Inhaltszusammenfassung zur Seite Nr. 1
Model No. KV-S7065C
These instructions contain information on operating the scanner. Before reading these
instructions, please read the installation manual enclosed with this unit.
Please carefully read these instructions, the enclosed installation manual and maintenance
manual. Keep all documentation in a safe place for future reference.
Keep the CD-ROM in the protective case. Do not expose the CD-ROM to direct sunlight or
extreme heat and do not scratch or smudge the surface of the CD-ROM.
Inhaltszusammenfassung zur Seite Nr. 2
Thank you for purchasing a Panasonic “High Speed Color Scanner.” ≥ Panasonic supports your imaging needs with a reliable and easy to use document scanner. ≥ Panasonic has developed Panasonic Image Enhancement Technology to improve the quality of your scanned images even beyond the quality of your original document. ∫ System requirements When using the scanner, the required host computer conditions are as follows. SCSI Connection USB Connection Minimum Pentium III, 1 GHz CPU Recommended Pentiu
Inhaltszusammenfassung zur Seite Nr. 3
Table of Contents Page Notice . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Precautions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Before Component Identification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 You Start ≥ Power turn-on sequence . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 ≥ About LED . . . . . . . . . . . . . . . . . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 4
Notice Federal Communications Commission Requirements (For United States only) Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruc
Inhaltszusammenfassung zur Seite Nr. 5
Notice (For United Kingdom only) For your safety please read the following text carefully. This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 5 amp. fuse is fitted in this plug. Should the fuse need to be replaced, please ensure that the replacement fuse has a rating of 5 amps. and that it is approved by ASTA or BSI to BS1362. Check for the ASTA mark or the BSI mark on the body of the fuse. If the plug contains a removable fuse cover you must ensu
Inhaltszusammenfassung zur Seite Nr. 6
Notice Roller cleaning paper precautions Before using the roller cleaning paper, please read these instructions completely. Keep these instructions for future reference. English WARNING Do not drink or inhale the roller cleaning paper fluid including isopropyl alcohol. The roller cleaning paper may be harmful to sensitive skin. Please use protective gloves. Do not use the roller cleaning paper near a heater or open flame. Do not store the roller cleaning paper in direct sunlight or in a
Inhaltszusammenfassung zur Seite Nr. 7
Precautions The following precautions are recommended to extend the life of the unit: Prior to scanning, remove all staples and Do not place floppy disks or any items paper clips from pages. containing magnetic data strips on the flatbed. —Magnets are located in the flatbed cover (flatbed sheet) and may damage data stored on floppy disks and mag- netic strips. Do not place any liquids near the Do not place books, paper, or other Do not place the unit in an area unit. items on the unit. where the
Inhaltszusammenfassung zur Seite Nr. 8
Precautions Operating Environment Do not place the unit in direct sunlight or in a cold Do not operate or place the unit in a vertical position. draft. Hot Cold Do not place the unit near a heating appliance or an Do not place the unit near other appliances which gen- air conditioning vent. Do not place the unit in a room erate large electrical noise. with extremely high or low humidity. Do not place the unit on a carpet. (Static electricity Do not drink or inhale the included roller cleaning pa
Inhaltszusammenfassung zur Seite Nr. 9
Precautions ∫ CD-ROM To prevent the CD-ROMs from accidental damages: Do not touch or write on the surface Do not leave the disc out of its Do not leave the disc in direct of the disc. protective case. sunlight or near heat sources. Do not place heavy objects on the To clean the disc, hold the disc by disc case or drop the case. its edges and wipe it from the center to the edges with a dry, soft cloth. 9
Inhaltszusammenfassung zur Seite Nr. 10
Component Identification Document guide Hopper tray Hopper Hopper extension tray ADF door Back stopper Exit stopper ADF door release Manual feed selector Exit tray Power indicator Power switch When the power is turned on, the green indicator lights. Document cover When an error occurs, the indicator will change to red, and light steadily or flash. STOP/START button Used to stop or start scanning a document. Exit door Top cover Imprinter door AC inlet Power cord SCSI connector USB connector FA
Inhaltszusammenfassung zur Seite Nr. 11
Component Identification Flatbed sheet Flatbed glass Exit door release ADF glass (B) Reference plate (F) Reference plate (B) ADF glass (F) 11
Inhaltszusammenfassung zur Seite Nr. 12
Component Identification ∫ Power turn-on sequence Turn on the power of the scanner. 1 ≥ The LED will now light. Turn on the power of the host 2 computer after scanner’s LED stays green. ≥In case of the USB connection, the host computer recognizes the scanner auto- LED matically when the scanner is powered on even after the host computer is powered Power switch on. ∫ About LED LED indicates the status of the scanner as follows: LED light Status Green Ready to scan or scanning Green (flashing) S
Inhaltszusammenfassung zur Seite Nr. 13
Component Identification ∫ About the SCSI setting (Not required for USB connection) When connecting the scanner to a SCSI chain using a SCSI cable, perform the SCSI ID setting correctly. The scanner is provided with a DIP switch for the SCSI ID No. setting. SCSI ID Setting Switch ID No. Remarks #2 #1 #0 0 OFF OFF OFF 1OFF OFF ON 2 OFF ON OFF 3 OFF ON ON 4ON OFF OFF 5ON OFF ON 6 ON ON OFF Default setting 7ON ON ON 13
Inhaltszusammenfassung zur Seite Nr. 14
Loading Documents on the ADF ADF (Auto Document Feeder) enables multiple sheet scanning. Acceptable documents Document size: 48~297 mm (1.9~11.7 in.) 70~635 mm (2.75~25 in.) 2 Paper thickness: 40–127 g/m Maximum number of sheets loadable on the hopper tray The height of the document should not exceed the limit mark on the document guide. 2 g/m 40 52 64 75 80 90 104 127 lb. 11141720212428 34 Maximum number of sheets 320 260 200 170 160 140 120 100 Recommendable paper: Plain paper The following ty
Inhaltszusammenfassung zur Seite Nr. 15
Loading Documents on the ADF ∫ When scanning multiple sheets Cautions: ≥ Please remove any staples from the document before scanning. ≥ Glued or curled documents may cause a paper jam or damage the unit, so please scan using the flatbed. Documents that have been stapled Prior to scanning, remove, all staples and paper clips 1 together or stacked together (as in a from pages. file folder) will need to be separated. 1Fan the stack of documents to separate all the edges. 2Hold both ends and bend th
Inhaltszusammenfassung zur Seite Nr. 16
Loading Documents on the ADF Set the manual feed selector to 4 “AUTO”. Manual feed selector When using long paper, pull out the Hopper Hopper extension 5 hopper extension tray from the hopper. tray Then raise and adjust the exit stopper to the position a little longer than the actual length of the document. Exit stopper 16
Inhaltszusammenfassung zur Seite Nr. 17
Loading Documents on the ADF Place the documents on the hopper Portrait 6 with the side to be scanned facing up. Then push them in the direction of the arrow until they stop. ≥The amount of documents should not exceed the limit mark on the document Fill indicator guide. This may cause a paper jam or (Limit mark) skew. Landscape Adjust the document guide to the size 7 Document guide of the document to be scanned. Adjust the exit stopper to the size of the document to be output. ≥When scanning the
Inhaltszusammenfassung zur Seite Nr. 18
Feeding a Document Manually When scanning a document one page at a time with the ADF, set the manual feed selector to “MANUAL” and the pages can be scanned one page at a time. Cautions: ≥ Please remove any staples from the document before scanning. ≥ Glued or curled documents may cause a paper jam or damage the unit, so please scan using the flatbed. Set the manual feed selector to 1 “MANUAL”. Manual feed selector Match the document guide with the Document guide 2 size of the document. Insert t
Inhaltszusammenfassung zur Seite Nr. 19
Loading Documents on the Flatbed One sheet or an entire book document can be scanned on the document glass. Scanning documents in this way is known as “scanning with the flatbed”. Caution ≥ Do not place floppy disks or any items containing magnetic data strips on the flatbed. Magnets are located in the flatbed cover (flatbed sheet) and may damage data stored on floppy disks and magnetic strips. ∫ When scanning with the flatbed Raise the hopper tray. Document cover 1 Open the document cover. 2 H
Inhaltszusammenfassung zur Seite Nr. 20
Loading Documents on the Flatbed Close the document cover gently. 6 ≥If the document cover is slammed, the document will move and may not be scanned properly. ≥ Do not open or press down on the docu- ment cover during scanning. ≥ Do not look directly at the light. (You may damage your eyes.) ≥Be sure to close the document cover before use. ≥ After scanning, open the document cover and remove the document. ∫ Scanning thick documents When scanning thick documents such as a book, please note the fo
