Bedienungsanleitung Elektra Beckum BAS 500 WNB

Inhaltszusammenfassung zur Seite Nr. 1

Betriebsanleitung Bandsäge
D
Operating Instructions for Band Saw
ENG
BAS 500 WNB
D
Achtung! Lesen Sie diese Anleitung vor der Installation und Inbetriebnahme aufmerksam durch.
ENG Attention! Carefully read through these instructions prior to installation and commissioning.
115 168 8051 / 3602 - 1.0 de, en

Inhaltszusammenfassung zur Seite Nr. 2

Inhaltszusammenfassung zur Seite Nr. 3

ENG GENERAL SAFETY INFORMATION As with all power tools there is a certain amount of hazard 18. ADJUST BLADE TENSION, upper and lower blades involved with the operator and his use of the machine. guides, thrust bearings and blade tracking correctly. Using the machine with the respect and caution 19. DOORS AND BLADE GUARD must be in place and demanded as far as safety precautions are concerned securely fastened when performing saw operations. will considerably lessen the possibility of personal in

Inhaltszusammenfassung zur Seite Nr. 4

function which results from improper use or unauthorized Contents modification from standard specifications, faulty 1 General maintenance, damage or improper repair by anyone 2 Specifications other than qualified persons approved by Elektra Beckum 3 Machine Installation or its representatives. 4 Blade Speed Selection Elektra Beckum reserves the right to change 5 Band Saw Setup specifications and design without prior notice and 6 Safety Rules without incurring obligation of any kind. 7 Additional

Inhaltszusammenfassung zur Seite Nr. 5

● Adjust the hex. head screw of the stop to set the table 5 Band Saw Setup exactly square with the blade. Blade Speed Change ● After the stop is adjusted, stick the rip fence scale (89) To change the cutting speed, the V-belts must be changed to the rip fence carrier (201). on the pulleys as shown in the table inside the lower wheel housing door. For an easy belt change a quick-action tensioning device is provided, actuated by the handwheel (20) at the lower right hand side of the wheel housing.

Inhaltszusammenfassung zur Seite Nr. 6

Saw Table Tilt 7 Additional Information - For bevel cuts the table can be tilted up to 45°. Loosen For this band saw a range of optional accessories is the wing nut (135) of the table trunnion assembly, tilt available. Both the band saw and the accessories are the table to the required position and retighten the wing only to be used for operations as described in this nut. Make trial cut in a piece of scrap wood to verify manual or in the instructions supplied with the setting to desired angle.

Inhaltszusammenfassung zur Seite Nr. 7

10 Dust collection 12 U.K. Supplement to Operating Caution! Dust of certain wood spezies is carcinogenic. Instructions for Elektra Beckum Band ➜ When operating your woodworking machine indoors Saw BAS 500 connect to a dust collector. ➜ If a woodworking machine is operated indoors for Please note the following supplementary information more than 30 minutes, it is mandatory to connect it to a associated with this machine: dust collector. U.K. Legislation and Codes of Practice Important information