Inhaltszusammenfassung zur Seite Nr. 1
NOT INTENDED FOR SALE
PN 80820202
Inhaltszusammenfassung zur Seite Nr. 2
Federal Communications Commission Radio Frequency Interference Statement l l l l The above statement applies only marketed the Trademark Acknowledgements NX-1000, NL-10, NP-10, NX-lO/lS, ND-IO/IS, NR-10/15: IBM PC, IBM Proprinter II, PC-DOS: Microsoft BASIC, MS-DOS: LX-800, EX-800, LX-80/W l l l l 1987 Star Ltd. Co., Micronics @Copyright manual. this in errors any for responsibility no assume can STAR notwithstanding, above The them. of informed being appreciate greatly woul
Inhaltszusammenfassung zur Seite Nr. 3
HOW TO USE THIS MANUAL manual is and all 1 5. as 1 and up. this 2 up, this and 3 tips using and this this manual. 4 is shows using DOS and 5 and this what as A lists B and C a and D sets. character printer’s the of tables presents Appendix characters. new download define to use can you program BASIC presents Appendix commands. printer other sequences escape of functions the details Appendix specifications. technical printer’s the Appendix later. necessary it to refer then
Inhaltszusammenfassung zur Seite Nr. 4
is a a making an a and sets, just and its main l is and that and and l lamp and a surprising and l and a l handling and all and A l ._. an and a up 18 23 - l and has and and small plus all plus - samples page: next the on the see print quadruple-sized print, double-sized print, bold print, condensed styles, for italics case), lower or capitals with Orator Sanserif, (Courier, styles NLQ four style draft one printer The sizes styles type of variety Large characters
Inhaltszusammenfassung zur Seite Nr. 5
Type styles are: D!.-a.f:.k Cl I-, 3. I'" FL, (-1 ,t $> ] " (=, p Courier characters, Sanserif characters, ORATOR WITH SMALL CAPITALS, OR with lower case characters, and J-TALICS for all ~+yt,p.j'a,~a Print pitches are: Pica pitch, Elite pitch, Condensed pica pitch, Condensed elite pitch, proportional spacing for all pitches, Quad- sized. Various line and character spacings: THE SPACINGS ARE CHANGED Other features: Emphasized, Double-strike. Underlininq Werlinlng. BUPERSCRIPT'
Inhaltszusammenfassung zur Seite Nr. 6
1 SETTING UP THE PRINTER Chapter 1 1 1 and 3 up Install 6 Manual 9 and 12 14 Adjusting gap 14 19 CONTROL PANEL OPERATIONS Chapter 2 19 and On 23 26 feed Page parking Paper functions combination Switch dump Hexadecimal style panel in Stay pitch panel in Stay pattern test Long pattern test Short functions Power-up switch Style Type NLQ switch Pitch Print switch Feed Paper switch Line indicator Power indicators Switches settings switch DIP printing the test
Inhaltszusammenfassung zur Seite Nr. 7
Right USING THE PRINTER WITH Chapter 3 31 COMMERCIAL SOFTWARE 31 33 33 Using and USING THE PRINTER Chapter 4 WITH DOS AND BASIC 37 31 DOS 38 40 MAINTENANCE AND TROUBLESHOOTING 47 Chapter 5 47 47 47 50 53 Appendix A TECHNICAL SPECIFICATIONS 59 Appendix B PRINTER CONTROL COMMANDS 59 63 66 and 70 76 80 82 85 86 commands control printer Other commands instruction Macro commands character Download commands Graphics commands position Horizontal commands positio
Inhaltszusammenfassung zur Seite Nr. 8
Appendix C DOWNLOAD CHARACTER GENERATOR 91 99 Appendix D CHARACTER SETS 100 102 #2 104 105 106 sets 107 INDEX REFERENCE CARD cover the Inside character International set character Additional #l set character IBM set character IBM set character Standard character NLQ character Draft
Inhaltszusammenfassung zur Seite Nr. 9
SETTING THE Subjects covered in Chapter 1 include - l l and l up l l and l l Adjusting gap l and a l a l sunlight and l l dust, l as a as a l is l using up at a hanging and against that items). five be should (there everything have you sure make to l-l Figure box the in item each check carton the Open contents carton the Check INSPECTION AND UNPACKING free. page full least with below, from it to feed can forms the where printer the place forms, fanfold be will you If
Inhaltszusammenfassung zur Seite Nr. 10
FIgwe 1-l. to you have five items: 1) 2) guide, 3) knob, 4) Ribbon and 5) manual. an parts: Bail lever: and bail against 2 platen. the paper the holds which paper the closes opens following the of locations the Note printer. the of inspection external Make User’s cartridge, Platen Paper Printer, all sure make Check -
Inhaltszusammenfassung zur Seite Nr. 11
igure i-2. The parts Release lever: must and up Top cover: and parts. Rear cover: Entry slot: Control panel: and Power switch: Connector: UP is a its push all hand is gears. printer’s the damage can on power while by platen the Turning knob. platen the turn you when off be always should Power way. the in it can you until it Turn printer. the of side right the on shaft on knob platen the Mount packing. the of disposing before knob the remove to careful Be box. packing the insi
Inhaltszusammenfassung zur Seite Nr. 12
lgure I-3. Mounting the platen knob top tabs at and lgure Removing the top cover 4 1-4. completely. cover the remove cover the of back the the disengage Then cover. top plastic clear printer’s the of edge front the Lift cover the Remove
Inhaltszusammenfassung zur Seite Nr. 13
has a this and snaps lgure Installing the ribbon and tabs at swing is dust and and an as is as manual. computer the in described computer your to cable the of end other the connect then OFF, turned computer the sure Make 1-6. Figure in shown printer the of side right the on socket connector the to cable interface the of end printer the Connect computer the to printer the Connect adjustment. make or ribbon the change to only cover the Open sounds. operating printer’s the reduce
Inhaltszusammenfassung zur Seite Nr. 14
Figure Connecting the interface that at is an AC wall is SHEETS using tits and 6 position. upright the to it raise guide the Mount cover. rear the of top on holes two the into guide paper The guide paper the Mount - booklet. instruction ASF the read (ASF), feeder sheet automatic optional the are you If paper. of sheets single loading for procedures the through you take will section This SINGLE LOADING on. turned printer the while cord power the unplug or plug Never outlet. int
Inhaltszusammenfassung zur Seite Nr. 15
Figure l-7. Mounting the guide for single sheets start 1. that is and bail a and signals. 2. a and a slight as past this and as as 3. bail bail 4. bail again, a inch. one about of margin top with print to position in ending forward slightly feed will paper The back. lever the Move automatically. paper the feeds printer the opens, the When forward. lever the Move go. will it far down it insert resistance paper the Work lever. detector paper the engages paper the resistance feel
Inhaltszusammenfassung zur Seite Nr. 16
lever wgure Loaatng smgle meet is is is: 1. that is and at is 2. a as as as 3. bail bail. 4. - 5. is straight, up hand, 6. bail bail. paper the close to back lever the Move down. back lever release the move then by paper the straighten position, the to lever release the move not paper the If cover. top the under from out comes paper the of edge front the until clockwise knob platen the Turn paper the open to forward printer the of top on lever the Move loading. semiautomatic
Inhaltszusammenfassung zur Seite Nr. 17
sides and just plain up 10” and as 1. a and at 2. 3. up is is just 4. bail bail. 5. and 6. its and upwards and as Figure Opening the cover 7. and units, as 8. units and align 9. and platen. the under in it tuck lever detector paper the over paper the of edge front the Insert paper. the in holes the with them can you so left right freely move to sprocket two the allows This down. levers clamp the Flip l-10. Figure in shown sprocket left right the on covers sprocket the Open
Inhaltszusammenfassung zur Seite Nr. 18
lever Figure Opening the sprocket covers to the sprocket teeth r Figure Closing the sprocket covers 10. pins. that is 11. 12. Raise 10 place. in unit sprocket one lock to levers clamp the of one 1). l-l (Figure covers sprocket the Close even. paper the Check sprocket the over paper the in holes the Fit 7-11. -. expose l-10.
Inhaltszusammenfassung zur Seite Nr. 19
13. 14. bail bail. 15. that is 16. upward and tabs at pads and snap 17. that Figure Mounting guide for fanfold forms and want a “park” 1. starts ON, up, and bail 2. On 11 off). indicator Line (On off-line printer the set to panel control the on switch Line the Press back. lever the lever release the position, printing in loaded paper fanfold power with parking Paper below. procedure the follow you if you for it will printer The sheet. single on print to you when it unload to
Inhaltszusammenfassung zur Seite Nr. 20
3. at last than a a is just and 4. and 5. is 6. 7. as at want using is as 1. all and bail. 2. 3. up 4. With ON, bail 5. bail bail. as a at that 1. that is 2. With On and 3. On start its On starts. at is 12 on.) power while knob platen the turn (Don’t knob. platen the turn then OFF, power switch test, the of end the paper the remove To printing after switch Line the release can You pattern. test short printing automatically will printer The on. power printer’s the t
