Inhaltszusammenfassung zur Seite Nr. 7
Getting Started with your iP48 Recycling Information for Lithium-ion Battery: Battery Removal Caution: Use safety goggles when disassembling your iP48 1. Use Philips screwdriver to remove screw of internal battery compartment, located behind the dock 2. Remove battery compartment door 3. Disconnect battery connector 4. Do not place in trash. Dispose of battery according to local battery recycling laws Installing/Replacing the Backup Battery The iP48 uses a backup battery system to provide co
Inhaltszusammenfassung zur Seite Nr. 8
Using iP48 Using Time Sync to Set Clock from iPhone/iPod The iP48 allows you to sync its clock with the time setting on the iP48 to the time from your iPhone or recent model iPod Touch, iPod Nano and iPod Classic (older iPod models such as iPod mini do not support this feature). 1. Make sure the iP48 is off. Dock your iPhone/iPod into the iP48 using the proper insert (see table on page 1). 2. Press the Button. “SYNC” will flash on the display until sync is completed. Two beeps will i
Inhaltszusammenfassung zur Seite Nr. 9
Using iP48 Alarm Time Cycle and Snooze Operation Alarm Time Cycle 1. When using AC power, the alarm time cycle is 1 hour. To save battery power, the alarm time cycle is shorter when using battery power (iPhone/iPod alarm cycle is 15 minutes and wake to buzzer is 3 minutes during battery operation). 2. Press the Snooze/Dimmer Button after the alarm sounds. The alarm will be silenced and come on again after 9 minutes. Snooze can be pressed several times during the alarm time cyc
Inhaltszusammenfassung zur Seite Nr. 10
A Consumer Guide to Product Safety When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1. Water and Moisture – The unit should
Inhaltszusammenfassung zur Seite Nr. 11
Trouble Shooting Symptom Possible Problem Solution Unit doesn’t respond AC adaptor isn’t plugged into a wall outlet Plug the AC adaptor into a wall outlet and plug the (no power) or the connector is not plugged into the connector into the supply jack on the unit power supply jack on the back of the dock Plug another device into the same outlet to confirm the outlet Wall outlet is not functioning or switched off is working. Make sure any ass
Inhaltszusammenfassung zur Seite Nr. 12
Limited 1 Year Warranty Information iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of 1 year from the date of original purchase. Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased. Should this fail to resolve the matter and service stil
