Inhaltszusammenfassung zur Seite Nr. 1
Inhaltszusammenfassung zur Seite Nr. 2
User’s Manual Planar Systems, Inc. Corporate Headquarters 1195 NW Compton Drive Beaverton, OR 97006-1992 Planar Customer Support Telephone: US: 1-866-PLANAR1 (866) 752-6271 Outside US: (503) 748-5799 E-mail: PlanarSupport@planar.com Online Technical Library: http://www.planar.com/support Hours: M-F, 8am - 8pm ET, 12pm - 12am GMT — i —
Inhaltszusammenfassung zur Seite Nr. 3
Preface Copyright This publication, including all photographs, illustrations and software, is protected under international copy- right laws, with all rights reserved. Neither this manual, nor any of the material contained herein, may be reproduced without written consent of the author. © Copyright June, 2006 Disclaimer The information in this document is subject to change without notice. The manufacturer makes no repre- sentations or warranties with respect to the contents hereof an
Inhaltszusammenfassung zur Seite Nr. 4
DLP®Projector – User’s Manual Important Safety Information Congratulations on purchasing the Planar DLP® projector! Important: It is strongly recommended that you read this section carefully before using the projector. These safety and usage instructions will ensure that you enjoy many years of safe use of the projector. Keep this manual for future reference. Symbols Used Warning symbols are used on the unit and in this manual to alert you of hazardous situations. The following styles
Inhaltszusammenfassung zur Seite Nr. 5
Preface Power Safety Only use the supplied power cord. Do not place anything on the power cord. Place the power cord where it will not be in the way of foot traffic. Remove the batteries from the remote control when storing or not in use for a prolonged period. Replacing the Lamp Replacing the lamp can be hazardous if done incorrectly. Refer to “Replacing the Projection Lamp” on page 35 for clear and safe instructions for this procedure. Before replacing the lamp: Unplug the
Inhaltszusammenfassung zur Seite Nr. 6
DLP®Projector – User’s Manual Main Features • Lightweight unit, easy to pack away and transport • Compatible with all major video standards including NTSC, PAL, and SECAM • A high brightness rating allows for presentations in daylight or in lit rooms • Supports resolutions up to SXGA+ at 16.7 million colors to deliver crisp, clear images • Flexible setup allows for front , rear & ceiling mounted projections • Line-of-vision projections remain square, with advanced keystone correction for
Inhaltszusammenfassung zur Seite Nr. 7
Preface Table of contents Getting Started......................................................................................................................................................1 Packing Checklist................................................................................................................................................1 Views of Projector Parts...............................................................................................................
Inhaltszusammenfassung zur Seite Nr. 8
DLP®Projector – User’s Manual PR5020 Projection distance and size table...................................................................................................45 Timing Mode Table ...........................................................................................................................................46 Projector Dimensions........................................................................................................................................47 Regu
Inhaltszusammenfassung zur Seite Nr. 9
Getting Started Packing Checklist Carefully unpack the projector and check that the following items are included: DLP® projector Remote control (with two AAA batteries) Power cord USB cable Composite video cable Computer cable (USB type A-to-B USB) (RCA 3-to-RCA 3) (VGA-VGA) Audio cable CD-ROM (This User’s Users GUIDE Carrying case (mini jack-to-mini jack) manual) Contact your dealer immediately if any items are missing, appear damaged, or if the unit does
Inhaltszusammenfassung zur Seite Nr. 10
DLP®Projector – User’s Manual Views of Projector Parts Front-right View Item Label Description See page: 1. Focus Focuses the projected image 19 2. Lens zoom Enlarges the projected image 19 3. Screws Holds lamp to projector 4. See “Top view—OSD buttons and LEDs” 3 5. Front IR receiver Receiver for IR signal from remote control 8 6. Lens Slide lens cap before use. 7. Lens cover Slide across to protect lens when not in use – 2 –
Inhaltszusammenfassung zur Seite Nr. 11
DLP® Projector – User’s Manual Item Label Description See page: 8. Height-adjuster but- Push to release height adjuster 18 ton Important: Ventilation openings on the projector allow for good air circulation, which keeps the projector lamp cool. Do not obstruct any of the ventilation openings. Top view—On-screen Display (OSD) buttons and LEDs Item Label Description See page: Keystone/ Corrects image-trapezoid (wider bottom) effect 1. 21 Down cursor Navigates and changes setting
Inhaltszusammenfassung zur Seite Nr. 12
DLP®Projector – User’s Manual Item Label Description See page: Enter Changes settings in the OSD 6. 21 7. VOL+/ Increases volume 21 Right cursor Navigates and changes settings in the OSD 8. Auto Optimizes image size, position, and resolution Navigates and changes settings in the OSD 9. Menu Opens and exits the OSD 14 10. Source Detects the input device 11. Power Turns the projector on or off – 4 –
Inhaltszusammenfassung zur Seite Nr. 13
DLP® Projector – User’s Manual Rear view Item Label Description See page: Rear IR receiver Receiver for IR signal from remote control 1. 8 DVI-D 2. Connect a DVI-D cable (not supplied) from a com- (For PR5020 puter only) VGA IN Connect a VGA cable (supplied) from a computer 3. VGA OUT Connect to a monitor (not supplied) 4. S-video Connect the S-video cable (not supplied) from a video 5. device Video Connect a composite video cable (supplied) from a 6. video device. 12
Inhaltszusammenfassung zur Seite Nr. 14
DLP®Projector – User’s Manual Item Label Description See page: Power Connect the power cord (supplied) 13. 14 Security Lock Secure to permanent object with a Kensington® Lock 14. 39 system Note: If your video equipment has both S-video and RCA jacks (composite video) connect to the S-video connector. S-video provides a better quality signal. Bottom view Item Label Description See page: Ceiling support Contact your dealer for information on mount- 1. holes ing the proje
Inhaltszusammenfassung zur Seite Nr. 15
DLP® Projector – User’s Manual Tilt adjuster Adjust angle of the picture 4. – 7 –
Inhaltszusammenfassung zur Seite Nr. 16
DLP®Projector – User’s Manual Remote Control Parts Important: 1. Avoid using the projector with bright fluorescent lighting turned on. Certain high-frequency fluores- cent lights can disrupt remote control operation. 2. Be sure nothing obstructs the path between the remote control and the projector. If the path between the remote control and the projector is obstructed, you can bounce the signal off certain reflective sur- faces such as projector screens. 3. The buttons and keys on t
Inhaltszusammenfassung zur Seite Nr. 17
DLP® Projector – User’s Manual Item Label Description See page: Right cursor 8. Adjusts volume Down cursor 21 9. Volume +/- 10. Mute Mutes the built-in speaker 11. 20 Zoom+ Zoom in 12. Zoom- Zoom out 13. Freeze Freeze/unfreezes the on-screen picture 14. Blank Makes the screen blank 15. Source Detects the input device 16. Auto Auto adjustment for phase, tracking, size, position 17. Menu Opens the OSD 18. Status Opens the OSD Status menu (the menu only 19
Inhaltszusammenfassung zur Seite Nr. 18
DLP®Projector – User’s Manual Remote Control Operating Range The remote control uses infrared transmission to control the projector. It is not necessary to point the remote directly at the projector. Provided you are not holding the remote perpendicular to the sides or the rear of the projector, the remote will function well within a radius of about 10 meters (33 feet) and 30 degrees above or below the projector level. If the projector does not respond to the remote control, move a little
Inhaltszusammenfassung zur Seite Nr. 19
Setup and Operation Inserting the Remote Control Batteries Remove the battery compartment 1. cover by sliding the cover in the di- rection of the arrow. Insert the supplied batteries taking 2. note of the polarity (+/-) as shown here. Replace the cover. 3. Caution: 1. Only use AAA batteries.(Alkaline is better) 2. Dispose of used batteries according to local ordinance regulations. 3. Remove the batteries when not using the projector for prolonged periods. –
Inhaltszusammenfassung zur Seite Nr. 20
DLP®Projector – User’s Manual Connecting Input Devices A PC or notebook computer as well as video devices can be connected to the projector at the same time. Video devices include DVD, VCD, and VHS players, as well as movie camcorders and digital still cameras. Check the user manual of the connecting device to confirm it has the appropriate output connector. Item Label Description Rear IR Receiver for IR signal from remote control. A DVI-D Connect DVI-D cable (not supplied) from a
