Inhaltszusammenfassung zur Seite Nr. 1
19
ND-91649 (E)
ISSUE 3
General Description
NEC Corporation
Inhaltszusammenfassung zur Seite Nr. 2
Inhaltszusammenfassung zur Seite Nr. 3
LIABILITY DISCLAIMER NEC Corporation reserves the right to change the specifications, functions, or features, at any time, without notice. NEC Corporation has prepared this document for use by its employees and customers. The information contained herein is the property of NEC Corporation and shall not be reproduced without prior written approval from NEC Corporation. term NEAX and D are registered trademarks of NEC Corporation. Copyright 20
Inhaltszusammenfassung zur Seite Nr. 4
Inhaltszusammenfassung zur Seite Nr. 5
ND-91649(E) ISSUE 3 NEAX 2000 IPS General Description TABLE OF CONTENTS Page CHAPTER 1 INTRODUCTION............................................................................................................. 1 System Overview ..................................................................................................................................................1 Hardware Architecture .........................................................................................
Inhaltszusammenfassung zur Seite Nr. 6
ND-91649(E) ISSUE 3 LIST OF ILLUSTRATIONS Figure Title Page Figure 1-1 NEAX 2000 IPS...................................................................................................................................1 Figure 1-2 NEAX 2000 IPS System Overview....................................................................................................2 Figure 1-3 Example of Network Configuration of Remote PIM over IP ..........................................................3 Figur
Inhaltszusammenfassung zur Seite Nr. 7
ND-91649(E) ISSUE 3 LIST OF TABLES Table Title Page Table 1-1 Technical Terms of NEAX 2000 IPS System ....................................................................................8 Table 2-1 Modules of NEAX 2000 IPS System ................................................................................................14 term term Table 3-1 D Series i/D IP Specifications and Accessories ..................................................................26 term term Table 3-2
Inhaltszusammenfassung zur Seite Nr. 8
Inhaltszusammenfassung zur Seite Nr. 9
INTRODUCTION CHAPTER 1 INTRODUCTION This document provides an overview of the NEAX 2000 IPS (Internet Protocol Server) stored program control digital electronic PBX. An introduction to the technical characteristics is included, along with a description of available system applications. System Overview The NEAX 2000 IPS is a full-featured IP-based communications system providing a rich feature set of NEAX 7400 ICS M100MX*, with pure Voice over IP (VoIP) communications (peer-to-peer co
Inhaltszusammenfassung zur Seite Nr. 10
INTRODUCTION term D IP telephones are designed to provide a converged infrastructure at the desktop, with a 100 Base T Ethernet connection to the LAN and built-in hub for a PC connection to the telephone itself. The system can term provide peer-to-peer connections between D IP telephones with voice compression, on a CCIS basis (CCIS over IP). PHS cell station can also be connected to LAN with 100 Base T Ethernet as IP-BS. term IPS also provide Windows PC based softphone (D Softphone
Inhaltszusammenfassung zur Seite Nr. 11
INTRODUCTION Remote PIM over IP NEAX 2000 IPS can install a PIM at remote site through IP network. At the main site, the NEAX 2000 IPS is installed and the Remote PIM is installed at remote site. The main site controls call processing and service feature access for station users located both main and remote sites. When the Remote PIM cannot be connected with the main site due to the IP network and/or main PBX failure, the Remote PIM initializes the system and re-starts operation by it
Inhaltszusammenfassung zur Seite Nr. 12
INTRODUCTION Migration Path For customers who are using the NEAX 7400 ICS M100MX*, the migration path is supplied. By replacing the existing MP card to the new IPS MP card, the NEAX 7400 ICS M100MX* can be upgraded to IP/TSW Hybrid System including new and enhanced service features introduced with the NEAX 2000 IPS. For customers who are using NEAX 7400 ICS M100*/M80VS, by replacing existing PN-CP00/CP03 with Retrofit MP and PN-CP01 with Retrofit FP, the NEAX
Inhaltszusammenfassung zur Seite Nr. 13
INTRODUCTION Hardware Architecture Reduced Hardware with IP-based Architecture term term The D IPs, D Softphone and IP-BS connected to the LAN do not require any special interface cards* term because they can be interfaced directly with the LAN and connected with peer-to-peer basis. When the D IP, term D Softphone or IP-BS is connected to a station/trunk that is using TSW, the speech path between LAN and term term TSW is made via IP PAD under the call processing control of the MP.
Inhaltszusammenfassung zur Seite Nr. 14
INTRODUCTION Extended Application Processor (AP) Port Capacity The NEAX 2000 IPS provides a maximum of 256 AP ports and it is independent of the 512 ports for the Line/Trunk (LT), therefore, more AP cards such as T1/E1 digital link cards can be used in the system. Universal Slot One PIM provides 12 card slots for Line/Trunk (LT). Also, these card slots can be used for Application Processor (AP) cards without complicated limitation. This makes easy quotation and instal
Inhaltszusammenfassung zur Seite Nr. 15
INTRODUCTION Software Architecture Built-in DRS (Device Registration Server) on MP The NEAX 2000 IPS incorporates DRS (Device Registration Server) on the MP. DRS provides Log-in/Log- term out management of D IP including Registration and Authentication. Also, the built-in DRS can be inter- worked with DHCP server to provide easy administration on IP address. Office Data Backup Enhancement The office data of the NEAX 2000 IPS is stored in Flash ROM, therefore the backup pe
Inhaltszusammenfassung zur Seite Nr. 16
INTRODUCTION Technical Terms Table 1-1 Technical Terms of NEAX 2000 IPS System SYMBOL DESCRIPTION SYMBOL DESCRIPTION AMP Amplifier Trunk Card LC Line Circuit Card (for Single Line Telephone) AP00 SMDR/Hotel Application Card LDT LD Trunk Card BGM External Music Source for Dterm LLC Long Line Circuit Card Back Ground Music Service BRT Basic Rate Interface Trunk Card M10 Optical Interface Card CCH Common Channel Handler Card MAT Maintenance Administration Terminal CFT 6/10 Party C
Inhaltszusammenfassung zur Seite Nr. 17
INTRODUCTION Trunking Diagram This figure shows a typical trunking diagram of the NEAX 2000 IPS system. Figure 1-6 Trunking Diagram of NEAX 2000 IPS ND-91649(E) CHAPTER 1 Page 9
Inhaltszusammenfassung zur Seite Nr. 18
SYSTEM CONFIGURATION CHAPTER 2 SYSTEM CONFIGURATION Module Configuration The NEAX 2000 IPS consists of Port Interface Modules (PIM) depending on the system configuration, and there are two types of PIMs; “Physical” PIM and “Virtual” PIM. The Physical PIM is a “hardware” PIM and is used to accommodate an MP, FPs, IP PADs, legacy LT an AP cards, and power supply units. One Physical PIM provides up to 64 ports. term term The Virtual PIM is a “software” PIM and is used to assign
Inhaltszusammenfassung zur Seite Nr. 19
SYSTEM CONFIGURATION Installation Methods The NEAX 2000 IPS provides three installation methods as follows: Floor Standing Installation Wall Mounting Installation 19-inch Rack Mounting Installation Floor Standing Installation In Floor Standing Installation, the NEAX 2000 IPS is comprised of up to 8 Port Interface Modules (PIMs). PIM #3 PIM #2 PIM #2 PIM #1 PIM #1 PIM #1 PIM #0 PIM #0 PIM #0 PIM #0 BASE BASE
Inhaltszusammenfassung zur Seite Nr. 20
SYSTEM CONFIGURATION Wall-mounting Installation The NEAX 2000 IPS can be wall-mounted with single or multiple PIM (MAX. 8) configuration. Figure 2-3 Wall-mounting of PIM CHAPTER 2 ND-91649(E) Page 12
