Bedienungsanleitung Autostart AS-1414

Inhaltszusammenfassung zur Seite Nr. 1

AUTOMATIC T R ANS MISS IO N MULT I-CH A NNEL R E MO T E ST ART ER SY ST EM
AS-1414/ AS-1424
User Guide
Transmitter Part Number and Module Serial Advanced Features...........................................4
Number..............................................................2 Remote Door Locks......................................4
Introduction .......................................................2 Arming the Starter Kill...................................5
Basic Remote Operation...........

Inhaltszusammenfassung zur Seite Nr. 2

Transmitter Part Number and Module Serial Number Transmitter Part Number: ASTR-204 The installer is to write in the boxes below the Module’s serial number and the location of the Valet Switch (If the Valet switch is installed). Module Serial Number: Your Valet Switch is located: Introduction This Module is a state-of-the-art remote car starter system. With many advanced function, this product will satisfy any one of the user’s expectations from high-end commodity systems, without neglecting t

Inhaltszusammenfassung zur Seite Nr. 3

Remote-starting Your Vehicle Press the START/STOP button for approx. 1 second. The parking lights will come ON, informing you that the unit has received your signal. Approx. 5 seconds later, the engine will start. The parking lights will remain ON during the pre-programmed run time. If the vehicle doesn’t start the first time, the system will shut down, wait a few seconds, and try to start the engine again. It will try to start the engine 3 times before giving up. Vehicle Presets Heater a

Inhaltszusammenfassung zur Seite Nr. 4

To ENTER Valet Mode 1. With the key in the Ignition switch, turn the key to the ON (RUN/IGNITION) and then OFF positions 5 times within 10 seconds. 2. The Parking Light will flash 3 times indicating the Module is now in Valet Mode. The LED will turn ON solid. To EXIT Valet Mode 1. With the key in the Ignition switch, turn the key to the ON (RUN/IGNITION) and then OFF positions 5 times within 10 seconds. 2. The Parking Light will flash twice indicating the Module is now out of Valet Mode.

Inhaltszusammenfassung zur Seite Nr. 5

Arming the Starter Kill If installed, the Starter Kill can be programmed to arm in Active Mode (will not arm automatically) or in Passive Mode (will arm automatically). To disarm the Starter Kill in Active or Passive Mode, press the UNLOCK button on the trans- mitter. The parking lights will flash twice. (If Remote Door Locks were installed, this will also unlock the doors.) In Passive Mode, the system will automatically rearm 1 or 3 minutes after the doors were unlocked. To arm the Sta

Inhaltszusammenfassung zur Seite Nr. 6

Starter Kill / Anti-Grind This added security feature will immobilize your vehicle when the system is armed (LOCKED). If your Module was installed with the Starter Kill option, you will not be able to start your vehicle with the key unless the system has been disarmed first (UNLOCKED). The Starter Kill option can be programmed to be ACTIVE (will not arm automatically) or PASSIVE (will arm automatically). In PASSIVE Mode, your installer can program it to arm automatically in 1 or 3 minutes.