Inhaltszusammenfassung zur Seite Nr. 1
Decoded Output
Inhaltszusammenfassung zur Seite Nr. 2
Disclaimer Welch Allyn reserves the right to make changes in specifications and other information contained in this document without prior notice, and the reader should in all cases consult Welch Allyn to determine whether any such changes have been made. The information in this publication does not represent a commitment on the part of Welch Allyn. Welch Allyn shall not be liable for technical or editorial errors or omissions contained herein; nor for incidental or consequential damages resu
Inhaltszusammenfassung zur Seite Nr. 3
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Class B Compliance Statement This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protect
Inhaltszusammenfassung zur Seite Nr. 4
The CE mark on the product indicates that the system has been tested to and conforms with the provisions noted within the 89/336/EEC Electromagnetic Compatibility Directive and the 73/23/EEC Low Voltage Directive. For further information, please contact: Welch Allyn Ltd. 1st Floor Dallam Court Dallam Lane Warrington, Cheshire WA2 7LT England Welch Allyn shall not be liable for use of our product with equipment (i.e., power supplies, personal computers, etc.) that is not CE marked and does not
Inhaltszusammenfassung zur Seite Nr. 5
TABLE OF CONTENTS Section 1 Introduction & Quick Start Menu Section Page Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–1 Scanner Identification . . . . . . . . . . . . . . . . . . . . . . . . . . 1–2 Connecting the Scanner . . . . . . . . . . . . . . . . . . . . . . . . 1–3 Scan Maps . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–4 Plug and Play Selections IBM PC Interface . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 6
Section 2 Output Parameters Menu, continued Output Selections Beeper Volume Selection . . . . . . . . . . . . . . . . . . . . . . . 2–8 Output Delays Selection . . . . . . . . . . . . . . . . . . . . . . . . 2–8 Reread Delay Selection . . . . . . . . . . . . . . . . . . . . . . . . . 2–9 Good Read Delay Selection . . . . . . . . . . . . . . . . . . . . . 2–9 Laser Voting Selection . . . . . . . . . . . . . . . . . . . . . . . . . . 2–9 Buffered Scans Selection . . . . . . . . . . . . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 7
Section 4 Symbology Menu Section Page Industrial Symbology Selections Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4–1 Codabar Selection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4–2 Code 39 Selection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4–4 Code 93 Selection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4–6 Interleaved 2 of 5 Selection . . . . . . . . . . . . . . . . . . . . . 4–7 Matrix 2 of 5 Selection . .
Inhaltszusammenfassung zur Seite Nr. 8
Section 8 Maintenance and Troubleshooting Section Page Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8–1 Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8–3 Section 9 Customer Service Section Page Obtaining Factory Service . . . . . . . . . . . . . . . . . . . . . . . 9–1 Technical Support . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9–2 Limited Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9–
Inhaltszusammenfassung zur Seite Nr. 9
Section 1 Introduction & Quick Start Menu Introduction Your scanner provides high value performance in an economical, durable solution for a wide variety of bar code data collection applications. The scanner contains Welch Allyn’s Instant Interface module, which integrates aggressive (“snappy”) decoding, advanced data editing and formatting capabilities, and multiple interface connectivity. The scanner recognizes and decodes 14 industry-standard bar code symbologies. The scanner can be programm
Inhaltszusammenfassung zur Seite Nr. 10
Scanner Identification Manufactured Month/Year Model Number 5X00/A-12 Serial Number 12345 Rev = 1.1=B=A SCANTEAM 5700 Identification Label Model Number 5X00/A–12 ➊ ➋➌ Engine Type AutoTrigger Option ➊➋ A = Increased 0 = Hands Free AutoTrigger Feature Not Included Performance 1 = Hands Free AutoTrigger Feature Included HD = High Density ALR = Advanced Long Range Interface Option ➌ IBM OCIA Bar Image Wand TTL True Keyboard RS–232 Option 4683 OCR Laser Out Emulation RS–232 RS–232 Wedge Wedge 0* 1
Inhaltszusammenfassung zur Seite Nr. 11
Connecting the Scanner Install the scanner by following the steps shown below: ➊ Turn off the power to the host system. ➋ Connect the interface cable to the scanner and to the terminal/computer. 3 Disconnect 2 Keyboard Wedge Interface Example 1 (Cable, Keyboard, and Terminal will vary.) ➌ Turn on the power to the host system. ➍ Program your scanner to work with your terminal or computer by scanning the Terminal Set–Up Codes. Either scan the Plug and Play codes (Pages 1–7 to 1–10) or use the Sup
Inhaltszusammenfassung zur Seite Nr. 12
In. Cm. Typical Performance at 20°C for 9.65 24.511 SCANTEAM 5700/A 19.3” 5 mil 2.5 3.5 7.5 mil 2 7 13 mil 1 9.65 24.511 14 20mil 1.5 40 mil 18 3.5 26 55 mil 4 31 In. 0 2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 Cm. 0 5.08 10.2 15.2 20.3 25.4 30.5 35.6. 40.6 45.7 50.8 55.9 61 66 71.1 76.2 81.3 Typical Depth of Field in Inches/Centimeters 1–4 SCANTEAM 5700 User’s Guide
Inhaltszusammenfassung zur Seite Nr. 13
Typical Performance at 20°C for SCANTEAM 5700/HD In. Cm. 2 5.08 1 2.54 2.8” 2.0” 3” 00 1 2.54 3 mil 1.0 2.5 5 mil 2 5.08 .5 4.0 7.5 mil .5 4.5 10 mil .5 5.5 13 mil 1.0 6.0 In. 0 1 2 3 4 5 6 Cm. 0 2.54 5.08 7.62 10.16 12.7 15.24 Typical Depth of Field in Inches/Centimeters SCANTEAM 5700 User’s Guide 1–5
Inhaltszusammenfassung zur Seite Nr. 14
Typical Performance at 20°C for SCANTEAM 5700ALR In. Cm. 41 104.1 30 76.2 20 50.8 10 25.4 00 10 25.4 20 50.8 15 mil 22 30 76.2 43 30 mil 40 88 55 mil 41 104.1 25 99 100 mil 123 322 In. 0 30 60 90 120 150 180 210 240 270 300 330 360 Cm. 0 76.2 152.4 228.6 304.8 381.0 457.2 533.4 609.6 685.8 762.0 838.2 914.4 Typical Depth of Field in Inches/Centimeters 70 mil retroreflective – 68” (172.7 cm) – 13.5’ (411.5 cm) 100 mil retroreflective – 82” (208.3 cm) – 17.5’ (533.4 cm) 1–6 SCANTEAM 5700 User’s Gu
Inhaltszusammenfassung zur Seite Nr. 15
IBM PC, Wand Emulation Interface IBM PC AT and Compatibles Interface (Default) (also PS/2 30-286, 50, 55SX, 60, 70, 70-061, 70-121, 80) IBM PS/2 and Compatibles Interface ( for PS/2 25, 30 models) IBM PC XT and Compatibles Interface These bar codes also program a carriage return (CR) suffix. Wand Emulation (Code 39 Format) Interface Wand Emulation (Same Code Format) Interface
These bar c
Inhaltszusammenfassung zur Seite Nr. 16
IBM 4683 Interface IBM 4683 Port 5B Interface IBM 4683 Port 9B HHBCR–1 Interface IBM 4683 Port 9B HHBCR–2 Interface IBM 4683 Port 17 Interface These bar codes also program the following parameters: Symbology Suffix Symbology Prefix EAN 8 0C Code 39 00 0A 0B EAN 13 16 I 2 of 5 00 0D 0B UPC A 0D Code 128 00 18 0B UPC E 0A 1–8 SCANTEAM 5700 User’s Guide
Inhaltszusammenfassung zur Seite Nr. 17
OCIA Interface Spectra-Physics OCIA Interface The bar code above also programs the following parameters: Symbology Suffix Symbology Prefix EAN 8 06 06 UPC A 01 EAN 13 06 UPC E 05 NCR OCIA Short Form Format (Eight Bit) Interface The bar code above also programs the following parameters: Symbology Suffix Symbology Prefix EAN 8 0F 0F UPC A 0A EAN 13 0F UPC E 0E NCR OCIA Long Form Format (Nine Bit) Interface The bar code above also programs the following parameters: Symbology Suffix Symbology Pref
Inhaltszusammenfassung zur Seite Nr. 18
OCR, RS232 Interface Fujitsu OCR Interface The bar code above also programs the following parameters: Symbology Suffix Symbology Prefix EAN 8 17 UPC A 17 EAN 13 17 UPC E 17 I 2 of 5 03 (Application Dependent) IBM OCR (Port 21) Interface The bar code above also programs the following parameters: Symbology Suffix Symbology Prefix EAN 8 0C UPC A 0D EAN 13 16 UPC E 0A Code 128 1D RS-232 Interface The bar code above also programs the following parameters: Programmable Option Setting Baud Rate 9600 b
Inhaltszusammenfassung zur Seite Nr. 19
If your terminal is not one of the Plug and Play options, you must program one of the terminals listed below. To program the terminal interface, scan the Program Terminal Interface bar code below, then scan the appropriate two digit Terminal I.D. code from the Programming Chart on the inside back cover of this manual. Program Terminal Interface Supported Terminals Terminal Model(s) Terminal I.D. ADI 1496 72 Apple Desktop Bus ADB MAC Classic, SE SE30, II (All) 49 Bull BDS–7 (HDS–7) 35 Burroughs
Inhaltszusammenfassung zur Seite Nr. 20
Supported Terminals Terminal Model(s) Terminal I.D. ICL 300 77 IDEAS 08 ITT 9271 07 Lee Data IIS 07 Link MC–5 18 Mac 49 OCIA 52 OCR 53 Olivetti M19, M24, M28, M200 01 Olivetti 240, 250, 290, 380, P500 03 Qume ANSI QVT 61, 62, 70, 191, 321, 322 82 Qume ASCII QVT 31, 51, 61, 62, 70, 191 74 Qume Enhanced PC QVT 61, 62, 70, 82, 191, Qx15 38 RS232 True 00 RS232 TTL 00 Serial Wedge 50 Siemens 9758 (German Only) 34 Stratus V103 14 Televideo 955, 965 36 Telex 88 Key 078A, 078, 79, 80, 191, 196, 25 1191,
