Inhaltszusammenfassung zur Seite Nr. 1
YP100_Guide_E.book 1 ページ ２００ ６年８ 月８日 火曜 日 午 後３時 １６分
English
Multifunctional
Presentation Kit YP-100
Getting Started with the Multifunctional Presentation Kit
• Be sure to read the “Safety Precautions” on page E-3 and “Operating Precautions” on page
E-6 before trying to use this product.
This manual provides a general overview and covers basic operations of the YP-100. For more
information about operations, see the User’s Guide on the bundled CD-ROM.
Contents
Safety Precautions ..........
Inhaltszusammenfassung zur Seite Nr. 2
YP100_Guide_E.book 2 ページ ２００ ６年８ 月８日 火曜 日 午 後３時 １６分 Microsoft, Windows, Windows NT, Windows XP, the Windows logo, and PowerPoint are registered trademarks or trademarks of Microsoft Corporation in the United States and other countries. Other company and product names may be registered product names or trademarks of their respective owners. The contents of this manual are subject to change without notice. Copying of this manual, either in part or its entirety is forbidden. You are
Inhaltszusammenfassung zur Seite Nr. 3
YP100_Guide_E.book 3 ページ ２００ ６年８ 月８日 火曜 日 午 後３時 １６分 Safety Precautions Safety Precautions Be sure to read these “Safety Precautions” before trying to use this product. About safety symbols Various symbols are used in this manual and on the product itself to ensure safe use, and to protect you and others against the risk of injury and against material damage. The meaning of each of the symbols is explained below. This symbol indicates information that, if ignored or applied incorrectly, Dan
Inhaltszusammenfassung zur Seite Nr. 4
YP100_Guide_E.book 4 ページ ２００ ６年８ 月８日 火曜 日 午 後３時 １６分 Safety Precautions Should the electrical cord or plug Location become damaged, contact your Never locate the product in any of the original dealer or authorized CASIO following types of locations. Doing so creates service center. the risk of fire and electric shock. Near an area subject to strong vibration Never touch the AC adaptor while An area subject to large amounts of your hands are wet. Water creates the moisture or du
Inhaltszusammenfassung zur Seite Nr. 5
YP100_Guide_E.book 5 ページ ２００ ６年８ 月８日 火曜 日 午 後３時 １６分 Safety Precautions Caution Caution Misuse of a battery can cause it to leak and AC adaptor stain the area around it, or to explode, Misuse of the AC adaptor creates the creating the risk of fire and personal injury. risk of fire and electric shock. Make Make sure that you always observe the sure that you always observe the following precaution. following precautions. Use only the type of battery that is Never cover the AC spec
Inhaltszusammenfassung zur Seite Nr. 6
YP100_Guide_E.book 6 ページ ２００ ６年８ 月８日 火曜 日 午 後３時 １６分 Operating Precautions Operating Precautions This product is made of precision components. Failure to observe the following precautions can result in inability to correctly save data and malfunction. Never use or store the product in the following locations. Doing so creates the risk of malfunction of and damage to the product. Locations subjected to electrostatic charge Locations subjected to temperature extremes Locations where there
Inhaltszusammenfassung zur Seite Nr. 7
YP100_Guide_E.book 7 ページ ２００ ６年８ 月８日 火曜 日 午 後３時 １６分 Introduction Introduction What you can do with the YP-100 The YP-100 makes it possible to connect a USB memory device, a wireless LAN, or a document camera to a data projector (CASIO XJ-S30, XJ-360, XJ-460) that is equipped with an RGB input terminal. Once you connect any one of the external USB devices described below to the USB terminal of the YP-100, you can project data from the connected device. Using a USB Memory Device with the YP-
Inhaltszusammenfassung zur Seite Nr. 8
YP100_Guide_E.book 8 ページ ２００ ６年８ 月８日 火曜 日 午 後３時 １６分 Introduction Using a Wireless LAN with the YP-100 Establishing a connection between the YP-100 and a computer over a wireless LAN makes it possible to project the display contents of the computer’s screen from the projector connected to the YP-100. XJ-S30, etc. YP-100 CASIO YW-2 You can have up to four computers connected to the YP-100 over a wireless LAN at the same time. Use the remote controller that comes with the YP-100 to select whi
Inhaltszusammenfassung zur Seite Nr. 9
YP100_Guide_E.book 9 ページ ２００ ６年８ 月８日 火曜 日 午 後３時 １６分 Introduction Using the YC-400 Document Camera with the YP-100 You can connect a CASIO YC-400 Document Camera to the USB port of the YP-100 and project the images of documents placed on the document stage of the YC-400. XJ-S30, etc. YP-100 YC-400 For information about basic YC-400 operations, see “Using the YP-100 with a YC-400 Document Camera” on page E-19 of this manual. For detailed information about operations, see the User’s Guide o
Inhaltszusammenfassung zur Seite Nr. 10
YP100_Guide_E.book 10 ページ ２００ ６年８ 月８日 火曜 日 午 後３時 １６分 Introduction About this manual... Terms and Conventions In this manual, there are many procedures that require parallel operations on the YP-100 and your computer. The following are special terms and conventions used in this manual to differentiate between the YP-100 and computer. projection area This is the entire rectangular area that is projected by the projector connected to the YP-100. Certain YP-100 operations will cause messages a
Inhaltszusammenfassung zur Seite Nr. 11
YP100_Guide_E.book 11 ページ ２００ ６年８ 月８日 火曜 日 午 後３時 １６分 Introduction General Guide YP-100 LINE OUT terminal RGB OUT terminal AC adaptor terminal [POWER] indicator [ ] (Power) key Remote control signal receiver (both sides) [ ] (Hold) key [HOLD] indicator USB port Remote Controller Remote control signal emitter CLASS 1 LED PRODUCT [ ] key Cursor keys [ , , , ] [MENU] key [ENTER] key [FUNC] key [ESC] key [] key [ ] key [] key E-11 English
Inhaltszusammenfassung zur Seite Nr. 12
YP100_Guide_E.book 12 ページ ２００ ６年８ 月８日 火曜 日 午 後３時 １６分 Getting Ready Getting Ready Preparing the Remote Controller The remote control unit comes loaded with a test battery. Before using it for the first time, remove the battery insulation sheet from the back of the remote controller. To avoid running down the battery, store the remote control unit so its buttons are not pressed inadvertently. Replacing the Remote Controller Battery The battery (CR2025) that comes pre-installed in the remote
Inhaltszusammenfassung zur Seite Nr. 13
YP100_Guide_E.book 13 ページ ２００ ６年８ 月８日 火曜 日 午 後３時 １６分 Getting Ready 2. Insert a new battery (CR2025) into the 3. Slide the battery holder back into the battery holder. remote controller. Make sure that the plus (+) side of the battery is facing upwards (so you can see it). Connecting a Projector Make sure that the YP-100 and the projector are both turned off before connecting them. YP-100 RGB OUT LINE OUT terminal terminal Projector To RGB IN To LINE IN terminal terminal Audio cable (co
Inhaltszusammenfassung zur Seite Nr. 14
YP100_Guide_E.book 14 ページ ２００ ６年８ 月８日 火曜 日 午 後３時 １６分 Getting Ready Turning On Power To turn on the YP-100 1. Connect the projector to the YP-100, referring to “Connecting a Projector” (page E-13). 2. Turn on the projector and/or audio equipment that is connected to the YP-100. 3. Connect the AC adaptor that comes with the YP-100 to the AC adaptor terminal, and plug the AC adaptor into a power outlet. This will cause the YP-100 to turn on automatically. This will cause the YP-100’s [POWER]
Inhaltszusammenfassung zur Seite Nr. 15
YP100_Guide_E_Body.fm 15 ペー ジ ２０ ０６年 １０月 ３日 火曜日 午後 ２時 ４４分 Getting Ready To turn off the YP-100 Press the [ ] (Power) key to turn off the YP-100. Any changes you make to setup menu* settings are retained when you press the [ ] (Power) key to turn off the YP-100. Note, however, that setup menu settings are lost if you unplug the AC adaptor from the YP-100 without first pressing the [ ] (Power) key to turn it off. * The setup menus include the Viewer setup menu, the Wireless setup menu, and
Inhaltszusammenfassung zur Seite Nr. 16
YP100_Guide_E.book 16 ページ ２００ ６年８ 月８日 火曜 日 午 後３時 １６分 Basic YP-100 Operations Basic YP-100 Operations This section explains the following YP-100 operations. Basic operation for using a USB memory device with the YP-100 You can use the projector connected to the YP-100 to project images from files stored on the USB memory device. Basic operation for using a YC-400 document camera with the YP-100 You can use the projector connected to the YP-100 to project images of documents whose images
Inhaltszusammenfassung zur Seite Nr. 17
YP100_Guide_E.book 17 ページ ２００ ６年８ 月８日 火曜 日 午 後３時 １６分 Basic YP-100 Operations 4. Enter “YP-100” and then press the [Enter] key. This will create a folder named “YP-100”. 5. Drag the image files to the “YP-100” folder. This will copy the image files into the folder. Be sure to copy only JPEG (jpg, jpeg or jpe) or BMP (bmp) format image files into the folder. Other formats are not recognized by the YP-100. 6. On the taskbar, click the (Safely Remove Hardware) icon. On the menu that appears
Inhaltszusammenfassung zur Seite Nr. 18
YP100_Guide_E.book 18 ページ ２００ ６年８ 月８日 火曜 日 午 後３時 １６分 Basic YP-100 Operations 2. Connect the projector to the YP-100, referring to “Connecting a Projector” (page E-13). 3. Use the procedure under “Turning On Power” on page E-14 to turn on the YP-100. This will cause the YP-100’s [POWER] indicator to light green. The YP-100 logo screen also will be projected by the connected projector. 4. Plug the USB memory device you prepared in step 1 into the YP-100’s USB port. Once the YP-100 recognizes
Inhaltszusammenfassung zur Seite Nr. 19
YP100_Guide_E.book 19 ページ ２００ ６年８ 月８日 火曜 日 午 後３時 １６分 Basic YP-100 Operations Using the YP-100 with a YC-400 Document Camera 1. Connect the projector to the YP-100, referring to “Connecting a Projector” (page E-13). 2. Use the procedure under “Turning On Power” on page E-14 to turn on the YP-100. This will cause the YP-100’s [POWER] indicator to light green. The YP-100 logo screen also will be projected by the connected projector. 3. Connect the document camera to the YP-100 using the USB ca
Inhaltszusammenfassung zur Seite Nr. 20
YP100_Guide_E.book 20 ページ ２００ ６年８ 月８日 火曜 日 午 後３時 １６分 Basic YP-100 Operations 4. With nothing on the document stage, press the [ ] (power) button on the camera stand. This will turn on the document camera. The YP-100 will recognize the document camera and start up the YC Camera application automatically. When the YC Camera application starts up, the YP-100 will project an image of the document stage along with a dialog box for adjusting the document camera position. If the document came
