Bedienungsanleitung Audiovox Prestige APS-2K4

Inhaltszusammenfassung zur Seite Nr. 1

Model APS-2K4
Transmitter Programming Guide
This transmitter makes use of icons (symbols) to identify the reaction
your security system/keyless entry/and or remote start system, where
applicable, will have when any icon (button) is pressed. These icons
are programmed at time of installation to meet the needs of the individual
and to complement the vehicle that the system is installed in. To replace
a transmitter or add transmitters, please follow the programming
instructions listed on the page

Inhaltszusammenfassung zur Seite Nr. 2

Some of the more popular options available for the unused Option Buttons of your transmitter are: AS 9554 Remote Garage Door Interface AS 9075 Remote car starter AS 9153 Remote window roll up AS 9256 Remote trunk release relay Although the most common use of the transmitter buttons are shown on the front page of this guide, any button or button combination can be programmed into any receiver channel. Additionally, if all 4 buttons are used and you require access to a 5th channel, you would pro

Inhaltszusammenfassung zur Seite Nr. 3

"Repeat step 4 for each transmitter you wish to program". NOTE: If your transmitter button has the Lock/Unlock icon on one button, Press and release the valet push button switch 2 times then move on to step #8. 5) Press and release the valet push button switch one time to advance to channel 2. The siren will chirp 2 times and the dash mounted LED will Flash 2 times, indicating that the unit is ready to accept programming for channel # 2 which is only used for separate lock & unlock button trans

Inhaltszusammenfassung zur Seite Nr. 4

Enter the transmitter program mode: 1. Turn the ignition switch to the “ON” position. 2. Within 10 seconds, press and release the valet/program switch three times. (Siren emits 1 short chirp indicating channel 1 has been entered) 3. Within 10 Seconds, Press and hold the ARM or ARM/DISARM button of the first transmitter you wish to remain stored into the control unit until a single chirp is heard from the siren. (Repeat this for each transmitter you wish to remain stored in the control unit). T

Inhaltszusammenfassung zur Seite Nr. 5

reprogrammed. Any other transmitter stored in the unit’s memory still remain operational. If the button is released and not pressed again within the 5 second period, no change in programming has been made to the receiver channel. The programmer can move onto a different channel or erase the transmitter codes as described in 1 above. QUICK REFERENCE CHART: You can program any individual channel without reprogramming all channels. To go directly to a particular receiver channel follow the char

Inhaltszusammenfassung zur Seite Nr. 6

ORDER FORM FOR TRANSMITTER APS-2K4 Attention: Transmitter Ordering Department Important: To help us expedite your order, please print all of the information legibly and mail this form and your payment according to the instructions below. Indicate the pad number of your transmitter selected from the pads shown above. 1) Pad Number: _____________________________________ 2) Name: __________________________________________ 3) Address: ________________________________________ 4) City: ______________