Inhaltszusammenfassung zur Seite Nr. 1
Website:http://ca.lge.com
Installation Manual
Electric Range
LSC5622W / LSB5611S / LST5601S / LSC5633W
LSC5674W / LSC5683W / LSB5682S / LST5651S
LRE3091S / LSE3094S / LSE3092S
Please read these instructions thoroughly before
installing and operating the range.
P/No.: MFL55646202
Inhaltszusammenfassung zur Seite Nr. 2
Part 1 SAFETY 1 BEFORE YOU BEGIN Remove all tape and packing materials before using the range. Dispose all plastic bags after unpacking the range. Never allow children to play with packing materials. IMPORTANT SAFETY INSTRUCTIONS Read and follow all instructions before using your oven to prevent the risk of fire, electric shock, injury to person, or damage when using the range. This guide don’t cover all possible conditions that may occur. For further assistance contact your service agent or man
Inhaltszusammenfassung zur Seite Nr. 3
Part 1 SAFETY PREPARE TO INSTALL THE RANGE WARNING TOOLS NEEDED • The information in this manual should be followed exactly. - A fire or electrical shock may result causing property damage, personal injury or death. WARNING • DO NOT step or sit on the door. Install the Anti-Tip Bracket packed with range. - The range could be tipped and injury might result from spilled hot liquid, food, or the range itself. - If the range is pulled away from the Safety Glasses wall for cleaning, service, or any
Inhaltszusammenfassung zur Seite Nr. 4
Part 2 PREPARE TO INSTALL THE RANGE 2 INSTALLATION DRAWINGS (LRE Series only) NOTE SAVE FOR THE USE OF THE LOCAL ELECTRICAL INSPECTOR. CLEARANCES AND DIMENSIONS (Figure 1) To install range refer to the following Figure 1. For installation in CANADA, a Free-standing range is not to be installed closer than 12mm from any adjacent surface. CAUTION CAUTION • Make sure that the wall covering, • Cabinet storage space located above the surface units should be avoided. countertop and cabinets around the
Inhaltszusammenfassung zur Seite Nr. 5
Part 2 PREPARE TO INSTALL THE RANGE 2 INSTALLATION DRAWINGS (LSE Series only) NOTE SAVE FOR THE USE OF THE LOCAL ELECTRICAL INSPECTOR. CLEARANCES AND DIMENSIONS (Figure 1) To install range refer to the following Figure 1. For installation in CANADA, a Free-standing range is not to be installed closer than 12mm from any adjacent surface. CAUTION CAUTION • Make sure that the wall covering, • Cabinet storage space located above the surface units should be avoided. countertop and cabinets around the
Inhaltszusammenfassung zur Seite Nr. 6
Part 3 INSTALL THE RANGE 3 ELECTRICAL CONNECTION REQUIREMENTS The range must be installed in accordance with Local and Canadian Electrical Codes (latest edition). See rating plate for total connected Amp rating. This model was shipped direct from the factory with Service cord attached. There are no range connections necessary. Note: Cord replacement Only a range cord rated at 40 amps with 120/240 Use a spirit level to check your adjustments. Place the minimum volt range is required. If a 50 amp