Inhaltszusammenfassung zur Seite Nr. 1
D I G I T A L S Y S T E M S
Operating Instructions
For
35mm Film Projector
Manual Turret Model P35GPS(Z)-MT
Automatic Turret Model P35GPS(Z)-AT
115VAC, 60Hz Motor or 220VAC, 50Hz Motor
TD-621: Version 3.8
CHRISTIE DIGITAL SYSTEMS
10550 Camden Drive
Cypress, CA 90630
Tel: 714-236-8610 Fax: 714-503-3385
Inhaltszusammenfassung zur Seite Nr. 2
Operator’s Manual P35GPS-MT/P35GPS-AT TD621GPS (Z) The information in this document is subject to change without notice and does not represent a commitment on the part of CHRISTIE, DIGITAL SYSTEMS (hereinafter referred to as CHRISTIE). CHRISTIE does not assume responsibility for errors that may appear in this document. CHRISTIE or its subsidiaries, designated representatives, and any other vendor of the P35GPS Film Projector are not responsible in any way for any liabilities or loss r
Inhaltszusammenfassung zur Seite Nr. 3
Inhaltszusammenfassung zur Seite Nr. 4
Table of contents TABLE OF CONTENTS TABLE OF CONTENTS..............................................................................i LIST OF FIGURES AND TABLES...............................................................v 1. INTRODUCTION .................................................................................. 1-1 1.1. Contents of the Manual..................................................................................................1-1 1.2. Who Should Use This Manua
Inhaltszusammenfassung zur Seite Nr. 5
P35GPS Dual Lens Turret Projector 5.4.2. Outer Timing Belt .................................................................................................. 5-3 5.4.3. Inner Timing Belt................................................................................................... 5-3 5.4.4. Shutter Timing Belt................................................................................................ 5-4 5.4.5. Upper, Center, and Lower Constant-Speed Sprocket Assemblies.............
Inhaltszusammenfassung zur Seite Nr. 6
Table of contents 7.2.4. SYMPTOM: Shutter Streaking .............................................................................7-2 7.3. Constant-Speed Sprocket Assembly..............................................................................7-2 7.3.1. SYMPTOM: Excessive Noise...............................................................................7-2 7.3.2. SYMPTOM: Film Sprocket Hole Damage ...........................................................7-2 7.3.3. SYMPTOM: Sp
Inhaltszusammenfassung zur Seite Nr. 7
P35GPS Dual Lens Turret Projector 7.6. Shutter Drive (Shutter Driver and Jackshaft System) ................................................... 7-3 7.6.1. SYMPTOM: Excessive Noise .............................................................................. 7-3 7.6.2. SYMPTOM: Shutter Streak.................................................................................. 7-4 7.7. Trap and Gate Assembly .......................................................................................
Inhaltszusammenfassung zur Seite Nr. 8
Table of contents LIST OF FIGURES AND TABLES Figure 2-1: Table of Equipment Specifications ..........................................................................2-1 Figure 2-2: Projector, Front View...............................................................................................2-2 Figure 2-3: Projector, Rear View................................................................................................2-3 Figure 3-1: Installing the Projector ...................
Inhaltszusammenfassung zur Seite Nr. 9
P35GPS Dual Lens Turret Projector Table B-11 Inner Timing Belt Tensioner Assembly Parts List ................................................B-19 Figure B-12: Central Pivot Analog Soundhead Assembly (P/N 196260-001)..........................B-20 Table B-12 Central Pivot Analog Soundhead Assembly Parts List .........................................B-21 Figure B-13: Central Pivot Digital Soundhead Assembly (P/N 196220-002) ..........................B-22 Table B-13: Central Pivot Digital So
Inhaltszusammenfassung zur Seite Nr. 10
1 1. INTRODUCTION 1.1. CONTENTS OF THE MANUAL This manual contains installation, operation, and operator maintenance procedures for CHRISTIE P35GPS Projector models having serial numbers P-1201 and up. The material covered includes: • general description • installation and assembly • operating the projector • periodic maintenance • calibration, alignment, and adjustments • troubleshooting. 1.2. WHO SHOULD USE THIS MANUAL? This manual provides information suitable for various pur
Inhaltszusammenfassung zur Seite Nr. 11
P35GPS Dual Lens Turret Projector 1.3.1. WARNING WARNING: Indicates the presence of a hazard that can cause personal injury if the hazard is not avoided. WARNING 1.3.2. CAUTION CAUTION: Indicates the presence of a hazard that could cause damage to projection system. 1.3.3. NOTE NOTE: Provides additional information. CHRISTIE DIGITAL SYSTEMS P35GPS Projector 1-2 March, 2004
Inhaltszusammenfassung zur Seite Nr. 12
2 2. GENERAL DESCRIPTION The CHRISTIE P35GPS Projector, manufactured exclusively by CHRISTIE DIGITAL SYSTEMS in Cypress, California, is a dual-lens 35mm movie projector that employs a revolutionary sealed-bearing intermittent movement called the Ultramittent©. This movement coupled with uncompromising design and assembly workmanship, results in the finest possible theater picture reproduction. The Ultramittent movement is standard on all CHRISTIE projectors. 2.1. OPTIONAL FEATURES
Inhaltszusammenfassung zur Seite Nr. 13
P35GPS Dual Lens Turret Projector 1. *Dual Turret (196555-001 10. **Sound-head Assembly-(Analog- 2. Turndown Knob (194510-001) (96260-001,Digital-196220-002) 3. center sprocket Assembly (194856-002 11. Aperture Drive Assembly (121435-001) 4. Upper Sprocket Assembly (194856-0010 12. Fan Grill (598931-547) 5. Ultramittent Assembly (119450-001)
Inhaltszusammenfassung zur Seite Nr. 14
General Description 17. Lower Sprocket Assembly (194857-001) 27. Analog Power Supply (194908-001) 18. Shutter Driver Assembly (194866-001) 28. Upper Sprocket Pulley (194858-001) 19. Ultramittent Pulley (194818-001) 29. Jackshaft Assembly (194810-001) 20. Center Sprocket Pulley (194858-001) 30. Changeover Dowser (121195-001) 21. Inner Belt Tensioner (196056-001) 31. Outer Belt Tensioner
Inhaltszusammenfassung zur Seite Nr. 15
Inhaltszusammenfassung zur Seite Nr. 16
3 3. PROJECTOR INSTALLATION AND ASSEMBLY 3.1. UNPACKING THE PROJECTOR Before opening box (es), carefully inspect outside of carton(s). If carton has been damaged, notify shipper immediately; do not open carton unless instructed to do so. The CHRISTIE P35GPS projector may be shipped in more than one container. Each P35GPS projector normally comes complete with the following items: • dual aperture plate (shipped in place) • framing lamp (installed) • sound-head flywheel (not inst
Inhaltszusammenfassung zur Seite Nr. 17
P35GPS Dual Lens Turret Projector 2. Insert lock washer (item 2 in Figure 3-1) and flat washer (item 3 in Figure 3-1) onto second hex bolt (item 1 in Figure 3-1). Insert hex head bolt, with lock washer and flat washer, into upper left opening of projector mount. Rotate hex head bolt four full turns. 3. Lift and mount projector to console or pedestal. Thread two remaining hex head bolts with lock washer and flat washer. Insert into two bottom mounting holes on projector. 4. Level projec
Inhaltszusammenfassung zur Seite Nr. 18
Projector Installation and Assembly Category Item Use Tools Miscellaneous Allen wrenches General Maintenance Small standard screwdriver Phillips screwdrivers Equipment Oscilloscope Sound-head Alignment Voltmeter Real-time Analyzer SK1994-3 alignment tool Lateral Guide Alignment Materials P35-BT (SMPTE) Buzz Track Test Loop P35-FL Flutter Loop Cat 69 Loop Dolby Tone, Pink Noise Cat 566 Loop Illumination Uniformity Cat 97 Loop Left/Right Alignment RP-40 Loop Optical Al
Inhaltszusammenfassung zur Seite Nr. 19
P35GPS Dual Lens Turret Projector Figure 3-3: Projector Wiring Diagram (50- and 60-Hz models) 3.3.2. A-C PROJECTOR WIRING A-C wiring to the projector requires stranded, 14-gauge wire. Be sure to follow local and national electrical codes for A-C wiring. The terminal connection numbers in the table in Figure 3-4 refer to terminals TB-1 in Figure 3-3. CHRISTIE DIGITAL SYSTEMS P35GPS Projector 3-4 March, 2004
Inhaltszusammenfassung zur Seite Nr. 20
Projector Installation and Assembly Terminal TB1 Connection 1 Motor (A-C neutral) 2 Motor switch lead (A-C hot, switched externally) 3 Framing lamp and cooling fan (A-C hot) 4 Changeover coil OPEN (A-C, switched externally) 5 Changeover coil CLOSE (A-C, switched externally) 6 Framing lamp, cooling fan, and changeover (A-C neutral). Figure 3-4: Table of A-C Terminal Connections The voltage and frequency rating of the projector (shown on the nameplate) must match the power line frequenc
