Inhaltszusammenfassung zur Seite Nr. 1
OWNER’S MANUAL
©
SYSTEMS
A Creative Light & Sound Company
1532 Enterprise Parkway • Twinsburg, Ohio 44087
330-425-3388 • 800-321-6699 • Fax: 330-425-9700
http://www.etasys.com E-mail eta@etasys.com
Inhaltszusammenfassung zur Seite Nr. 2
ETA’s line of Conditioned Power Distribution units are designed to reduce damage to sensitive electronic equipment from sudden voltage spikes, damaging power surges, and EMI/RFI noise, which is inherent in utility power lines. The PD11SP is a sequential four step/stage power up/down conditioned power distribution unit. It is designed to protect electronic equipment that requires a time-delayed start-up, particularly when high in-rush current can poten- tially damage audio, video, or computer equ
Inhaltszusammenfassung zur Seite Nr. 3
The PD11SS is a sequential four step/stage power up/down conditioned power distribution unit. It is designed to protect electronic equipment that requires a time-delayed start-up, particularly when high in-rush current can potentially damage audio, video, or computer equipment at power up. 1 thru 4 steps/stages in sequential power up/ 15 amp breaker down 1, 5, 10, 30 second pre-sets Breaker protected and unswitched 15 amp outlet Power switch Protection "On" Sequential On / Off Indicator On / O
Inhaltszusammenfassung zur Seite Nr. 4
Pull out lights Digital Voltmeter Protection "On" Power switch ON/OFF Breaker protected Readout Indicator On / Off HI/LOW and unswitched switch 15 amp outlet 20 amp Breaker 15 amp Breaker Pull out lights Front View PD11LVP Model Shown Back View PD11P, 11VP, 11LP, 11LVP Protected "Always On” 20 amp Outlets Back View PD11LVSP 3 pin terminal block for re sequential operation of un Protected "Always On” 20 amp Outlets Stage 1 Stage 2 Stage 3 Stage 4 Easy 4-step bulb replacement.
Inhaltszusammenfassung zur Seite Nr. 5
PD11P, PD11VP, PD11LP, PD11LVP Features: • Light Switch (PD11LP/LVP/LVSP) activates rack illumination; choice of HI or LOW intensity • Light Tubes (PD11LP/LVP/LVSP) illuminates up to 25 rack spaces • 4 dual 20 amp U-grounded switched outlets per unit • 1 dual 15 amp U-grounded "always on" and protected outlet • Digital Voltmeter Readout (PD11VP/LVP/LVSP) displays incoming line voltage • Resettable 20 amp thermal circuit breaker; 15 amp for front panel outlet • Lighted Outlet Power Switch activat
Inhaltszusammenfassung zur Seite Nr. 6
Audio Conditioned Power Distribution is also designed to Installation Requirements protect electronic equipment from potentially damaging high- PD11P, PD11VP, PD11LP, PD11SP, PD11LVP, PD11LVSP voltage spikes and surges. Plug unit into power source and observe status of four Sequencing Audio Conditioned Power Distribution is de- "Protection" light emitting diodes. The (green) “1st Stage”, signed to initiate a turn-on cycle, energizing one circuit “2nd Stage”, and “GROUND OK” L.E.D.’s should norma
Inhaltszusammenfassung zur Seite Nr. 7
Three-Wire Remote Control Interface A three-wire remote control interface is added to the main PC board for the PD11SS, PD11SP AND PD11LVSP units. This remote control interface is accessible through an external terminal block on the back of the unit (see Figure 6). This interface requires an external user provided switch, L.E.D., and a three-wire cable to implement. The interface has been tested reliably over 1000 feet with 22-gauge speaker wire (see Figures 1 and 5). Connect the short minus (-)
Inhaltszusammenfassung zur Seite Nr. 8
ETA Conditioned Power Distribution... The Benchmark By Which Professionals Compare. For over 20 years ETA has developed, manufactured Power Conditioning Firsts and sold high amperage theatrical lighting systems from from ETA which evolved an extensive line of rack mounted condi- tioned power distribution products designed to protect • “Always-On” Protected Outlets today’s sensitive electronic digital equipment. • 10 Rear Panel Outlets • Front Panel Convenience Outlets The “PD” Conditioned Power
