Bedienungsanleitung Epson Stylus CX7300

Inhaltszusammenfassung zur Seite Nr. 1

Instruction for EPSON CX7300

You are welcomed to use continue Ink Supply System which will greatly reduce your cost. And
it is the ideal products suiting for Color Inkjet Printer. Pls Please look over the instruction
carefully before using it, which will make you use this system easily, safely and stably.


1. General Guide
1、Components
a、CIS System 1set b、Air Filters 6pcs c、Support Arm 1set
d、Standby Refill Kit 6pcs e、Instruction CD 1pc

2、Op

Inhaltszusammenfassung zur Seite Nr. 2

Press the ink-changing button Carriage move out Pull out the power line of the printer and move the carriage to the right side. Step 3: Remove the cartridge cover Open the cartridge cover Take out the original cartridges prize the cover lightly along with the gap with screwdriver Take one side first. Then take out the whole cover Carriage

Inhaltszusammenfassung zur Seite Nr. 3

① reset button. ② switch. Push it upside until it is locked by the third clip in the red circle. If the switch is turned to up place,then CISS should work with original cartridge. If the switch is turned to down palce, then CISS Can work without original cartridge. Step 5: Install CIS Catridges Move the carriage to the left side Make the cartridge round the printer cover as above show Move the carriage back to the original position Put in the specia

Inhaltszusammenfassung zur Seite Nr. 4

Tube went through the flute Clip the tube on the tubing holder by claspers. Step 7: Adjust Tube Line Adjust the tube length and move the Stimulate the move of the cartridge car. Adjustment is finished. cartridge car. Insure there's plenty length Insure there will no block when the of tube to make the cartridge cart can tubes moving with cartridge car and thoroughly move to the left side.

Inhaltszusammenfassung zur Seite Nr. 5

Inhaltszusammenfassung zur Seite Nr. 6

Press the reset button Press the ink-changing button again Press the ink-changing button again, then you will find the cartridges are full of ink. And you can print again. Another reset method is: turn down the printer for one minute and then turn it on. 5. Refill Ink Please pay attention to the ink level in the reservoirs; if the ink level is below 1CM as the picture shown above

Inhaltszusammenfassung zur Seite Nr. 7

2. Avoid exposure to direct sunshine and don’t keep it in high or freezing temperature. 3. Avoid collision and fallen down.