Inhaltszusammenfassung zur Seite Nr. 1
uh036sx-4
Quad Pack
Operating
Guide
To bring outstanding wireless communication products
to people's lives throughout the world.
Inhaltszusammenfassung zur Seite Nr. 2
CONTROL & INDICATORS INCLUDED IN YOUR uh036sx-4 QUAD PACK ! uh036sx x 4 ! Belt Clip x 4 ! Operating Guide RX TX 1 Antenna 9 Volume down/mon (monitor) Key 2 PTT (Push-To-Talk) Button 10 Microphone 3 Channel/scan up Key 11 Battery Compartment Door 4 Channel/scan down Key 12 Channel Indicator 5 Duplex Key 13 Receive Indicator 6 Speaker 14 Battery Low Indicator 7 Power On/Off Key 15 Transmit Indicator 8 Volume up/mon (monitor) Key 1
Inhaltszusammenfassung zur Seite Nr. 3
GETTING STARTED BATTERY WARNING To retain the previous user settings, the UH036SX will continue to use a small amount of battery power when switched off. To prevent the batteries from running down, remove them from the radio if the UH036SX will not be used for long periods. BATTERY INSTALLATION Your UH036SX radio uses 3 AAA ALKALINE batteries for power. Use only good quality alkaline batteries for maximum life and range. Note: Batteries are not supplied. To avoid damage to the unit do not mix o
Inhaltszusammenfassung zur Seite Nr. 4
WATER WARNING Uniden does not represent this product to be waterproof. Do not expose this product to Rain or Moisture. BELT CLIP To attach the belt clip: Pinch Belt Clip and Latch Slide the belt clip until it snaps into place. To remove the belt clip: Press and hold belt clip locker, slide the belt clip at the same time until released. LOW BATTERY ALERT If the Battery level becomes low, the battery indicator icon will appear on the LCD and begin flashing. The unit will go into a Battery Lo
Inhaltszusammenfassung zur Seite Nr. 5
OPERATION POWER ON/OFF Press and hold to turn the Radio ON. The channel number will appear on the display. Press and hold to turn the Radio OFF. VOLUME Press volume or to increase or decrease the volume level. The Channel indicator will flash when the volume is being adjusted. ADJUSTING THE KEY BEEPS Your radio emits a beep each time one of the keys (except for the PTT button and the Key) are pressed. dup To turn OFF this beep: Press and hold the Key wh
Inhaltszusammenfassung zur Seite Nr. 6
SELECTING CHANNEL Press channel or to select the desired channel. TO TRANSMIT AND RECEIVE The UH036SX uses the 40 UHF-CB Channels. For your reference a list of the available channels and corresponding frequencies is printed on page 10. 1. The transmit power of the UH036SX is 500mW which will PTT provide a range of up to 3+ Km. Switch 2. Before you transmit, listen for activity on the selected channel. PTT 3. When the channel is clear, press and hold the
Inhaltszusammenfassung zur Seite Nr. 7
For maximum range and extended the life of the batteries, avoid touching the antenna with your hand when transmitting. RANGE 6
Inhaltszusammenfassung zur Seite Nr. 8
AUTOMATIC SQUELCH FEATURE The UH036SX is equipped with an Automatic Squelch system which shuts off weak transmissions and unwanted noise. MONITOR This feature enables users to listen in for weak signals on the current channel at the press of a button. RX To use monitor, ! Press and hold Volume or for 2 seconds. The RX icon will begin to flash. ! For continuous listening, the receiver circuit will stay open, letting in both the noise & weak signals. ! To return to normal rec
Inhaltszusammenfassung zur Seite Nr. 9
Operation with the aid of a Repeater Eg. CH1 is being used in your area for repeater use. dup Press momentarily. The icon appears. dup Press again to deactivate the duplex operation. UH036SX will return to normal operation. POWER SAVE Your UH036SX has a unique circuit designed to dramatically extend the life of the batteries. If there is no transmission nor an incoming call within 2 seconds, your Radio switches to the Power Save mode. The Radio is still able to receive t
Inhaltszusammenfassung zur Seite Nr. 10
To initiate scanning, 1. Assuming the unit is on CH1 when switched on. 2. Press and hold Channel or for 3 seconds and scanning starts. 3. Press Channel or ; PTT or to cancel scanning. If Channel or is pressed while the unit is paused on a channel, scanning will be resumed. DROP-OUT DELAY While scanning, the UH036SX stops at a busy channel and receives a transmission. When the received signal is over, the unit will wait for 2 seconds
Inhaltszusammenfassung zur Seite Nr. 11
UHF CHANNELS & FREQUENCIES Please follow these guidelines for channel use in Australia: • Channels 05 and 35 are Emergency Channels. • Channel 11 is a Calling Channel. • Channels 22 and 23 are for telemetry and telecommand applications and TX should be avoided on these channels. General communication is accepted on all other channels with these guidelines: • Channel 40 - road channel (Australia). • Channels 01-08 (and 31-38) are repeater channels. Simplex Mode Duplex Mode Simplex Mode CH
Inhaltszusammenfassung zur Seite Nr. 12
WARRANTY UNIDEN UH036SX-4 UHF CB TRANSCEIVER RADIO Limited One Year Warranty Note: Please keep your sales docket as it provides evidence of warranty. Warrantor: Uniden Australia Pty Limited ABN 58 001 865 498 Uniden New Zealand Limited Warranty only available in original country of purchase Elements of Warranty: Uniden warrants to the original retail owner for the duration of this warranty, its uh036sx-4 UHF CB Transceiver Radios (hereinafter referred to as the Product) to be free from defects
