Inhaltszusammenfassung zur Seite Nr. 1
.
C
.
L
.
L
,
S
T
C
U
I
D
S
O
O
R
1
P
4
0
R
0
E
1
M
F
U
I
OWNER’S MANUAL
Integrated High Definition
Compatible with Toshiba’s new
™
TM
DLP Projection Television
Audio/Video Hard Drive Recorder!
See pages 26 and 55 for details.
HIGH-DEFINITION TELEVISION
For an overview of steps for setting up your new TV, see page 9.
Note: To display a High Definition picture, the TV must be receiving a
High Definition signal (such as an over-the-air High Definition TV
broadcast, a High Definition digital cabl
Inhaltszusammenfassung zur Seite Nr. 2
Dear Customer, NOTICE OF POSSIBLE TV STAND INSTABILITY Thank you for purchasing this Toshiba TV. This manual will CAUTION: This television is for use only with help you use the many exciting features of your new TV. the Toshiba stand listed below. Use with other Before operating the TV, please read this manual carts or stands is capable of resulting in instability causing possible injury. completely, and keep it nearby for future reference. Television Stand Model 52HMX95 ST 5275 Safety Precautio
Inhaltszusammenfassung zur Seite Nr. 3
Important Safety Instructions 16) WARNING: This product contains a lamp to project the picture, and requires special safety precautions: 1) Read these instructions. • See pages 129–131 for instructions on lamp unit 2) Keep these instructions. replacement and care. 3) Heed all warnings. • DO NOT attempt to service this product except as specified on pages 129–131. The only user- 4) Follow all instructions. serviceable item in this product is the lamp unit. 5) Do not use this apparatus near water.
Inhaltszusammenfassung zur Seite Nr. 4
Installation (continued from previous page) Care (continued from previous column) 33) For added protection of your TV from lightning and power 27) Always make sure the antenna system is properly surges, always unplug the power cord and disconnect the grounded to provide adequate protection against voltage antenna from the TV if you leave the TV unattended or surges and built-up static charges (see Section 810 of the unused for long periods of time. National Electric Code). Antenna lead-in wire 3
Inhaltszusammenfassung zur Seite Nr. 5
FCC Declaration of Conformity Compliance Statement (Part 15): interference to radio communications. However, there is no The Toshiba 52HMX95 and 62HMX95 DLP™ projection guarantee that interference will not occur in a particular TVs comply with Part 15 of the FCC rules. installation. If this equipment does cause harmful Operation is subject to the following two conditions: (1) this interference to radio or television reception, which can be device may not cause harmful interference, and (2) this
Inhaltszusammenfassung zur Seite Nr. 6
Contents Important safety, care, and service information ........... 2–4 Chapter 4: Menu layout and navigation ........................... 40 Main menu layout .............................................................. 40 FCC Declaration of Conformity Compliance Setup/Installation menu layout ........................................... 41 Statement (Part 15): ............................................................ 5 Navigating the menu system .............................................
Inhaltszusammenfassung zur Seite Nr. 7
Contents Chapter 8: Using the TV’s features .....................................72 Chapter 9: Using the Locks menu ....................................... 97 Entering the PIN code ....................................................... 97 Selecting the video input source to view ............................. 72 If you cannot remember your PIN code ............................. 97 Labeling the video input sources ......................................... 73 Changing your PIN code ...............
Inhaltszusammenfassung zur Seite Nr. 8
Introduction 1 Welcome to Toshiba ™ Thank you for purchasing this Toshiba TV, one of the most innovative DLP projection See “Important notes about your TVs on the market. The goal of this manual is to guide you through setting up and ™ DLP projection TV” on page 5. operating your TV as quickly as possible. • This manual applies to models 52HMX95 and 62HMX95. Before you start reading, check the model number on the back of your TV. • Instructions in this manual are based on using the remote contro
Inhaltszusammenfassung zur Seite Nr. 9
Chapter 1: Introduction Overview of steps for installing, setting up, and using your new TV Follow these steps to set up your TV and begin using its many exciting features. 1. Carefully read the important safety, installation, care, 9. Program the remote control to operate your other and service information on pages 2–5. Keep this device(s) (pages 33–39). manual for future reference. 10. AFTER connecting all cables and devices, plug in the 2. Observe the following when choosing a location for po
Inhaltszusammenfassung zur Seite Nr. 10
Connecting your TV 2 TV front panel touchpad and side panel controls and connections Front of TV Side panel TV/VIDEO EXIT CHANNEL VOLUME MENU POWER Remote sensor 1 Front panel touchpad* zyx • EXIT MENU (ENTER)** 4 3a 5 GUIDE POWER 2 6 Right side of TV VIDEO-3 IN Memory card 0 slots !¡ Green/Red LEDs TV/VIDEO Channel zy Volume x • 9 3b 7 8 *Gently touch the printed keys on the touchpad. **The MENU button on the TV front panel touchpad functions as the ENTER button when a menu is on-screen. 1 Rem
Inhaltszusammenfassung zur Seite Nr. 11
Chapter 2: Connecting your TV TV back panel connections For an explanation of cable types, see page 13. 12 345 6 7 8 9 0 1 VIDEO 1 IN and VIDEO 2 IN — Two sets of standard 6 PC IN/AUDIO — For connecting audio from a personal (composite) video and standard audio inputs plus optional computer when using the TV screen as the display for the S-video inputs for connecting devices with composite video connected PC. See page 29. or S-video output. 7 PC IN/VIDEO— For connecting video from a personal Not
Inhaltszusammenfassung zur Seite Nr. 12
Chapter 2: Connecting your TV TV back panel connections (continued) 123 45 1 ANT-1 (cable) IN and ANT-2 IN — Two RF inputs that 4 TheaterNet IEEE1394 1 and 2 — Two bi-directional support analog (NTSC) and digital (ATSC) off-air antenna digital IEEE1394 ports for connecting multiple devices signals and analog and digital Cable TV (QAM) signals. with compressed digital video. Because these ports are bi-directional, they can be used for playback and recording. Note: If you have an antenna only, con
Inhaltszusammenfassung zur Seite Nr. 13
Chapter 2: Connecting your TV Overview of cable types ® Note: Two dual-wand IR blaster/G-LINK cables are included with your TV. All other required cables, if not provided with your other devices, can be purchased at many electronics accessory Coaxial (F-type) cable suppliers. ● Coaxial (F-type) cable is used for connecting your antenna, cable TV service, and/or cable converter box to the ANT-1 and/or ANT-2 RF inputs on your TV. ● Standard A/V cables (composite video) usually come in sets of thre
Inhaltszusammenfassung zur Seite Nr. 14
Chapter 2: Connecting your TV About the connection illustrations You can connect different types and brands of devices to your TV in several different configurations. The connection illustrations in this manual are representative of typical device connections only. The input/output terminals on your devices may differ from those illustrated herein. For details on connecting and using your specific devices, refer to each device’s owner’s manual. Connecting a digital CableCARD™ This digital televi
Inhaltszusammenfassung zur Seite Nr. 15
Chapter 2: Connecting your TV Connecting a VCR and antenna or Cable TV (no Cable box) You will need: From Cable TV or antenna one signal splitter three coaxial cables IN Signal splitter OUT two sets of standard A/V cables OUT • For better picture performance, if your VCR has S-video, use an Stereo VCR S-video cable (plus the audio cables) instead of the standard video cable. Do not connect both types of video cables to VIDEO AUDIO LR IN from ANT VIDEO 1 (or VIDEO 2) at the same time or th
Inhaltszusammenfassung zur Seite Nr. 16
Chapter 2: Connecting your TV Connecting a VCR and Cable box You will need: From Cable TV one signal splitter IN Cable box Signal splitter five coaxial cables IN OUT CH 3 OUT CH 4 OUT two sets of standard A/V cables Stereo VCR • For better picture performance from your VCR: If your VCR has S-video, connect an S-video cable (plus the audio cables) instead VIDEO AUDIO IN from ANT LR of the standard video cable. Do not connect an S-video cable and CH 3 IN CH 4 a standard video cable to VIDEO
Inhaltszusammenfassung zur Seite Nr. 17
Chapter 2: Connecting your TV Connecting a VCR and satellite receiver From antenna You will need: one signal splitter IN Signal splitter four coaxial cables OUT OUT one set of component video cables (if your satellite receiver does not have component Stereo VCR video, connect the standard A/V cables only) VIDEO AUDIO LR IN from ANT one pair of standard audio cables CH 3 IN CH 4 OUT to TV three sets of standard A/V cables OUT LR • For better picture performance, if your satellite TV re
Inhaltszusammenfassung zur Seite Nr. 18
Chapter 2: Connecting your TV Connecting a DVD player with S-video, a VCR, and a Cable box From antenna or Cable TV You will need: one signal splitter IN Cable box Signal splitter five coaxial cables IN OUT CH 3 OUT CH 4 OUT two sets of standard A/V cables Stereo VCR Note: If you have a mono VCR, connect L/MONO on the TV VIDEO AUDIO (VIDEO 1) to your VCR’s audio out terminal using the white L R IN from ANT CH 3 audio cable only. IN CH 4 OUT to TV OUT one S-video cable L R one pair of
Inhaltszusammenfassung zur Seite Nr. 19
Chapter 2: Connecting your TV ® Connecting a DVD player with ColorStream (component video) and a VCR ® From antenna or Cable Your TV has ColorStream (component video) inputs. You will need: IN Signal splitter OUT one signal splitter OUT three coaxial cables Stereo VCR two sets of standard A/V cables VIDEO AUDIO • For better picture performance, if your VCR has S-video, use an LR IN from ANT CH 3 IN S-video cable (plus audio cables) instead of the standard video CH 4 OUT to TV cable. Howev
Inhaltszusammenfassung zur Seite Nr. 20
Chapter 2: Connecting your TV Connecting two VCRs From antenna or Cable You will need: one signal splitter IN Signal splitter ** three coaxial cables OUT OUT two sets of standard A/V cables • For better picture performance, if VCR 1 has S-video, use VCR1 (plays) an S-video cable (plus the audio cables) instead of the VIDEO AUDIO LR standard video cable. However, do not connect both types IN from ANT CH 3 IN of video cable to VIDEO 1 (or VIDEO 2) at the same time CH 4 OUT to TV OUT or the
