Inhaltszusammenfassung zur Seite Nr. 1
Copyright
This publication, including all photographs, illustrations and software, is protected under international copy-
right laws, with all rights reserved. Neither this manual, nor any of the material contained herein, may be
reproduced without written consent of the author.
© Copyright 2008
Disclaimer
The information in this document is subject to change without notice. The manufacturer makes no repre-
sentations or warranties with respect to the contents hereof and specifically discl
Inhaltszusammenfassung zur Seite Nr. 2
DLP Projector—User’s Manual DLP Projector—User’s Manual DLP Projector—User’s Manual Important Safety Information Important: It is strongly recommended that you read this section carefully before using the projector. These safety and usage instructions will ensure that you enjoy many years of safe use of the projector. Keep this manual for future reference. Symbols Used Warning symbols are used on the unit and in this manual to alert you of hazardous situations. The following styles ar
Inhaltszusammenfassung zur Seite Nr. 3
Preface Preface Preface Power Safety Only use the supplied power cord. Do not place anything on the power cord. Place the power cord where it will not be in the way of foot traffic. Remove the batteries from the remote control when storing or not in use for a prolonged period. Replacing the Lamp Replacing the lamp can be hazardous if done incorrectly. See Replacing the Projection Lamp on page 34 for clear and safe instructions for this procedure. Before replacing the lamp: Unpl
Inhaltszusammenfassung zur Seite Nr. 4
DLP Projector—User’s Manual DLP Projector—User’s Manual DLP Projector—User’s Manual Main Features • Lightweight unit, easy to pack away and transport. • Compatible with all major video standards including NTSC, PAL, and SECAM. • A high brightness rating allows for presentations in daylight or in lit rooms. • Supports resolutions up to SXGA+ at 16.7 million colors to deliver crisp, clear images. • Flexible setup allows for front, rear projections. • Line-of-vision projections remain squa
Inhaltszusammenfassung zur Seite Nr. 5
Preface Preface Preface Table of Contents GETTING STARTED...............................................................................................................................................................1 PACKING CHECKLIST................................................................................................................................................................1 VIEWS OF PROJECTOR PARTS......................................................................
Inhaltszusammenfassung zur Seite Nr. 6
DLP Projector—User’s Manual DLP Projector—User’s Manual DLP Projector—User’s Manual AUDIO PROBLEMS ................................................................................................................................................................. 41 HAVING THE PROJECTOR SERVICED ..................................................................................................................................... 41 SPECIFICATIONS .................................................
Inhaltszusammenfassung zur Seite Nr. 7
DLP Projector – User’s Manual DLP Projector – User’s Manual DLP Projector – User’s Manual GETTING STARTED Packing Checklist Carefully unpack the projector and check that the following items are included: DP825MS DLP PROJECTOR D820MS / D825MX DLP PROJECTOR REMOTE CONTROL RGB CABLE POWER CORD RGB TO COMPONENT (WITH ONE AAA BATTERY) ADAPTER (OPTIONAL) CARRYING CASE CD-ROM (THIS USER’S MANUAL) Contact your dealer immediately if any items are missing, appear d
Inhaltszusammenfassung zur Seite Nr. 8
DLP Projector—User’s Manual DLP Projector—User’s Manual DLP Projector—User’s Manual Views of Projector Parts D825MS / D820MS / D825MX Front-right View ITEM LABEL DESCRIPTION SEE PAGE: IR receiver Receive IR signal from remote control 1. 6 Height-adjuster button Push to release height adjuster 2. 15 Height adjuster Adjusts level of projector 3. Lens cap Protect lens when not in use 4. Lens Projection Lens 5. Focus ring Focuses the projected image 6. 16 Zoom ring E
Inhaltszusammenfassung zur Seite Nr. 9
DLP Projector – User’s Manual DLP Projector – User’s Manual DLP Projector – User’s Manual Top view—On-screen Display (OSD) buttons and LEDs SEE ITEM LABEL DESCRIPTION PAGE: Turns the projector On or Off 1. 11 (POWER) SOURCE Detects the input device 2. 10 AUTO Optimizes image size, position, and resolution 3. ▲ (Up cursor) / Navigates and changes settings in the OSD 4. KEYSTONE Quick Menu – For Keystone 18 Navigates and changes settings in the OSD ► (Right cursor) / VO
Inhaltszusammenfassung zur Seite Nr. 10
DLP Projector—User’s Manual DLP Projector—User’s Manual DLP Projector—User’s Manual Rear view ITEM LABEL DESCRIPTION SEE PAGE: 1. AC IN Connect the POWER CABLE 11 Connect the USB CABLE from a computer 2. (USB) S-video Connect the S-VIDEO CABLE from a video device 3. 4. Video Connect the COMPOSITE CABLE from a video device 10 Audio-in Connect the AUDIO CABLE from the input device 5. Connect the RGB CABLE from a computer and compo- VGA 6. nents RS-232 Connect RS-232 s
Inhaltszusammenfassung zur Seite Nr. 11
DLP Projector – User’s Manual DLP Projector – User’s Manual DLP Projector – User’s Manual Bottom view ITEM LABEL DESCRIPTION SEE PAGE: Ceiling support holes Contact your dealer for information on mounting the projector on a ceiling 1. Tilt adjustor Rotate adjuster lever to adjust angle position. 2. 15 Lamp cover Remove when changing the lamp. 3. 34 Height adjustor Adjuster drops down when adjuster button is pushed. 4. 15 Height adjustor button Push to release adjustor. 5.
Inhaltszusammenfassung zur Seite Nr. 12
DLP Projector—User’s Manual DLP Projector—User’s Manual DLP Projector—User’s Manual Remote Control Parts Important: 1. Avoid using the projector with bright fluorescent lighting turned on. Certain high-frequency fluo- rescent lights can disrupt remote control operation. 2. Be sure nothing obstructs the path between the remote control and the projector. If the path be- tween the remote control and the projector is obstructed, you can bounce the signal off certain reflective surfaces su
Inhaltszusammenfassung zur Seite Nr. 13
DLP Projector – User’s Manual DLP Projector – User’s Manual DLP Projector – User’s Manual ITEM LABEL DESCRIPTION SEE PAGE: IR transmitter Transmits signals to projector 1. Status LED Lights when the remote control is used 2. Laser Press to operate the on-screen pointer 3. Up Up arrow when connected through USB to a PC 4. Right Right arrow when connected through USB to a PC 5. Down Down arrow when connected through USB to a PC 6. Page Down Page down when connected through
Inhaltszusammenfassung zur Seite Nr. 14
DLP Projector—User’s Manual DLP Projector—User’s Manual DLP Projector—User’s Manual Remote Control Operating Range The remote control uses infrared transmission to control the projector. It is not necessary to point the remote directly at the projector. Provided you are not holding the remote perpendicular to the sides or the rear of the projector, the remote will function well within a radius of about 7 meters (23 feet) and 15 degrees above or below the projector level. If the projector
Inhaltszusammenfassung zur Seite Nr. 15
SETUP AND OPERATION Inserting the Remote Control Batteries Remove the battery compartment cover 1. by sliding the cover in the direction of the arrow. Insert the battery with the positive side 2. facing up. Replace the cover. 3. Caution: 1. Only use AAA batteries (Alkaline batteries are recommended). 2. Dispose of used batteries according to local ordinance regulations. 3. Remove the batteries when not using the projector for prolonged periods. — 9 —
Inhaltszusammenfassung zur Seite Nr. 16
DLP Projector—User’s Manual DLP Projector—User’s Manual DLP Projector—User’s Manual Connecting Input Devices A PC or notebook computer and video devices can be connected to the projector at the same time. Video devices include DVD, VCD, and VHS players, as well as movie camcorders and digital still cameras. Check the user manual of the connecting device to confirm it has the appropriate output connector. ITEM LABEL DESCRIPTION Connect the USB CABLE from a computer. (USB) A S-vide
Inhaltszusammenfassung zur Seite Nr. 17
DLP Projector – User’s Manual DLP Projector – User’s Manual DLP Projector – User’s Manual Starting and Shutting down the Projector Connect the power cord to the projector. 1. Connect the other end to a wall outlet. The POWER and READY LEDs on the projector light. Turn on the connected devices. 2. Ensure the READY LED displays a 3. solid orange and not a flashing orange. Then press the POWER button to turn on the projector. The projector splash screen displays and conne
Inhaltszusammenfassung zur Seite Nr. 18
DLP Projector—User’s Manual DLP Projector—User’s Manual DLP Projector—User’s Manual When the “Power Off? /Press Power 5. again” message appears, press the POWER button. The projector turns off. Caution: 1. Be sure to remove the lens cap before starting projector. 2. Do not unplug the power cord until the READY LED stops flashing–indicating the projector has cooled down. – 12 –
Inhaltszusammenfassung zur Seite Nr. 19
DLP Projector – User’s Manual DLP Projector – User’s Manual DLP Projector – User’s Manual Setting an Access Password (Security Lock) You can use the four (arrow) buttons to set a password and prevent unauthorized use of the projec- tor. When enabled, the password must be entered after you power on the projector. (See Navigating the OSD on page 18 and Setting the OSD Language on page 19 for help on using OSD menus.) Important: Keep the password in a safe place. Without the password, you w
Inhaltszusammenfassung zur Seite Nr. 20
DLP Projector—User’s Manual DLP Projector—User’s Manual DLP Projector—User’s Manual You can use the cursor buttons ▲▼◄► 5. either on keypad or IR remote control for password entry. You can use any combination including the same arrow five times, but not less than five. Press the cursor buttons in any order to set the password. Push the MENU button to exit the dialog box. The password confirm menu appears when 6. user presses the power-on key in case the Security Lock is enab
