Inhaltszusammenfassung zur Seite Nr. 1
General Mobile Radio Service (GMRS)
Model : GMRS9010-2CH
Owner’s Manual
HI LO BUSY
S/VOX
MODE
WB
MIC
Customer Service
1-800-290-6650
128-7033A
1 of 28
Released: 1-30-04
Revision A: 5-14-04 Changed the power on/off/keylock and power output
functions.
Inhaltszusammenfassung zur Seite Nr. 2
THIS PAGE LEFT BLANK INTENTIONALLY 2 128-7033A 2 of 28
Inhaltszusammenfassung zur Seite Nr. 3
CAUTION SAFETY INFORMATION Your wireless hand-held portable transceiver contains a low power transmitter. When the PTT button is pushed (or the VOX mode is enabled) it sends out radio frequency (RF) signals. The device is authorized to operate at a duty factor not to exceed 50%. In August 1996, the Federal Communications Commissions (FCC) adopted RF exposure guidelines with safety levels for hand-held wireless devices. Important: To maintain compliance with the FCC’ s RF exposure guidelines hol
Inhaltszusammenfassung zur Seite Nr. 4
WARNINGS: Battery Care Never attempt to charge alkaline or dry cell batteries, as batteries may burst causing personal injury and damage to the product. If rechargeable batteries are used, such as Nickel Metal Hydride (NiMH), use only the supplied Audiovox-approved rechargeable batteries. Use of the Audiovox charger (also supplied) with other brands of batteries is not recommended, as battery charging times will vary with different brands. Refer to the Manufacturer’s instructions for charging
Inhaltszusammenfassung zur Seite Nr. 5
Model GMRS9010-2CH (FCC License Required) 5 6 8 4 15 3 (REF) 16 3 PTT 14 11 M S/VOX 10 1 MODE WB MIC (REF) 2 9 13 12 1 7 17 1. Battery Door 9. Built-in Microphone 2. Monitor/Backlight Button 10. Up Channel/Volume Button 3. Detachable Carry Clip 11. Down Channel/Volume Button 4. Push-To-Talk (PTT) Button 12. MODE/Weather Button 5. Antenna 13. Power On/Off Keylock 6. External Speaker(SPK)/Micro- Button phone (MIC)/Charge (CHG) Jack 14. SCAN/VOX Button 7. Built-in Speaker 15. White Flashlight LED
Inhaltszusammenfassung zur Seite Nr. 6
Model GMRS9010-2CH DISPLAY 1 8 9 2 10 HI LO BUSY 3 11 4 12 5 13 6 14 7 1. Beep Tone Indicator: Icon appears when beep button confirmation tone is selected; icon disappears when tone is off. 2. Key Lock Indicator: Icon appears when the keypad is locked. This function disables keys such as channel up/down, SCAN and MODE. 3. Monitor Indicator: Icon appears when the Monitor (M) button is pressed and the channel monitor function is activated. 4. Signal Strength Indicator: Icon appears when a sig
Inhaltszusammenfassung zur Seite Nr. 7
12.Small Segment Display: Displays the CTCSS tone option for each main channel from 01-38. 13.Dual Watch Mode Indicator: Indicator appears when dual watch mode is active. 14.Voice Activated Transmission (VOX) Indicator: This function allows hands free conversation. The indicator appears when the VOX mode is activated. Equipment and Accessories Supplied 1. Radio (2) GMRS9010-2CH 2. Owner’s Manual 128-7033 3. Desktop Charger GMRS9DS 4. AC Wall Adapter GMRS9AC 5. Rechargeable (NiMH) Batteries GMR
Inhaltszusammenfassung zur Seite Nr. 8
2.Audiovox Rechargeable Ni-MH Batteries - (Rechargeable NiMH batteries and Charging Adapter included). Use only Audiovox approved rechargeable batteries and charging equipment when charging batteries internal to the unit. NOTE: To extend battery life, avoid overcharging the batteries 3. Various Brands of Rechargeable Batteries - Use of the Audiovox charger with other brands of rechargeable batteries is not recommended, as battery charging times will vary with different brands of batteries. Re
Inhaltszusammenfassung zur Seite Nr. 9
PWR The following guidelines will improve performance and provide longer operating times for the GMRS9010-2CH: 1. Do not mix old and new batteries. 2. The use of alkaline-type batteries is recommended to provide the longest operating time. 3. Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries. 4. If the unit is not to be used for an extended period of time, remove the batteries. Old or leaking batteries can cause damage to the unit and will void the warranty. CHARGING STAND PW
Inhaltszusammenfassung zur Seite Nr. 10
GMRS9010-2CH OPERATIONAL MODES GMRS/FRS BAND WEATHER BAND CHANNEL CHANNEL SELECT SELECT CTCSS SELECT WEATHER BAND POWER (GMRS Channels SELECT SELECT Only) NOTE: 1. To switch between GMRS/FRS VOX LEVEL and Weather Band modes, SELECT press and hold the Mode but- DUAL ton for 3 seconds. Refer to the WATCH appropriate section of this BUTTON manual for detailed operating BEEP instructions for each mode. ROGER 2. To enter the VOX mode, press BEEP and hold the SCAN button for 3 CALL seconds. SELECT Con
Inhaltszusammenfassung zur Seite Nr. 11
volume. The display will indicate the current volume level between 1 and 7 5 by the small number in the icon ( UL ). Monitor/Display Backlight Button (2) This button is used to check activity on the current frequency before transmitting. Check activity by pressing the Monitor (M) Button longer than 2 seconds; the icon will apppear on the display and you will hear static if frequency is clear. Do not transmit if you hear conversation. Hold down the Monitor Button again longer than 2 seco
Inhaltszusammenfassung zur Seite Nr. 12
Down Channel/Volume Button (11) In the standby mode, pressing this button will decrease the listening volume. When in function edit mode this button will be used to adjust the unit’s settings. Mode Button (12) This button is used to select the various feature settings in the GMRS/FRS or Weather band modes. Holding the MODE button longer than 2 seconds will toggle between the GMRS/FRS and Weather band modes. External Microphone (MIC)/Speaker (SPK)/(CHG) Jack (6) This jack accepts the supplied Au
Inhaltszusammenfassung zur Seite Nr. 13
- Release PTT Button (4) to receive. - Communication can only be accomplished when the channel and CTCSS tone frequency of at least two parties are the same. - The CTCSS small segment display will appear next to the main frequency channel on the display if the CTCSS tone frequency function is enabled. Channel Selection In order to communicate with other GMRS units, both transmitting and receiving party must be on the same frequency. The GMRS9010-2CH has 22 channels (frequencies) indicated by the
Inhaltszusammenfassung zur Seite Nr. 14
party on the same main channel using the same subcode. (This filters out unwanted transmissions without the same coded squelch tone). There are 38 CTCSS Sub-channels for each main channel. A different subcode may be selected for each of the 22 channels. To change the CTCSS Sub-channel: - From GMRS/FRS standby mode, press the MODE Button twice; a flashing oF or sub-channel number is displayed. If oF is displayed, press the Up or Down button to enable the CTCSS mode. - Then press the Up or Down b
Inhaltszusammenfassung zur Seite Nr. 15
VOX Sensitivity Level Selection This selection enables you to set the sensitivity level to compensate for ambient noise in your immediate area. A VOX sensitivity of 3 is the most sensitive, and should be used in a relatively quiet surrounding. A VOX sensitivity of 1 is the least sensitive and should be used in a noisy sur- rounding. To set the VOX sensitivity level: - Press the MODE button 4 times (3 times for FRS) until the VO icon appears on the display accompanied by the flashing VOX icon and
Inhaltszusammenfassung zur Seite Nr. 16
- Press the PTT button momentarily to confirm selection of the dual watch channel. The display will now alternate between the primary channel and the dual watch channel just selected. NOTE: Pressing the PTT button during dual watch mode will trans- mit on the primary channel and suspend dual watch opera- tion for 20 seconds. Dual watch mode will then resume. - Momentarily press the SCAN button to exit the dual watch mode. Key Tone This feature allows the transceiver to sound a confirmation tone
Inhaltszusammenfassung zur Seite Nr. 17
Call Ringer Selection Mode The transceiver provides 3 user-selectable call ringer melodies to alert you to an incoming call. To select your favorite call ringer melody: - From GMRS/FRS standby mode, press the MODE Button 8 times (7 times for FRS). CA will appear on the display, together with a flashing number between 01 and 03, and an appropriate call ring. - Press the Up or Down Button to preview and hear the 3 available call melodies. - Press the PTT button momentarily to confirm selection. C
Inhaltszusammenfassung zur Seite Nr. 18
Auto Key Lock Selection Mode This feature prevents accidental channel change to the preferred settings of the unit. The Auto Key Lock function temporarily disables the MODE, Up/ Down and SCAN Buttons. To access the Auto Key Lock selection menu: - From GMRS/FRS standby mode, press and hold the Power Button for more than 1 second to enable the Auto Key lock function; the unit will beep once and the lock ( ) icon appears on the display. - The Power, PTT, and Monitor Buttons are not effected. -
Inhaltszusammenfassung zur Seite Nr. 19
To change the channel: - Press the Up Button (10) briefly to move to the next higher main channel number. - Press the Down Button (11) briefly to move to the next lower main channel number. NOTE: When the weather band operation mode is entered the transceiver will bypass the squelch setting and open the channel. Weather Alert Mode The weather alert mode notifies the user of unusual weather situations when the radio is operating in the GMRS/FRS mode. To access the weather alert function: -
Inhaltszusammenfassung zur Seite Nr. 20
NOTES FOR GOOD COMMUNICATION 1 . The GMRS9010-2CH 22 channels are shared on a ‘take turns’ basis. This means other groups may be talking on any of the channels. A common code of ethics/courtesy is to switch to another vacant channel and not to attempt to talk over someone who is already using the channel you first selected. 2. The GMRS9010-2CH has been designed to maximize performance and improve transmission range in the field. To avoid interference, it is recommended that you do not use the u
