Bedienungsanleitung Q-See - Digital Peripheral SolutionsQSTD

Inhaltszusammenfassung zur Seite Nr. 1

QSTD Series
Port Forwarding Instructions
STEP 3. Select Network (Red box in
Picture 3) in the System Menu
window.
NOTE! The DVR and PC must be connected to the same router.
Port Forwarding allows computers and devices outside of your network to communicate
with the DVR. You will need to forward ports 80 and 6036 from the attached router to the
IP address of the DVR. Your router must be powered up and attached to the DVR before
proceeding.
PICTURE 3
STEP 4. This is the Network Setup
Things

Inhaltszusammenfassung zur Seite Nr. 2

SECTION 2: DETERMINE THE NUMBER OF ROUTERS ON THE NETWORK To find out the number of routers on your network, you will need to download a FREE router detection program. STEP 7. Write down the IP address, Subnet Mask, and Gateway assigned by the router. STEP 1. Go to http://www.pcwintech.com/shanes-toolbox STEP 2. Click on Detect Multiple Routers to begin the download. PICTURE 7 STEP 8. Return to the Network Setup window in Step 4 and enter the information into the appropriate fields. PIC

Inhaltszusammenfassung zur Seite Nr. 3

SECTION 2: DOWNLOAD SIMPLE PORT FORWARDING PROGRAM Download the FREE Simple Port Forwarding program from: STEP 6. If there is only one router detected, then you may skip to Section 3: Simple http://www.simpleportforwarding.com/download Port Forwarding. Click on Download on Mirror 7 to download and install this program. If Multiple Routers are Detected If there are multiple routers, you will see a display similar to Picture 12. If so, it may be preferable to connect your DVR and computer to

Inhaltszusammenfassung zur Seite Nr. 4

Click on ADD CUSTOM. You will now be returned to the main window of the program. The ports you added will now show on the list. Click on Update Router at the bottom. PICTURE 18 You will see the “Updating is in progress” message. Please wait until you see it say DONE at PICTURE 16 the bottom. Input the required information: Name: (You can name your DVR if you wish) Type: TCP Start Port: 80 End Port:80 IP add: IP of DVR obtained in Step 1. Click on ADD PICTURE 17 Repeat for port 6036. PICTURE 19

Inhaltszusammenfassung zur Seite Nr. 5

If for some reason, a port or ports that you forwarded are not listed in the Router and if you Click on Begin. see a message in the Scripts list on the left side of the window stating that the port already If you receive a message stating that the port is online and can be reached, then you have set exists (Red box in Picture 20), then you will need to change the Port 80 to 85 in the DVR it up correctly. and start over again. PICTURE 20 Once you receive the DONE message that the ports have bee

Inhaltszusammenfassung zur Seite Nr. 6

SECTION 4: SETTING UP DMZ IN ROUTER 2 NOTE! You will only need to proceed with this section if you detected a second router in Section 2. STEP 1. Login into Router 1 by putting the IP of Router 1 into the Internet Explorer browser, as in the example shown in Picture 23 where the IP address of Router 1 is 192.168.0.1 STEP 2. Find the status page on the router settings that shows the WAN/ Internet IP address and write it down this WAN IP address. STEP 3. Log into the Router 2 by putting t