Bedienungsanleitung Ryobi 4060310

Inhaltszusammenfassung zur Seite Nr. 1

OPERATOR'S MANUAL
Miter Slot Table
4060310
(For use with BT3000 & BT3100 Table Saws)
Your new miter slot table has been engineered and manufactured to Ryobi's high standard for dependability, ease
of operation and operator safety. Properly cared for, it will give you years of rugged, trouble-free performance.
WARNING: To reduce the risk of injury, the user must read and understand the operator’s manual.
Thank you for buying a Ryobi accessory kit.
SAVE THIS MANUAL FOR FUTURE REFERENCE

Inhaltszusammenfassung zur Seite Nr. 2

RULES FOR SAFE OPERATION Safe operation of this accessory requires that you read ■ ALWAYS WEAR SAFETY GLASSES WITH SIDE and understand this operator's manual, the operator’s SHIELDS. Everyday eyeglasses have only impact- manual for the table saw and all labels affixed to the tool. resistant lenses; they are NOT safety glasses. ■ DO NOT USE THIS PRODUCT WITH OTHER READ ALL INSTRUCTIONS EQUIPMENT or for other purposes. ■ KNOW YOUR ACCESSORY. Read the operator's ■ ALWAYS DISCONNECT THE SAW FROM TH

Inhaltszusammenfassung zur Seite Nr. 3

UNPACKING INFORMATION WARNING: ■ Remove the loose parts from the box. Make sure that all items listed in the loose parts list are in- If any parts are missing, replace the missing parts cluded . before assembling the kit. Failure to do so could result in serious personal injury. ■ Inspect all parts carefully to make sure no breakage or damage occurred during shipping. LOOSE PARTS LIST ■ If any parts are damaged or missing, please call 1-800-525-2579 for assistance. 1. Miter Slot Table 2. Shims (

Inhaltszusammenfassung zur Seite Nr. 4

TOOLS NEEDED 7/16 in. NUT DRIVER 3/16 in. HEX KEY Fig. 2 ASSEMBLY INSTALLING THE MITER SLOT TABLE WARNING: See Figure 3. The table saw should never be connected to a power ■ Turn the ON/OFF switch to the OFF position. supply while you are assembling parts. Disconnect- ■ Unplug the saw from the switched on-board outlet. ing the table saw will prevent accidental starting that ■ Disconnect the saw from the power supply. could cause serious personal injury. ■ Remove the sliding miter table a

Inhaltszusammenfassung zur Seite Nr. 5

ASSEMBLY REAR VIEW 1/4-20 x 1 in. MITER HEX CAP SCREW SLOT TABLE PLACE SHIMS AS SHOWN SHIMS WASHER 1/4-20 NUT FRONT VIEW Fig. 4 ALIGNING THE MITER SLOT TABLE MITER 1/4-20 x 1 in. See Figure 4. SLOT TABLE HEX CAP SCREW ■ Place the miter slot table on the saw as shown in Figure 4. ■ Extend a straight edge across the saw table onto the miter slot table and note any space between the straight edge and the miter slot table. If space ex- ists, place one of the shims under the miter slot WASHER table

Inhaltszusammenfassung zur Seite Nr. 6

OPERATOR'S MANUAL Miter Slot Table 4060310 WARRANTY Ryobi warrants its accessories for a period of 90 days from the date of purchase. Batteries and chargers are warranted for a period of two years from the date of purchase. PARTS AND SERVICE For parts or service, contact your nearest Ryobi authorized service center. Be sure to provide all relevant information when you call or visit. For the location of the authorized service center nearest you, please call 1-800-525-2579 or visit us online at ww