Inhaltszusammenfassung zur Seite Nr. 1
®
ELECTRONICS CORP .
VOD916 Drop Down Video TV/Monitor with DVD
PROV916/PROV916 S/PROV916 P
Drop Down Video TV/Monitor with DVD
AUTO FM
ON OFF AUTO
PROG CHANNEL SOURCE VOLUME SELECT
AP S
Installation Guide
Inhaltszusammenfassung zur Seite Nr. 2
Important Notice It is unlawful in most jurisdictions for a person to drive a motor vehicle which is equipped with a television viewer or screen that is located in the motor vehicle at any point forward of the back of the driver's seat, or that is visible directly or indirectly to the operator of the motor vehicle.
Inhaltszusammenfassung zur Seite Nr. 3
HA EDPHONE S MATERIALS INCLUDED IN THIS PACKAGE: 1) VOD916/PROV916/PROV916 S/PROV916 P TV/Video Monitor with DVD (1pc) 2) 12 Pin Power / Signal harness (P/N 112B2821) (1 pc) 3) 3 Pin Power Wire Harness with choke (P/ N 112B3274) (1 pc) 4) Hardware Package #4 x 3/8” Screws (9 pcs) #8 x 5/8” Self Drilling Screws (4 pcs) #8 Washers (4 pcs) 5) Remote Control (136B3447) (1pc) 6) 14 Pin FMM Cable (P/N 112B3273) (1pc) 7) FM Modulator (P/N 136C3426) (1pc) 1 2 3 CHOKE AUTO FM PROG CHANNEL SO
Inhaltszusammenfassung zur Seite Nr. 4
GENERAL INSTALLATION APPROACH: 1) Decide upon system configuration and options that will be installed (i.e.: what components, VCP, Video Game, external amp, wireless headphones, VCP, etc.). 2) Review all manuals to become familiar with electrical requirements and hook ups. 3) Decide upon mounting locations of all components and method of mounting. 4) Prep the vehicle by removing any interior trim necessary to gain access to vehicle's wiring as well as all areas where interconnecting wire harness
Inhaltszusammenfassung zur Seite Nr. 5
VEHICLE PREPARATION: 1) Locate a constant power source (+12v at all times), an accessory power source (+12v when key is in the ACC. and run positions, and 0v when key is off), and also a good ground generally, these wires can be found at the ignition switch or fuse-box. 2) The mounting method and location will vary from vehicle to vehicle, so this manual will only focus on the installation of the video monitor and related console accessories. 3) Generally, the best location for the video monitor
Inhaltszusammenfassung zur Seite Nr. 6
MINI CONSOLE INSTALLATION: This page only covers special installation considerations for the mini-console installation. If the video monitor is to be installed in a vehicle with the mini console, this console may need to be trimmed to fit the contour of the vehicle headliner. 1) In this installation, the video monitor is mounted directly to the overhead cross-member in the roof using the mounting screw bosses. These screw bosses should contact the cross-member di- rectly (i.e.: no gap between
Inhaltszusammenfassung zur Seite Nr. 7
MOUNTING THE MINI-CONSOLE Roof Roof Support Headliner 12”x9”x3/4” Plywood Block (4) Self-Tapping Screws (not supplied) Mini-Console Video Unit (5) #8 Flat Washers (5) #8x3/4” Self-Tapping Screws -5-
Inhaltszusammenfassung zur Seite Nr. 8
VOD916/PROV916/PROV916 S/PROV916 P Hard Wired FM Modulator Output 12 VDC Power and Ground Satalite Radio TO Am/Fm FM FACTORY Antenna 14Pin FMM Cable RADIO Modulator Item #8 Dash Radio Second IR Input Battery 12V CHOKE Power Harness Item #3 To Secondary AV Monitor RCA-Female INPUT 12 VDC Power and Ground VIDEO TO TV OPTIONAL LINE Line Out-L (White) ANTENNA ADDITIONAL Auxillary OUT MONITOR Patch Cord VIDEO video display RCA Male to Male Line Out-R (Red) (Yellow) Line Out-V (Yellow) O
Inhaltszusammenfassung zur Seite Nr. 9
VOD916/PROV916/PROV916 S/PROV916 P INSTALLATION INSTRUCTIONS WHEN USING SATELLITE RADIO The VOD916/PROV916/PROV916 S/PROV916 P pods have dual IR transmitters. Channel A handles normal audio program material from A/V sources (DVD/AUX/TV, etc). The second B chan- nel allows an external audio source such as Satellite Radio or a CD changer to be used through RCA input jacks. There are a variety of ways to wire this package as outlined below. Using an Audiovox SIRIUS satellite receiver 1) The modul
Inhaltszusammenfassung zur Seite Nr. 10
CONNECTING THE DOME LIGHTS The dome lights in the video monitor require three connections to the vehicle's wiring. There are two common types of dome light circuits used, positive or negative switched. Positive systems supply voltage to the interior lights to turn them on, negative switched systems apply ground to illuminate the bulbs. To determine which system you have you must locate the wires at the dome light. On a positive switched system, with all the doors closed and the lights out, b
Inhaltszusammenfassung zur Seite Nr. 11
Negative Switched Dome lighting Red / black - Lamp on To 12 pin Black / red - Lamp common connector Purple / brown - Lamp Auto To constant Factory Dome light circuit To constant Factory Door ajar switch or Body Troubleshooting: SYMPTOM: REMEDY: No power at Video Monitor -Verify +12 VDC on Red wire at 2 pin Power Harness behind video monitor. Verify ground connection with continuity test from known good ground to black wire at 2 pin Power Harness Power but no video or -Verify that the correct so
Inhaltszusammenfassung zur Seite Nr. 12
For Customer Service Visit Our Website At WWW.audiovox.com Product Information, Photos, FAQ’s Owner’s Manuals 128-6744 © Copyright 2003 Audiovox Electronics Corp. 150 Marcus Blvd. Hauppauge, NY 11788
