Bedienungsanleitung Audiovox AX-2K4MSFL

Inhaltszusammenfassung zur Seite Nr. 1

Model AX-2K4 AX-2K4S,
AX-2K4MS, & AX-2K4MSFL
Transmitter Programming Guide
These transmitters makes use of icons (symbols) to identify the reac-
tion your security system/keyless entry/and or remote start system,
where applicable, will have when any icon (button) is pressed.
These icons are programmed at time of installation to meet the needs of
the individual and to complement the vehicle that the system is installed
in. To replace a transmitter or add transmitters, please follow the
programmi

Inhaltszusammenfassung zur Seite Nr. 2

Some of the more popular options available for the unused Option Buttons of your transmitter are: AS 9554 Remote Garage Door Interface AS 9075 Remote car starter AS 9153 Remote window roll up AS 9256 Remote trunk release relay Although the most common use of the transmitter buttons are shown on the front page of this guide, any button or button combination can be programmed into any receiver channel. Additionally, if all 4 buttons are used and you require access to a 5th channel, you would pro

Inhaltszusammenfassung zur Seite Nr. 3

channel 2. The siren will chirp 2 times and the dash mounted LED will Flash 2 times, indicating that the unit is ready to accept programming for channel # 2 which is only used for separate lock and unlock button transmitters, and is the disarm/unlock/unlock 2 and panic. 6) Press and hold the unlock symbol button of the transmitter you wish to program for 4 seconds or until a long chirp is heard from the siren. "Repeat step 6 for each transmitter you wish to program". 7) Press and release the va

Inhaltszusammenfassung zur Seite Nr. 4

button of the first transmitter you wish to remain stored into the control unit until a single chirp is heard from the siren. (Repeat this for each transmitter you wish to remain stored in the control unit). The receiver stores up to four transmitters. To be certain all transmitter slots in the receiver are occupied with transmitters you wish to con- tinue to use, and all others are erased, you will have to fill all four receiver slots. If in step 3 you identified one transmitter, you will hav

Inhaltszusammenfassung zur Seite Nr. 5

The light will turn off when the button is released. Caution! Always point the light away from you and the eyes of others. This is a bright high intensity LED which should not be directed toward or into the eyes of anyone. QUICK REFERENCE CHART: You can program any individual channel without reprogramming all channels. To go directly to a particular receiver channel follow the chart below: CHANNEL VALET SWITCH LED 1 Ign. On Then Press and Release 3 Times 1 Flash 2 Ign. On Then Press and Releas

Inhaltszusammenfassung zur Seite Nr. 6

ORDER FORM FOR AX-2K4 AX-2K4S, AX-2K4MS, AX-2K4MSFL Attention: Transmitter Ordering Department Important: To help us expedite your order, please print all of the infor- mation legibly and mail this form and your payment according to the instructions below. Indicate the pad number of your transmitter selected from the pads shown above. Note: Transmitter model number found on back of case. AX-2K4MSFL Main use PD 110, Side use 111 1)Pad Number:_________________________________ 2)Name: ____________