Inhaltszusammenfassung zur Seite Nr. 1
Inhaltszusammenfassung zur Seite Nr. 2
Copyright Information Copyright © 2007 by Oki Data Americas, Inc. All Rights Reserved Document Information OkiLAN 7120e Network Users Guide P/N 59386201, Revision 1.3 February, 2007 Disclaimer Every effort has been made to ensure that the information in this document is complete, accurate, and up-to-date. The manufacturer assumes no responsibility for the results of errors beyond its control. The manufacturer also cannot guarantee that changes in software and equipment made by other manufac
Inhaltszusammenfassung zur Seite Nr. 3
Table of Contents Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Specification. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Self-diagnostic test . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Configuration utility. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Available utilities. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Us
Inhaltszusammenfassung zur Seite Nr. 4
Windows 95/98/Me . . . . . . . . . . . . . . . . . . . . . . . . . . . .38 Windows NT 4.0 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .38 Windows 2000 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .40 Windows XP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .42 Novell Netware IPX . . . . . . . . . . . . . . . . . . . . . . . . . . . . .45 NetBEUI Protocol . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .45 Windows 95/98/Me . . . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 5
CONFIGURATION Introduction The OkiLAN 7120e is a fast 100BASE-TX/10BASE-T network interface card for a range of Oki printers. This users guide explains the functionality of the OkiLAN 7120e. Access for interconnection and producing self-diagnostic test and configuration printouts is provided via an interface panel at the rear of the printer. This network interface card supports IEEE802.2, IEEE802.3, Ethernet-II and SNAP and can detect those frame types automatically. Also, the interface ca
Inhaltszusammenfassung zur Seite Nr. 6
Specification Frame types IEEE 802.2 IEEE 802.3 Ethernet-II, SNAP, AUTO Network interface 100BASE-TX 10BASE-T Network protocols TCP/IP Network layerARP, RARP, IP, ICMP Session layerTCP, UDP Application layerLPR, FTP, HTTP, IPP, BOOTP, DHCP, SNMP, DNS, SMTP, SLP IPX/SPX (NetWare) Remote printer mode (up to eight file servers and 32 queues) Print server mode over IPX/SPX (up to eight print servers) Encrypted password supported in print server mode SNMP NetBEUI SMB, NetBIOS, WINS Functions Self-
Inhaltszusammenfassung zur Seite Nr. 7
From this the Ethernet address is: 00:80:92:12:34:56 Restrictions 1. The printer can not receive data from either the Centronics or the USB interfaces with OkiLAN 7120e installed. To use these remove OkiLAN 7120e. 2. Set "Buffer Print" in the printer menu "I-Prime". Missing data or other unexpected problem occurs when anything else ("Invalid" or "Buffer Clear") is selected. 3. When the printer is off-line, the status displayed on WEB/ AdminManager/TELNET may not be correct. 4. The link add
Inhaltszusammenfassung zur Seite Nr. 8
Utility Features System requirements AdminManag Configure the OkiLAN 7120e Windows95/98/Me/NT4.0/ er in detail. 2000/XP (TCP/IP protocol or IPX/SPX protocol should be installed). To create a NetWare queue, NetWare Client 32 or IntranetWare Client should be installed in your system. Web browser Configure the print server and Microsoft Internet Explorer printer by using a Web Version 3.0 and higher or browser such as Microsoft Netscape Navigator Version Internet browser or Netscape 3.0 and
Inhaltszusammenfassung zur Seite Nr. 9
This utility must be used on a PC that is located in the same segment as the printer. To create a NetWare queue, NetWare Client 32 or IntranetWare Client should be installed in your system. The following explanation uses Windows 98 as an example. 1. Insert the CD-ROM into the CD-ROM drive. The Setup Utility starts automatically. If it does not start, double-click autorun.exe on the CD-ROM. 2. Select [Optional Utilities]. 3. Select [Install Network Setup Utility]. 4. Select the appropriate
Inhaltszusammenfassung zur Seite Nr. 10
To create a NetWare queue, NetWare Client 32 or IntranetWare Client should be installed on to your system. The following explanation uses Windows 98 as an example. Installation 1. Insert the CD-ROM into the CD-ROM drive. The installation starts automatically. If it does not start, double-click autorun.exe on the CD-ROM. 2. Select [Optional Utilities]. 3. Select [Install Network Setup Utility]. 4. Select the appropriate language. 5. Select [OKI Device Standard Setup]. 6. Follow the on-screen i
Inhaltszusammenfassung zur Seite Nr. 11
Status Menu In the [Status] menu, the following items can be selected: Item Function Printer Status Current printer status is displayed. System Status Displays current OkiLAN 7120e configuration. Configuration data can be saved as log file. List of Configuration Displays current OkiLAN 7120e configuration. Items Configuration data can be saved as log file.,. Setup Menu In this menu, the following items can be selected: Item Function Oki Device Setup Configure the Configure the currently sele
Inhaltszusammenfassung zur Seite Nr. 12
>NetBEUI >SNMP >SMTP > Maintenance > Printer Port The following section explains each tabs functionality. Depending on your printer, some items in the following explanation may not be displayed. General Tab This allows you to set or change the root password used for Admin Manager and FTP. Location Comments Change root You can set/change the root password for password AdminManager and FTP. TCP/IP Tab This allows you to configure TCP/IP related items. Location Comments Use TCP/IP Set TCP/IP pr
Inhaltszusammenfassung zur Seite Nr. 13
Location Comments WINS Set IP addresses for WINS primary Server... and secondary servers; set scope ID Netware Tab This is where you can configure NetWare related items. Location Comments Use NetWare Protocol Set NetWare protocol as enabled/disabled. Print Server Name Set Print Server name. Frame Type Set primary NetWare frame type. Operation Mode Set NetWare mode. Check box besides Check if you want to use the Bindery mode and Bindery Setup Bindery Setup button becomes available. If it i
Inhaltszusammenfassung zur Seite Nr. 14
NetBEUI Tab This allows you to configure NetBEUI related items. Location Comments Use NetBEUI Set NetBEUI protocol to enabled/disabled. Protocol Short Printer Name Set a computer name for the print server. Workgroup Set a work group name to which the print server belongs. Comment Set the comments for the print server. SNMP Tab This allows you to configure SNMP related items. Location Comments Authentic This community name is used to check whether incoming Community SNMP requests have
Inhaltszusammenfassung zur Seite Nr. 15
Location Comments Printer Trap By selecting the button, the following dialogue box is Setup . . . displayed: In the dialogue box, the following items can be configured: Printer Trap This community name is assigned to Community Name outgoing printer status traps such as off-line, paper out, etc. TCP#15 Set the IP address to which a Trap packet will be sent. You can set up to five IP addresses. Detail . . . In the dialogue box, the following items can be configured: Trap Enable Set sendin
Inhaltszusammenfassung zur Seite Nr. 16
Location Comments Printer Trap Detail . . . Insert JAM Set sending a Trap, Setup . . . enabled or disabled, when an Insert JAM occurs. Park JAM Set sending a Trap, enabled or disabled, when a Park JAM occurs. Paper Lever ALARM Set sending a Trap, enabled or disabled, when a Paper Lever Alarm occurs. Cover Open Set sending a Trap, enabled or disabled, when the printer cover opens. Feed JAM Set sending a Trap, enabled or disabled, when an Feed JAM occurs. Ribbon JAM Set sending a T
Inhaltszusammenfassung zur Seite Nr. 17
Location Comments Printer Trap Detail . . . Paper Out Set sending a Trap, Setup . . . enabled or disabled, when paper is out. Printer Error Set sending a Trap, enabled or disabled, when the printer error occurs. Exit JAM Set sending a Trap, enabled or disabled, when an Exit JAM occurs. Insert JAM Set sending a Trap, enabled or disabled, when an Insert JAM occurs. Park JAM Set sending a Trap, enabled or disabled, when a Park JAM occurs. Paper Lever ALARM Set sending a Trap, enable
Inhaltszusammenfassung zur Seite Nr. 18
E-mail (Send) Tab In E-mail (Send) tab, you can configure SNMP related items. Location Comments Use SMTP Set sending E-Mail via SMTP, enabled or disabled. Transmit Protocol SMTP Server Set IP address or host name of SMTP server. Address/Name Reply-To Address Set the E-Mail address that is used in the [Reply-To] field in the mail header. E-Mail Address Set the E-Mail address that is used in the [From] field in the mail header. 15 By selecting each button, the following dialogue box is
Inhaltszusammenfassung zur Seite Nr. 19
Location Comments Advanced . . . By selecting the button, the following dialogue box is displayed: In the dialogue box, the following items can be configured: SMTP Port Set port number of SMTP. Number Signature Set up to four signature lines. Signatures added to the bottom of an E-Mail. OkiLAN 7120e Network Users Guide 19
Inhaltszusammenfassung zur Seite Nr. 20
Maintenance Tab Location Comments Service Use TCPIP Set TCPIP Protocol, enabled or disabled. Protocol Use NetBEUI Set NetBEUI Protocol, enabled or disabled. Protocol Use FTP Set FTP service, enabled or disabled. Service Use TELNET Set TELNET service, enabled or disabled. (Not Service supported.) Use Web Set Web service, enabled or disabled. Service Use SNMP Set Web service, enabled or disabled. Service Use STMP Set Web service, enabled or disabled. Service IP Filter Use IP Filter Set IP filteri
