Inhaltszusammenfassung zur Seite Nr. 1
TW O-W A Y LED MA N U A L TRA NSMISSIO N
RE M O TE S T A R TE R
User Guide
WARNING
It is the responsibility of the vehicle operator to ensure
their vehicle is parked in a safe and responsible
manner.
1. When leaving the vehicle, it is the user’s responsibility to
ensure that the gearshift lever is in the NEUTRAL position
and the parking brake is engaged in order to avoid accidents
upon remote starting.
2. It is the user's responsibility to ensure that th
Inhaltszusammenfassung zur Seite Nr. 2
Table of Contents Priority Door Access.......................................... 8 Introduction............................................. 2 Ignition-controlled Door Locks........................... 8 Using the Remote Control ...................... 3 Ignition Re-lock.................................................. 8 Vehicle Presets....................................... 3 Secure Lock....................................................... 8 Heater & Heated Seat ........................
Inhaltszusammenfassung zur Seite Nr. 3
Using the Remote Control Your remote starter is equipped with a 5-button multi-channel remote control. It can operate two independent vehicles equipped with a remote starter (see Multi-car operation section on page 10). The functions of the transmitter are as follows: For certain vehicles: • Pressing and holding the LOCK button for more than 3 seconds will lock all doors and will send a constant pulse as long as the LOCK button is held down (maximum of 15 seconds). This constant
Inhaltszusammenfassung zur Seite Nr. 4
of vehicles could cause them to remain ON even after remote starter shut down, resulting in a dead battery. Arming the Starter Kill The Starter Kill (if installed) can be configured by the installer so as to arm automatically (Passive Mode) or not to arm automatically (Active Mode). • To disarm the Starter Kill, press the UNLOCK button on the transmitter. The parking lights will flash twice. If remote door locks are installed, this will also unlock the doors. • To arm the Starter
Inhaltszusammenfassung zur Seite Nr. 5
Remote-starting Press the START/STOP button for approx. 1 second. The parking lights will come ON to inform you that the Remote Car Starter has received your signal. Approximately 5 seconds later, the engine will start. The parking lights will remain ON during the pre-programmed run time of the engine. If the vehicle does not start at the first attempt, the system will shut down. Driving Off With the vehicle running under remote control, press the UNLOCK button to disarm and unlock the
Inhaltszusammenfassung zur Seite Nr. 6
successively into the IGNITION ON / RUN and OFF positions. • The parking lights will flash three times to indicate that the vehicle is now in Valet Mode. The L.E.D. will come ON solid once the ignition key is removed. To take the system o u t o f Valet Mode: • Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times successively into the IGNITION ON / RUN and OFF positions. • The parking lights will flash twice to indicate that the vehicle is now in Valet
Inhaltszusammenfassung zur Seite Nr. 7
• Press the brake pedal. • Press the SHIFT button then press and hold the START/STOP button for 3 sec. (the parking lights will flash once). When the vehicle exits Cold Weather Mode, the Parking Lights will flash once. If Safe Start is enabled, you can activate Cold Weather Mode by • Pressing and releasing the SHIFT button, then • Pressing and holding the START/STOP button until the parking lights flash 3 times. Extended Run Time With the vehicle running under a remote start, pressi
Inhaltszusammenfassung zur Seite Nr. 8
Priority Door Access If the Remote Door Locks option is installed on your vehicle, this safety feature allows you unlock solely the driver’s door with a single press of the UNLOCK button on the transmitter; upon a second press of the UNLOCK button, all the other doors will unlock. Ignition-controlled Door Locks This is an added security feature. If your Remote Car Starter was installed with the Ignition- Controlled Door Locks option, the doors will automatically be locked as soon as the i
Inhaltszusammenfassung zur Seite Nr. 9
• Turn the ignition key to the IGNITION ON (RUN) position. • Within 3 sec., press and release the valet button , the parking lights will flash twice the L.E.D. will turn itself off. Note: Once Valet Mode is activated, the remote starter will be disabled. “Home ValetTM” Mode If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if the vehicle is parked indoors there is no danger of it starting accidentally by remote control. Note: Once t
Inhaltszusammenfassung zur Seite Nr. 10
• Flashing LED ON: the L.E.D. will flash at all times (either under active arming or under passive arming) to indicate that the starter kill is active. • Active Arming: the LED will flash normally. • Passive Arming: the LED will not flash during the countdown preceding the activation of the Starter Kill. Once the Remote Car Starter is armed, the LED will flash at a normal rate. • In Valet Mode: the LED will remain lit without flashing. • Flashing LED OFF: the LED will not flash even whe
Inhaltszusammenfassung zur Seite Nr. 11
Your installer can customize the system as to personalize these multi-level features in an order that best suits you. Your options are: Option 1: Level 1 (requires pressing the SHIFT button 1X) Multi car operation Level 2 (requires pressing the SHIFT button 2X) Basic features Level 3 (requires pressing the SHIFT button 3X) Customized features Option 2: Level 1 (requires pressing the SHIFT button 1X) Basic features Level 2 (requires pressing the SHIFT button 2X) Multi car oper
Inhaltszusammenfassung zur Seite Nr. 12
Status Request When the Engine IS NOT Running STATUS SEQUENCE LED #1 LED #2 LED #3 LED #4 Beep(s) Lock 3 flashes X X X 1 Unlock X 3 flashes X X 2 st 1 sequence if 3 flashes X X X 2 locked Cold st 1 sequence if Weather X 3 flashes X X 2 unlocked nd 2sequence X X X 1 second X st 1 sequence if 3 flashes X X X 2 locked Home st 1 sequence if Valet X 3 flashes X X 2 unlocked nd 2 sequence 1 second X X 1 second X st 1 sequence if 3 flashes X X X 1 locked Valet st 1 seq
Inhaltszusammenfassung zur Seite Nr. 13
Status Request When the Engine is Running When the vehicle doors are locked: The LED # 1 will flash 3 times to denote that the vehicle’s doors are locked. When the vehicle doors are unlocked: The LED # 2 will flash 3 times to denote that the vehicle’s doors are unlocked. RUN TIME Beep(s) LED #1 LED #2 LED #3 LED #4 If there is more than 3/4 of run 3 ON for 1-sec ON for 1-sec ON for 1-sec ON for 1-sec time cycle If there is more than half of 3 ON for 1-sec ON for 1-sec ON for 1-sec X
Inhaltszusammenfassung zur Seite Nr. 14
Diagnostics – Parking Light Flash Table Flashes Description • Doors locked, starter kill armed. • Run time has expired. 1 • TRUNK button pressed. • Start signal received by the module. • Cold weather mode cancelled. • Remote start attempt cancelled by remote. • Doors unlocked, starter kill disarmed. 2 • Exiting ignition valet. • Exiting remote valet. • Power-up reset • Entering cold weather mode. • Entering ignition valet. 3 • Entering remote valet. • Entering extended run time
