Bedienungsanleitung JVC LX-D1000

Inhaltszusammenfassung zur Seite Nr. 1

INSTRUCTION MANUAL
FOR ASSEMBLY AND INSTALLATION OF
EF-L1000CG
LCD Projector Compatible with Installation
Model Name: LX-D1000 (Body’s mass is 4.5 Kg)
For Selling and Installing Stores
n Read this instruction manual carefully before assembly and/or installation. Be sure to carry out the
work properly always with safety in mind.
n Do not permit the customers to engaged in assembly and/or installation. Make sure that your custom-
ers request you, the pr

Inhaltszusammenfassung zur Seite Nr. 2

CAUTION: When installing component parts, caution must be CHECK AND MAKE SURE exercised not to use any parts except the ones packed with the body. Check and confirm before assembly and/or installation that the following parts are packed along with the body as accessories: No. Names of parts Quantity No. Names of parts Quantity q Coupling plate 1 !1 Hexagon head bolts [C] (M10 × 65) 1 w Supporter for LCD projector 1 !2 Nut 1 e Assembling bolts (M8 × 25) 4 !3 Washers (for M10) 2 r Rotary setscrew

Inhaltszusammenfassung zur Seite Nr. 3

Fig. 3 ASSEMBLY y Ceiling plate !3 Washers (for M10) !7 2 rotary mini 20 Fig. 3-1 10 setscrews (M5 × 5) !2 Nut t 2 screws [A] (M4 × 12) !1 Hexagon head bolts [C] (M10 × 65) u Inner pole q Coupling !3 Washer (for M10) plate !8 4 hexagon socket !0 Collar bolts (M5 × 16) (109.6) i Inner pole 150 fixing plate Size of fixing hole of base metal fixtures @0 4 nuts (for M5) r 2 rotary setscrews [E] (M5 × 10) !9 4 washers (for M5) e 4 assembling bolts (M8 × 25) o 4 hexagon socket bolts (M5

Inhaltszusammenfassung zur Seite Nr. 4

ADJUSTMENT OF PROJECTION POSITION (Refer to Fig. 5) Carry out horizontal and vertical adjustments as follows: 1. (1) To adjust the horizontal position of the screen, loosen rotary setscrews [E] (there are two pieces on both sides) and 4 hexagon socket bolts (M5 × 10), and rotate the projector horizontally. (2) To adjust the vertical position of the screen, loosen the assembling bolts (there are 4 pieces on both sides), then tilt the front of the projector vertically. Tighten the rotary setscre