Inhaltszusammenfassung zur Seite Nr. 1
thermaline S90
SOLID TOP GAS COOKERS - FOURNEAUX À PLAQUE COUP DE FEU, GAZ
Doc.
62.9534.01_UL
Edition 1
01.2006
US INSTALLATION- AND OPERATING INSTRUCTIONS page 3
FR INSTRUCTIONS D’INSTALLATION ET D’EMPLOI page 13
FOR YOUR SAFETY POUR VOTRE SÉCURITÉ
Do not store or use gasoline or Ne déposez pas ou n'employez
other flammable vapors or liquids pas l'essence ou d'autres vapeurs
in the vicinity of this or any other ou liquides inflammables à pro-
appliance. ximité de ceci ou d'aucun autre
app
Inhaltszusammenfassung zur Seite Nr. 2
Against wall - contre une paroi Free standing - isolé Connections - Raccordement Gas - Gaz Fig.1 INSTALLATION DRAWINGS - PLANS D'INSTALLATION Doc. 62.9534.01_UL
Inhaltszusammenfassung zur Seite Nr. 3
Free standing - isolé Base operated from both sides - base ulilisable des deux côtés Connections - Raccordement Gas - Gaz Fig.1 INSTALLATION DRAWINGS - PLANS D'INSTALLATION Doc. 62.9534.01_UL
Inhaltszusammenfassung zur Seite Nr. 4
Doc. 62.9534.01_UL
Inhaltszusammenfassung zur Seite Nr. 5
CONTENTS I. GENERAL INFORMATION................................................................................................. 3 II. INSTALLATION INSTRUCTIONS....................................................................................... 5 III. OPERATING INSTRUCTIONS............................................................................................ 9 SOMMAIRE IV. INSTRUCTIONS GÉNÉRALES......................................................................................... 13
Inhaltszusammenfassung zur Seite Nr. 6
Page 2 62.9534.01_UL
Inhaltszusammenfassung zur Seite Nr. 7
GENERAL INFORMATION I . GENERAL INFORMATION 1. INSTRUCTIONS FOR SAFETY AND USE The roasting and baking oven must under no circumstances (not even at the low setting) 1.1 INSTALLATION AND INITIAL OPERATION be operated with a slightly opened door, since the high temperatures can damage the The installation, adjustment and initial opera- control knobs and gas valve. tion of the appliance must be carried out When putting oil, fat, water or ingredients in according to the manufacturer's instructio
Inhaltszusammenfassung zur Seite Nr. 8
GENERAL INFORMATION 2. TECHNICAL DATADATA 1.5 AFTER-SALES SERVICE AND REPAIR In the event of a permanent fault which inter- Width Cooking feres with operation, the appliance must be Gas Depth surface Burner PNC Appli- switched off and disconnected from the oven Appliance type Height ances power supply. inch mm Power in kW To perform maintenance and repairs contact 9CHG584158 WLGWAFOOOO the factory, the factory representative or a 9CHG584160 WLGWAAOOOO local service company. 840 x 740 27.
Inhaltszusammenfassung zur Seite Nr. 9
INSTALLATION INSTRUCTIONS II . INSTALLATION INSTRUCTIONS 1. INSTALLATION 1.3 ASSEMBLING TWO APPLIANCES The appliance is designed for connection to fixed lines. The appliances are suitable for setting up as single appliances or as a group of appliances. They can be set up freely in the room, side by side, at the side and/or at the back against a wall. (3a) Gaps between two appliances or appliance and sidewall should be filled with a FDA approved silicone such as Samco (1) (2) RTV103. (3b) 1
Inhaltszusammenfassung zur Seite Nr. 10
INSTALLATION INSTRUCTIONS 1.4 SIDEWALL (D) 1.6 ASSEMBLING ON CASTORS () (5) (4) () (5) (4) 1 1 (3c) 1 a a b Fig.2 Assemblage of sidewall The assembly kit contains two of each of the following: (3c) hexagonal screws M8x25 (1 / Fig.1), bolts with retaining rings 1 (3c) 1 (2 / Fig.1), mounting links (3 / Fig.1), hexagonal screws M8x16 with serrated washers and hexagonal nuts M8, hexagonal c screws M5 with serrated washers (4 / Fig.2) b and a fastening angle (5 / Fig.2). Fig.4 Assemblage on ca
Inhaltszusammenfassung zur Seite Nr. 11
INSTALLATION INSTRUCTIONS 2.1 FRONT PANELS (A) and (B) 3. DOWNPIPE (1) (3c) (1) 1 a b Fig.6 Front panel Unscrew screws (1 or 3). Also, in the case of a built-in oven, unscrew screws (2 and/or 4) on the inside of the oven. (3) Pull the panel away forwards and downwards. 2.2 CONTROL PANEL (C) Fig. 8 Downpipe (2) c (3c) (3c) Work surfaces with a downpipe (Fig.8a) have the downpipe (1) 1 1 opening on the right-hand side of the appliance. A flexible sili- con hose when installed in the standard
Inhaltszusammenfassung zur Seite Nr. 12
INSTALLATION INSTRUCTIONS 4. GAS CONNECTION Retighten the slotted screw in the measuring nipple. Gas pressure deviation tolerances are laid down by EN 203. If The installation of the gas connection, as well as the laying of the existing gas pressure is outside the given tolerances, the customer's gas line, is only to be carried out by an author- correct combustion can no longer be ensured. Compulsory ised specialist subject to the relevant national and local regula- measures: pressure adjustmen
Inhaltszusammenfassung zur Seite Nr. 13
OPERATING INSTRUCTIONS III . OPERATING INSTRUCTIONS 1. GENERAL To return from the lowest setting ( ) towards the highest setting ( ), push the knob (1, 3 / Fig.9) fully in and turn it An 840 x 740 mm solid top with a burner output of 2 x 7 kW clockwise. can reach a maximum temperature of 842°F (450°C) in the area of the burner. 2.4 INITIAL OPERATION The base unit is equipped with a hygienic area or with a gas The new appliance should be heated up for 30 minutes. roasting and baking oven.
Inhaltszusammenfassung zur Seite Nr. 14
OPERATING INSTRUCTIONS 3.1 GAS BURNER 5. STORAGE SPACE So far as is necessary, the pilot burner and main burner are The storage space (Fig.10) is incorporated into the base unit. cleaned by after-sales service. Recommended accessories: 3.2 FLAME - Shelf holder (1) 2 off. In a visual check, the flames must be dark blue without any - Shelves (2) 1 off. upper yellow or orange tips; they must be stable and soot-free and adhere firmly to the outlets. If there is a lack of primary air, the flame h
Inhaltszusammenfassung zur Seite Nr. 15
OPERATING INSTRUCTIONS 6.1.4 HEATING AND REGULATION 6. GAS-OPERATED ROASTING AND BAKING OVEN Turning the temperature selection switch (2 / Fig. 11) anti- clockwise causes the main burner to ignite automatically. The The roasting and baking oven is integrated in the base unit of oven temperature can be set steplessly and is regulated ther- the range. The oven equipment includes: mostatically. The rotary switch has a scale from 1 to 7. In the - removable grid guides steady state the various sc
Inhaltszusammenfassung zur Seite Nr. 16
OPERATING INSTRUCTIONS 6.5.2 GUIDE TEMPERATURES FOR ROASTING (°C) Type of food being roasted Temperature °F °C Roast beef 536 280 Fillet of veal or pork in pastry 446 230 2 Roast pork or veal 536 280 1 Base plate Saddle of venison or saddle of lamb 536 280 2 Grid guides Meatloaf in the mould 356 180 3 3 Guide Poultry, about 700 - 1500 g 536 280 Pâtés of any type 302 150 6.5.3 INFORMATION ON BAKING 1 • Preheat the oven. • The heating-up time depends on the set temperature. Fig. 13Grid guide •
Inhaltszusammenfassung zur Seite Nr. 17
INSTRUCTIONS GÉNÉRALES I . INSTRUCTIONS GÉNÉRALES 1. CONSIGNES DE SÉCURITÉ ET D'UTILISATION 1.4 TRAVAILLER EN TOUTE SÉCURITÉ 1.1 INSTALLATION ET MISE EN SERVICE On peut se brûler si l'on entre en contact avec les plaques chaudes. Le montage, le réglage et la première mise Une distance de 16 inch (40 cm) minimum en service de l'appareil doivent s'effectuer doit être garantie à l'avant de l'appareil, afin conformément aux instructions du fabricant de permettre l'ouverture en toute sécurité de e
Inhaltszusammenfassung zur Seite Nr. 18
INSTRUCTIONS GÉNÉRALES 1.5 SERVICE-APRÈS-VENTE ET RÉPARATION 2. DONNÉES TECHNIQUES Largeur Super- Four Si un problème persistant empêche le Profondeur ficie Brûleur à gaz Code de fonctionnement correct de l'appareil, mettez- Hauteur Modèle de l'appareil l'appareil le hors tension et débranchez-le. inch mm Puissance en kW Pour toute opération d'entretien ou de répa- 9CHG584158 WLGWAFOOOO ration, adressez-vous au fabricant, à un représentant agréé ou au Service Après- 9CHG584160 WLGWAAOOOO 84
Inhaltszusammenfassung zur Seite Nr. 19
INSTRUCTIONS RELATIVES À L'INSTALLATION II . INSTRUCTIONS RELATIVES À L'INSTALLATION 1. MISE EN PLACE 1.3 ASSEMBLAGE DE DEUX APPAREILS Cet appareil est conçu pour être raccordé à des conduites fixes. Les appareils peuvent être montés individuellement ou en groupe. Ils peuvent être installés de façon indépendante, côte à côte, avec un côté et/ou la partie arrière de l'appareil (3a) reposant contre une paroi. Les interstices entre deux appareils ou entre un appareil et le (1) (2) mur latéral
Inhaltszusammenfassung zur Seite Nr. 20
INSTRUCTIONS RELATIVES À L'INSTALLATION 1.4 PAROI LATERALE (D) 1.6 ASSEMBLAGE SUR ROULETTES () (5) (4) () (5) (4) 1 1 (3c) 1 a a b Fig.2 Montage du paroi latérale Chaque kit d'assemblage comprend respectivement deux vis hexagonales M8 x 25 (1 / Fig.1), des boulons avec circlip (2 (3c) 1 (3c) / Fig.1), des éclisses (3 / Fig.1), des vis hexagonales M8 x 16 1 avec rondelles à denture intérieure et des vis hexagonales M8, des vis hexagonales M5 avec rondelles à denture intérieure (4 c b / Fig.1)
