Inhaltszusammenfassung zur Seite Nr. 1
HT1000
Entertainment Projector
English
User’s Manual
Deutsch
Français
Italiano
Español
Svenska
Inhaltszusammenfassung zur Seite Nr. 2
IMPORTANT INFORMATION RF Interference Safety Cautions Precautions WARNING Please read this manual carefully before using your NEC HT1000 Pro- The Federal Communications Commission does not allow any jector and keep the manual handy for future reference. Your serial num- modifications or changes to the unit EXCEPT those specified ber is located on the bottom of your projector. Record it here: by NEC Soluctions (America), Inc. in this manual. Failure to com- ply with this government regulation cou
Inhaltszusammenfassung zur Seite Nr. 3
C E L ASPECT FREEZE 3D REFORM EFFECTOR PICTURE VIEWER POSITION MAGNIFY SLIDE HELP VOLUME FOLDER PIC-MUTE SLIDE LIST OFF ON POWER VIDEO S-VIDEO COMPONENT RGB AUTO ADJ. DVI SELECT Quick Connect Guide User’s manual Fire and Shock Precautions What's in the Box? 1. Ensure that there is sufficient ventilation and that vents are unob- Make sure your box contains everything listed. If any pieces are miss- ing, contact your dealer. structed to prevent the build-up of heat inside your projector. Allow at
Inhaltszusammenfassung zur Seite Nr. 4
TABLE OF CONTENTS Picture Management .............................................................................. E-38 IMPORTANT INFORMATION ........................................... E-2 Picture ................................................................................................ E-39 Safety Cautions ........................................................................................... E-2 User Adjust (when using User 1 to 4) .................................................
Inhaltszusammenfassung zur Seite Nr. 5
INTRODUCTION NOTE: Composite video standards are as follows: Introduction to the Projector NTSC: U.S. TV standard for video in U.S. and Canada. This section introduces you to your new HT1000 Projector and describes PAL: TV standard used in Western Europe. the features and controls. PAL-N: TV standard used in Argentine, Paraguay and Uruguay. PAL-M: TV standard used in Brazil. Congratulations on Your Purchase of The HT1000 Pro- PAL60: TV standard used for NTSC playback on PAL TVs. jector SECAM: TV
Inhaltszusammenfassung zur Seite Nr. 6
C E L V VID IDE EO O S S-V -VID IDE EO O COMPONENT R RG GB B/D /DV VI I A AU UD DIO IO IN IN SG TRIGGER PC CONTROL VIDEO IN S-VIDEO IN Y Cb/Pb Cr/Pr DVI-D IN RGB IN Focus Ring (See page E-20) Part Names of the Projector Controls (See page E-7) Remote Sensor (See page E-10) Ventilation (inlet) Ventilation (outlet) Built-in Security Slot ( )* Heated air is exhausted from here Zoom Lever (See page E-20) Carrying Handle Adjustable Tilt Foot Lever (See page E-19) Lens Iris Lever (See page E-20) Adju
Inhaltszusammenfassung zur Seite Nr. 7
Top Features 910 4 5 11 2 67 8 12 1 3 1. POWER Button (ON / STAND BY) ( ) 7. ENTER Button Executes your menu selection and activates items selected from the Use this button to turn the power on and off when the main power is supplied and the projector is in standby mode. menu. NOTE: To turn on or off the projector, press and hold this button for a mini- 8. CANCEL Button mum of two seconds. Press this button to exit "Menus". Press this button to return the ad- justments to the last condition whi
Inhaltszusammenfassung zur Seite Nr. 8
Terminal Panel Features 13 12 793511 VIDEO VIDEO S-VIDEO S-VIDEO COMPONENT RGB/DVI RGB/DVI AUDIO IN AUDIO IN SC TRIGGER PC CONTROL VIDEO IN S-VIDEO IN Y Cb/Pb Cr/Pr DVI-D IN RGB IN 10 6 8 41 2 1. RGB IN / Component Input Connector (Mini D-Sub 15 Pin) 10. PC CONTROL Port (Mini DIN 8 Pin) Connect your computer or other analog RGB equipment such as IBM Use this port to connect your PC to control your projector via a serial compatible or Macintosh computers. Use the supplied RGB cable to cable. This
Inhaltszusammenfassung zur Seite Nr. 9
E N T E R U N Part Names of the Remote Control 1. Infrared Transmitter 13. ENTER Button Direct the remote control toward Executes your menu selection and activates items selected from the the remote sensor on the projec- menu. tor cabinet. 14. CANCEL Button 2. LED Press this button to exit "Menus". Press this button to return the ad- Flashes when any button is justments to the last condition while you are in the adjustment or pressed. setting menu. 1 3. POWER ON Button 15. ASPECT Button If the m
Inhaltszusammenfassung zur Seite Nr. 10
Battery Installation Remote Control Precautions 1. Press firmly and slide the battery cover off. • Handle the remote control carefully. • If the remote control gets wet, wipe it dry immediately. •Avoid excessive heat and humidity. • If you will not be using the remote control for a long time, remove the batteries. • Do not place the batteries upside down. • Do not use new and old batteries together, or use different types of batteries together 2. Remove both old batteries and install new ones (A
Inhaltszusammenfassung zur Seite Nr. 11
Screen size (Unit: cm/inch) 406.4(W) X 304.8(H)/160"(W) X 120"(H) 200" 365.8(W) X 274.3(H)/144"(W) X 108"(H) 180" 304.8(W) X 228.6(H)/120"(W) X 90"(H) 150" 243.8(W) X 182.9(H)/96"(W) X 72"(H) 120" 203.2(W) X 152.4(H)/80"(W) X 60"(H) 100" 162.6(W) X 121.9(H)/64"(W) X 48"(H) 80" 121.9(W) X 91.4(H)/48"(W) X 36"(H) 60" 81.3(W) X 61.0(H)/32"(W) X 24"(H) 40" 30" 61.0(W) X 45.7(H)/24"(W) X 18"(H) Lens center INSTALLATION AND CONNECTIONS This section describes how to set up your projector and how to con
Inhaltszusammenfassung zur Seite Nr. 12
Throw Distance and Screen Size The following shows the proper relative positions of the projector and screen. Refer to the table to determine the position of installation. Distance Chart Screen Width Screen Diagonal Screen Height Screen center (B) Screen Bottom (D) Lens Center Throw Angle () Throw Distance (C) B= Vertical distance between lens center and screen center C= Throw distance D= Vertical distance between lens center and bottom of screen α = Throw angle NOTE: Distances may vary +/–5%.
Inhaltszusammenfassung zur Seite Nr. 13
Making Connections Wiring Diagram VCR, DVD Player or LaserDisc Player Video Game To video, S-video, and au- dio inputs on the projector. VIDEO VIDEO S-VIDEO S-VIDEO COMPONENT RGB/DVI RGB/DVI AUDIO IN AUDIO IN SC TRIGGER PC CONTROL VIDEO IN S-VIDEO IN DVI-D IN Y Cb/Pb Cr/Pr RGB IN RGB Signal cable (supplied) To mini D-Sub 15-pin connector on the projector. It is recommended that you use a commercially avail- able distribution amplifier if con- necting a signal cable longer than Component video ca
Inhaltszusammenfassung zur Seite Nr. 14
Connecting Your VCR or Laser Disc Player VIDEO AUDIO IN VIDEO IN S-VIDEO IN or VIDEO VIDEO S-VIDEO S-VIDEO COMPONENT RGB/DVI RGB/DVI AUDIO IN AUDIO IN SC TRIGGER PC CONTROL VIDEO IN S-VIDEO IN Y Cb/Pb Cr/Pr RGB IN DVI-D IN S-VIDEO AUDIO IN Composite video S-video cable (supplied) cable (supplied) Audio equipment Audio cable (supplied) AUDIO IN LR VCR/ Laser disc player AUDIO OUT S-VIDEO OUT RL VIDEO OUT Audio cable (not supplied) Use the supplied composite video cable to connect your VCR or lase
Inhaltszusammenfassung zur Seite Nr. 15
Connecting Your DVD Player COMPONENT AUDIO IN COMPONENT IN VIDEO VIDEO S-VIDEO S-VIDEO COMPONENT RGB/DVI RGB/DVI AUDIO IN AUDIO IN SC TRIGGER PC CONTROL VIDEO IN S-VIDEO IN Y Cb/Pb Cr/Pr DVI-D IN RGB IN Audio cable Audio Equipment (supplied) Component video RCA3 cable (supplied) AUDIO IN LR DVD player AUDIO OUT RL COMPONENT OUT Audio cable (not supplied) You can connect your projector to a DVD player with component output NOTE: Refer to your DVD player's owner's manual for more information abou
Inhaltszusammenfassung zur Seite Nr. 16
C E L Connecting Your PC or Macintosh Computer AUDIO IN RGB IN VIDEO VIDEO S-VIDEO S-VIDEO COMPONENT RGB/DVI RGB/DVI AUDIO IN AUDIO IN SG TRIGGER PC CONTROL VIDEO IN S-VIDEO IN DVI-D IN Y Cb/Pb Cr/Pr RGB IN RGB signal cable (supplied) To mini D-Sub 15-pin connector on the projector. It is recommended that you use a commercially available distribution amplifier if con- Audio cable (not supplied) necting a signal cable longer than the supplied one. PHONE PHONE NOTE: For older Macintosh, use a comm
Inhaltszusammenfassung zur Seite Nr. 17
VIDEO VIDEO S-VIDEO S-VIDEO COMPONENT RGB/DVI RGB/DVI AUDIO IN AUDIO IN SG TRIGGER PC CONTROL VIDEO IN S-VIDEO IN Y Cb/Pb Cr/Pr DVI-D IN RGB IN When Viewing a DVI Digital Signal: AUDIO IN DVI-D IN VIDEO VIDEO S-VIDEO S-VIDEO COMPONENT RGB/DVI RGB/DVI AUDIO IN AUDIO IN SC TRIGGER PC CONTROL VIDEO IN S-VIDEO IN Y Cb/Pb Cr/Pr RGB IN DVI-D IN Audio cable (not supplied) DVI-D Signal cable (not supplied) PHONE To project a DVI digital signal, be sure to connect the PC and the projec- NOTE: tor using a
Inhaltszusammenfassung zur Seite Nr. 18
E E E N N N T T T E E E R R R U U U N N N PROJECTING AN IMAGE (BASIC OPERATION) This section describes how to turn on the projector and to project a 2. Press the ENTER button to execute the selection. picture onto the screen. Turning on the Projector NOTE: • When plugging in or unplugging the supplied power cable, make sure that the SELECT main power switch is pushed to the off[O] position. Failure to do so may cause damage to the projector. • The projector has two power switches: main power swi
Inhaltszusammenfassung zur Seite Nr. 19
C C E E L L Selecting a Source Adjusting the Picture Size and Position Place your projector on a flat level surface and ensure that the projector is square to the screen. Selecting the computer or video source Using the Remote Control Lift the front edge of the projector to center the image vertically. OFF ON POWER VIDEO S-VIDEO COMPONENT RGB AUTO ADJ. DVI Press any one of the VIDEO, S-VIDEO, COM- PONENT, RGB, DVI or VIEWER buttons. ASPECT FREEZE 3D REFORM EFFECTOR PICTURE VIEWER POSITION MAGNIF
Inhaltszusammenfassung zur Seite Nr. 20
VIDEO VIDEO S-VIDEO S-VIDEO COMPONENT RGB/DVI RGB/DVI AUDIO AUDIO IN IN SG TRIGGER PC CONTROL VIDEO IN S-VIDEO IN Y Cb/Pb Cr/Pr DVI-D IN RGB IN The rear foot height can be changed. Rotate the rear foot to the desired Correcting the Horizontal and Vertical Key- height, but the vertical distance from the bottom to the desk or floor stone Distortion (3D Reform) should be 1" (25 mm) to make the projector horizontal on the flat sur- face. Use the 3D Reform feature to correct keystone (trapezoidal) di
